Hot Shot
Floor Strippers
Heavy Duty No For Use On:
Rinse Speed 顎?
Vinyl Tile Terrazzo
Rubber Tile*
Vinyl Asbestos Ceramic Tile
Concrete
Asphalt Tile* Flagstone
Stripper
Linoleum
DESCRIPTION
The most effective floor finish emulsifier ever developed. Will
solubilize aged and built-up finishes almost instantly. May be
used as a no-scrub stripper or with a conventional floor machine
and pad depending on the concentration of the product and the
condition of the floor.
DIRECTIONS
1. Sweep or dust mop the floor to remove any debris.
2. Dilute Low Odor Floor Finish Remover from 1:2 to 1:11 (43oz. to
11oz./gal) with cold or warm water, depending on age and build-up
of finish. Do not use hot water.
3. Apply liberally with a mop to an area small enough so as not
to allow the product to dry. Be sure to completely cover floor to
baseboards.
4. After 3 to 5 minutes, agitate the wet section with a mop or ma-
chine scrub. Pick up solution using a mop, wet vac or automatic
scrubber.
5. Rinse thoroughly with clear water to remove residue as neces-
sary.
NOTE: Asphalt tile and rubber flooring could be affected by strip-
ping solutions in high concentrations with hot water. Always test
floor before proceeding.
PRODUCT SPECIFICATIONS
50.0 卤 0.5%
Active Ingredients: Emulsification: Excellent
Color: Detergency:
Clear Excellent
Odor: Rinsability:
Sassafras Excellent
145oF (TCC)
pH: Flash Point:
13.0 - 13.5
Viscosity: Biodegradability:
Water thin Complete
Foam: Storage/Stability:
Low 2 years
Abrasives: Weight per Gallon:
None 8.27 lbs./gal.
Phosphate Content: Freeze / Thaw Stability:
None Keep from freezing
Solubility: Complete with water
Misco Products Corporation 鈥? Reading, PA 鈥? (800) 548-4568 FAX (610) 926-1194
www.miscoprod.com
HOT MATERIAL SAFETY DATA SHEET N/A=Not Applicable
Prepared by: Regulatory Affairs Dept. Effective Date: 5/99 Revision: n/a
(Prepared According to 29 CFR 1910.1200)
SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION
Product Name: Hot Shot
Manufacturer's Name:
Misco Products Corporation Generic Name: Heavy Duty No Rinse Speed
Manufacturer's Address: Stripper
1048 Stinson Drive Reading, PA 19605 Chemical Family: Solvent Detergent Blend
Manufacturer's Phone #: (610) 926-4106 Formula: Proprietary
SECTION 2-INGREDIENT INFORMATION
CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV
Water 7732-18-5 to 100
2-Butoxyethanol 111-76-2 40 to 50 25 ppm 25 ppm N/A
8mg/M3
Ethanolamine 141-43-5 0 to 5 N/A N/A
C2mg/M3
Potassium Hydroxide 1310-58-3 0 to 5 N/A N/A
Nonionic Surfactant 9016-45-9 0 to 5
Potassium Fluoroalkyl Carboxylate (C8) 2991-51-7 0 to 5
Perfume Oils N/A <1
SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): 145 F. (TCC)
Boiling Point (掳F): 210 F. Specific Gravity: .994
Upper Explosion Limit: 10.6 Lower Explosion Limit: 1.1
Vapor Pressure: 20mm Hg @ 68 F. Vapor Density (Air=1): >1
Extinguishing Media: Alcohol foam, water fog, CO2 or dry chemical.
% Volatile: 96+ pH: 13.0-13.5
Special Firefighting Procedures: Wear self-contained breathing apparatus
Solubility in Water: Complete Evaporation Rate (Water=1): <1
for confined areas. Keep fire exposed containers cool with water spray.
Physical Description: Thin liquid with characteristic odor.
Unusual Fire and Explosion Hazards: Vapors heavier than air.
SECTION 5-REACTIVITY DATA
Stability: Stable Hazardous Polymerization: None
Hazards Decomposition Products: Alkaline vapors in a fire. Incompatibility (Materials to Avoid): Strong acids.
SECTION 6-STORAGE AND HANDLING INFORMATION
Combustible liquid- Avoid contact with heat, spark or open flame. Keep out of reach of children. For use by trained personnel only. Keep unauthorized personnel away
when applying to floor. Keep container closed during storage. For institutional and industrial use only. Avoid contact with eyes, skin and clothing. Wear protective
eyewear, gloves and footwear when handling. Avoid breathing of vapors. Use in well-ventilated area only.
SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION
Effects of Overexposure: Respiratory Protection: Use NIOSH approved organic vapor respirator or self-
Skin: Severe skin irritant. May cause moderate reddening, swelling, and possible contained breathing apparatus in confined or poorly ventilated areas.
skin damage. Ventilation Requirements: Provide mechanical exhaust to keep TLV of Section 2
Eyes: Severe eye irritant. Liquid and mists may damage eyes, causing corneal ingredients below acceptable limits.
damage. Protective Gloves: Chemical resistant rubber or neoprene.
Inhalation: Vapors and mists may be irritating to mucous membranes in the nose, Eye Protection: Chemical splash goggles or full-face shield.
throat, and lungs. Other Protective Equipment: Eye wash station nearby. Protective outerwear and
Ingestion: Irritating and corrosive to the mouth and throat. May cause headache, rubber boots should be worn when using.
nausea, abdominal pain, vomiting, and diarrhea. Excessive amounts may cause
collapse.
First Aid Procedures: SECTION 9-SPILL OR LEAK PROCEDURES
Steps to be taken in Case Material is Released or Spilled: Floors will become slippery.
Skin: Flush with water. Seek medical attention if irritation persists.
Avoid walking in product. Keep unessential personnel away. Mop up or otherwise absorb and
Eyes: Contact damage is immediate. Immediately flush with large quantities of
hold disposal. Avoid discharge to sewer or open waterways.
water, holding eyelids open. Seek medical attention immediately.
Waste Disposal Method: Any method in accordance with local, state and federal laws. Best
Inhalation: Get to fresh air. Seek medical attention if irritation persists. method is to recycle or reuse for intended purpose. If discarded, this material and containers
Ingestion: Do not induce vomiting. Drink large quantities of water. Seek medical should be treated as hazardous waste based on the characteristic of corrosivity and ignitability
attention immediately. as defined under federal RCRA regulations (40 CFR 261).Consult local authorities for disposal
in public sewer. Do not dispose of into storm drain, stream, river or to ground. Rinse
container thoroughly before discarding in trash.
SECTION 10-REGULATORY INFORMATION
HMIS Hazardous Materials
SARA Title III - Section 311/312 -Hazard Categories: Shipping Information:
No - Fire Hazard FOR CONTAINERS > 1 Gallon: Compounds, cleaning liquid, Identification System
No - Sudden Release of Pressure Hazard Health 3
(Potassium Hydroxide), 8, NA-1760, PG III
No - Reactivity Hazard FOR 1 GALLON CONTAINERS: Compounds, cleaning liquid, Flammability 2
Yes - Immediate (acute) Health Hazard (Potassium Hydroxide), 8, NA-1760, PG III (Limited Quantity) Reactivity 0
Yes - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : ORM-D Personal Protection D
FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act
of 1986 and of 40 CFR 372.
CAS# Chemical Name Percent by Weight
111-76-2 Glycol Ether 46%
This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.
CAS# Chemical Name Percent by Weight
None
SECTION 11-OTHER INFORMATION
This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the application of this
information, or the safety and suitability of our products either alone or in combination with other products. It is the responsibility of the user to provide a safe workplace, using the
health and safety information contained herein as a guide. This company will accept no liability for damages or loss incurred from the improper handling and use of this product
|