Search    ENTER KEYWORD
MSDS Material Safety Data Sheet
CAS

111-30-8

File Name: qmaxsolutions_com---t_352_biocide.asp
                                                 MATERIAL SAFETY DATA SHEET
#1700, 407 2ND STREET S.W., CALGARY, ALBERTA T2P 2Y3
TELEPHONE: (403) 269-2242 FAX: (403) 269-2251
1-613-996-6666 鈥? CANUTEC 鈥? Transportation Emergency
1-888-243-9771 鈥? ChExSS 鈥? Chemical Exposure



T 352 BIOCIDE
SECTION I: IDENTIFICATION OF PRODUCT
Product Use: Biocide
Product Name: T 352 BIOCIDE
TDG Classification: Not applicable
Chemical Family: Aqueous Mixture of Aldehydes
Packaging Group: Not applicable
WHMIS Classification: D-1B, D-2B, E
PIN: Not applicable
Workplace Hazard: Skin & Eye Irritant, Corrosive,
Toxic


SECTION II: HAZARDOUS INGREDIENTS
Ingredients Percent CAS Number LD50 (Rat/Oral) LC50 (Rat/Inhala)
Glutaraldehyde 15-40 111-30-8 134 mg/kg 480 mg/kg




SECTION III: TOXICOLOGICAL PROPERTIES
Route of entry: Skin Eye Contact Inhalation Ingestion

Effects of acute exposure: Inhalation can cause discomfort or pain in the chest and abdomen, nausea, vomiting, diarrhea,
dizziness, faintness, drowsiness, thirst, weakness, circulatory shock, collapse and coma. Aspiration into the lungs may occur
during ingestion or vomiting, resulting in lung injury.Ingestion may cause moderate to marked irritation and possibly chemical
burns of the mouth, throat, esophagus and stomach. Prolonged or widespread skin contact may result in the absorption of
potentially harmful amounts of material and/or dermatitis.Eye contact causes corneal scarring, clouding and glaucoma, cataracts,
blindness may occur

Effects of chronic exposure: Not applicable

Exposure limits: Glutaraldehyde, AGGIH TLV 0.05ppm (ceiling)

Irritancy of product: Severe skin and eye irritant.

Sensitization to product: Not applicable

Carcinogenicity: No ingredients classified as carcinogenic

Reproductive toxicity: None anticipated

Teratogenicity: None anticipated

Mutagenicity: None anticipated

Name of toxicological synergistic products: None known


1 OF 4
鈥渄edicated to exceeding customer expectations鈥?
T 352 BIOCIDE

SECTION IV: FIRST AID MEASURES
Skin contact: Wash affected area with water for at least 20 minutes. Remove and clean contaminated clothing. Seek medical
attention if irritation develops or persists

Eye contact: Flush with water immediately for at least 30 minutes by holding eye open while flushing. Seek immediate medical
attention. Do not transport victim until recommended flushing period is complete.

Inhalation: Remove victim from area to fresh air. Apply artificial respiration if breathing has stopped. If difficulty breathing,
administer oxygen. Seek immediate medical attention.

Ingestion: Never give anything by mouth to an unconscious person. Do not induce vomiting. Rinse mouth out and give 1 to 2
glasses of milk, water may be used as a substitute. Seek immediate medical attention.


SECTION V: PHYSICAL DATA
Physical state: Liquid.

Appearance and odour: Clear, colorless liquid. Sweet Odour.

Odour threshold: Not available

Specific gravity: 1.06 to 1.13

Vapor pressure (mmHG): Not available

Vapor density (Air=1): Not available

Evaporation rate: 1.0

Boiling point (潞C): 100

Freeze/Melting point (潞C): -35

pH: 3.1 to 4.5

Co-efficient of water/oil distribution: Not available




2 OF 4
鈥渄edicated to exceeding customer expectations鈥?
T 352 BIOCIDE

SECTION VI: FIRE AND EXPLOSION DATA
Conditions of flammability: Not considered flammable but may be flammable if the water was evaporated.

Means of extinguishing: CO2, dry chemical. Water may be used as a fog only.

Flash point: Does not flash.

Upper flammable limit: Not applicable

Lower flammable limit: Not applicable

Auto-ignition temperature: Not applicable

Hazardous combustion products: Oxides of carbon, irritating gas.

Explosion data-sensitivity to mechanical impact: Not expected

Explosion data-sensitivity to static discharge: Not expected


SECTION VII: REACTIVITY DATA
Chemically unstable (conditions): Stable.

Product incompatible with: Strong acids and alkalies, reducing agents, Lewis or mineral acids, amines, strong oxidizers.

Conditions of reactivity: Avoid high temperatures

Hazardous decomposition products: Oxides of carbon, irritating gas.




3 OF 4
鈥渄edicated to exceeding customer expectations鈥?
T 352 BIOCIDE

SECTION VIII: PREVENTATIVE MEASURES
Personal protective equipment: All equipment should be NIOSH approved. Chemical resistant protective clothing must be
worn at all times when handling product. Wash thoroughly or dispose of any contaminated clothing. Chemical goggles must be
worn at all times when handling product. If there is a possibility of splashing, wear protective face shield. If vapours irritate
eyes, wear full face respirator.

Specific engineering controls: Local exhaust ventilation is recommended for controlled products. The use of mechanical
ventilation is recommended whenever this product is used in a confined space or when air circulation is inadequate. If product is
flammable/combustible, all equipment should be explosion proof.

Procedures for leak/spills: Remove all sources of ignition. Contain spill. Absorb material on appropriate non-flammable
absorbent and shovel into compatible salvage containers. Avoid all bodily contact. Appropriate breathing apparatus must be
worn in ventilation is inadequate. Do not allow product to enter sewers or stormwater inlets.

Waste disposal: It is the responsibility of the user of this product to determine at the time of disposal whether this product meets
the criteria for hazardous waste. This is because product uses, processes, mixtures, etc., may render a non-hazardous material
hazardous, or a hazardous material non-hazardous. Empty container retains product residue. Containers must be rinsed before
disposal or reuse. Observe all hazard precautions. Keep away from heat, sparks and flames. Do not weld or use a cutting torch
on or near container. Do not distribute, make available, furnish or reuse empty container except for storage and shipment of
original product. Remove all hazardous product residue and puncture or otherwise destroy empty container before disposal.

Handling procedures and equipment: Avoid inhalation of vapours/mists. Do not get on skin, in eyes or on clothing. Keep
container closed when not in use. Wear suitable protection for eyes and skin when handling. Use with adequate ventilation.
Avoid contact with incompatible materials. Store in cool, dry, well ventilated area away from sources of heat, ignition, and
sparks. Use proper grounding techniques if product is classified as flammable or combustible. Eye wash and safety showers
should be easily accessible and in proper operating order.

Storage requirements: Store in cool, dry, well ventilated area away from sources of heat, ignition, and sparks. Use proper
grounding techniques if product is classified as flammable or combustible. Eye wash and safety showers should be easily
accessible and in proper operating order.

Special shipping information: Storage and Handling Precautions. Refer to Fire and Explosion Hazard for data on
flammability/combustibility of product. Do not ship with foodstuffs, feed or clothing.

SECTION IX: PREPARATION
Date updated: August, 2005 Prepared by: Product Safety Committee

All the recommendations and suggestions herein concerning this product are based upon tests and data believed to be reliable,
however it is the user鈥檚 responsibility to determine the safety, toxicity and sustainability for their own use of the product described
herein. Since the actual use by others is beyond our control, no guarantee, expressed or implied, is made by Q鈥橫ax Solutions Inc.
as to the effects of such use, the results to be obtained, or the safety and toxicity of the product nor does Q鈥橫ax Solutions Inc.
assume any liability arising out of use by others. Nor is the information herein to be considered as absolutely complete since
additional information may be necessary or desirable when particular or exceptional conditions or circumstances exist or because
of applicable laws or government regulations.




4 OF 4
鈥渄edicated to exceeding customer expectations鈥?

Search    ENTER KEYWORD
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP
NAMECAS
qmaxsolutions_com---synerspec_SYN_675.asp 25322-68-3 7732-18-5 75-21-8 123-91-1 75-07-0
qmaxsolutions_com---synersperse_35-50.asp 9003-04-7
qmaxsolutions_com---tdl_13.asp 64741-68-2 67-63-0 1330-20-7 61791-63-7 71-43-2
qmaxsolutions_com---tdl_33.asp 67-63-0
qmaxsolutions_com---tdl_34.asp 67-56-1 67-63-0 75-21-8
qmaxsolutions_com---thermasalB_Dec2007.asp N/A
qmaxsolutions_com---thin_tex.asp N/A
qmaxsolutions_com---tributyl_phosphate.asp N/A
qmaxsolutions_com---trupac_lv.asp N/A
qmaxsolutions_com---t_2001_Dec2007.asp 1330-20-7 68477-31-6 100-41-4 67-56-1 64742-94-5 91-20-3 7664-93-9 71-43-2
qmaxsolutions_com---t_2508_demulsifier.asp 67-56-1 007664-93-9
qmaxsolutions_com---t_352_biocide.asp 111-30-8
qmaxsolutions_com---ultra_low_2.asp N/A
qmaxsolutions_com---ultra_seal_coarse.asp N/A
qmaxsolutions_com---ultra_seal_plus.asp N/A
qmaxsolutions_com---ultra_seal_poly_plug.asp 39430-51-8
qmaxsolutions_com---ultra_seal_xp.asp N/A
qmaxsolutions_com---versamod.asp 64742-47-8
qmaxsolutions_com---walnut_cfm.asp N/A
qmaxsolutions_com---watesal.asp N/A
qmaxsolutions_com---xanthum_gum.asp 11138-66-2
qmaxsolutions_com---xanvis.asp 107-22-2
qmaxsolutions_com---xl_defoamer.asp 104-76-7
qmaxsolutions_com---zinc_carbonate.asp N/A
qmaxsolutions_com---zinc_chelate.asp N/A
qmifloorcare_com---powr7.asp 1310-73-2 3456-94-8 60-00-4
qmifloorcare_com---powrplus.asp 64-02-8 7758-29-4
qorpak_com---375315.asp 7732-18-5 34487-61-1
qorpak_com---375473.asp 538-62-5 115-39-9 64-17-5 67-63-0
quabieu_com---UV_Dry.asp N/A
qualityssl_com---ssl_guide_intro_1.00.asp N/A
qualityssl_com---ssl_validation_wp_1.00.asp N/A
quantumchemicals_com_au---EDTA_Tetrasodium_Salt_MSDS_16-08-2006.asp 13235-36-4 10378-23-1
quantumchemicals_com_au---EthylGlycol_MSDS_May2005.asp N/A
quantumchemicals_com_au---Potassium_Sorbate_MSDS_25-06-2007.asp N/A
quantumchemicals_com_au---Sodium_Hydrosulfide_MSDS_10-08-2005.asp N/A
quantumchemicals_com_au---Sorbic_Acid_MSDS_07-09-2006.asp N/A
quantumchemicals_co_nz---ATMP_MSDS_25-01-2003.asp N/A
quantumsilicones_com---QGel_300Y_Data_Sheet.asp N/A
quantumsilicones_com---QLE_1032_Data_Sheet.asp N/A
quantumsilicones_com---QM_237_Data_Sheet.asp N/A
quantumsilicones_com---QM_280_Data_Sheet.asp N/A
quantumsilicones_com---QSil_431_Data_Sheet.asp N/A
quantumsilicones_com---QSil_555_Data_Sheet.asp N/A
quantumsilicones_com---QSil_557_Data_Sheet.asp N/A
quantumsilicones_com---QSil_601_Data_Sheet.asp N/A
quantumsilicones_com---QSil_602_Data_Sheet.asp N/A
quikrete_com---MSDS-X2-PolyureSelf-Level.asp N/A
quikrete_com---MSDS-X3-PolyureConAd.asp N/A
quimobasicos_com_mx---msdsG23.asp 800-00-2 01-81-8 75-46-7

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com | Ads link:HBCCHEM.INC