SECTION II PHYSICAL DATA
BOILING POINT SPECIFIC GRAVITY (H20 = 1.0)
>500 deg. F (260 deg. C.) @760mmHg @ 49 F / 25 C 0.85 - 0.90
VAPOR PRESSURE PERCENT VOLATILE BY VOLUME
@72 Deg.F. Less than 1 mm Not Known
VAPOR DENSITY EVAPORATION RATE
Not known Not Known
SOLUBILITY IN WATER
@72 Deg.F. Negligible
APPEARANCE & ODOR
@72 Deg.F. Water white to yellowish solid; musty oily odor
SECTION III FLAMMABILITY & EXPLOSIVENESS DATA
FLASH POINT (METHOD) EXPLOSIVE LIMITS
> 300 Deg. F. (148.9 deg. C.) (PMCC) N/A N/A
UPPER LOWER
EXTINGUISHING MEDIA
Use CO2 or dry chemical for small fires.
SPECIAL FIRE FIGHTING PROCEDURES
Use foam for large fires.
UNUSUAL FIRE AND EXPLOSION HAZARDS
None
SECTION IV HEALTH & SAFETY DATA
THRESHOLD LIMIT VALUE
Not established
EFFECTS OF OVER EXPOSURE
Accidental exposure to the eyes will cause a mild but transient irritation.
Mild, primary skin irritation with prolonged or repeated contact.
EMERGENCY & FIRST AID PROCEDURES
If instilled in eyes, rinse thoroughly with water for at least 15 minutes.
Avoid prolonged contact with skin.
Wash skin with soap and water upon contact.
DATA SUPPLIED IS FOR USE ONLY IN CONNECTION WITH OCCUPATIONAL SAFETY AND HEALTH
TRC-101 FATTY ACID
SECTION V REACTIVITY DATA
STABILITY UNSTABLE CONDITIONS TO AVOID
HAZARDOUS POLYMERIZATION MAY OCCUR CONDITIONS TO AVOID
X
WILL NOT OCCUR
SECTION VI SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Neutralization not required. Soak up with absorbent material
such as paper, rags, or sawdust. Dispose as any grease or
oily material.
WASTE DISPOSAL METHOD
Dispose of according to Federal, State, and / or Local regulations.
SECTION VII PROTECTION INFORMATION
RESPIRATORY PROTECTION
None required
VENTILATION LOCAL EXHAUST SPECIAL
Acceptable
MECHANICAL (general) OTHER
EYE PROTECTION PROTECTIVE GLOVES
Safety glasses, Goggles or Face shield Rubber or plastic
OTHER PROTECTIVE EQUIPMENT
Have eye wash and safety shower nearby.
SECTION VIII PRECAUTIONS
HANDLING AND STORAGE
Should be stored in resin lined steel, aluminum, stainless
steel, or reinforced fiberglass vessels.
LABELING
None required
OTHER
Heated product may cause thermal burns if contacted.
The submission of this MSDS may be required by law but this is not an assertion that this substance
is hazardous when used in accordance with proper safety practices and normal handling procedures.
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP