Safety Data Sheet
Material Name: 8500 Series DuraGlass庐 Mats ID: 1121
Section 1 - Product and Company Identification
Hazard Label CAUTION label
Company Information
Johns Manville Engineered Products Group Telephone: 303-978-2000 8:00AM-5:00PM M-F
Mats and Reinforcements Division Internet Address: http://www.jm.com
P.O. Box 5108 Emergency: 800-424-9300 (Chemtrec, in English)
Denver, CO 80127 USA
Trade Names: 8500 Series DuraGlass庐 Mats
Use: May be used as substrate components in carpet tile systems, as facer mats or any application requiring undetectable amounts of
off gassing formaldehyde.
Section 2 - Hazards Identification
Emergency Overview
Inhalation of excessive amounts of dust from the product may cause temporary upper respiratory irritation and/or congestion--
remove individual to fresh air.
Summary
Breathing dust from this product may cause a scratchy throat, congestion, and slight coughing. Getting dust or fibers on the
skin, or in the eyes may cause itching, rash, or redness. Additional health and safety information is provided in Section 11 of
this safety data sheet.
Inhalation
Irritation of the upper respiratory tract (scratchy throat), coughing, and congestion may occur in extreme exposures.
Skin
Temporary irritation (itching) or redness may occur.
Ingestion
This product is not intended to be ingested (eaten). If ingested, it may cause temporary irritation to the gastrointestinal
(digestive) tract.
Eyes
Temporary irritation (itching) or redness may occur.
Primary Routes of Entry (Exposure)
Eyes, skin, inhalation (breathing dust and fibers) and ingestion.
Target Organs
Nose (nasal passages), throat, lungs, skin, eyes
Medical Conditions Aggravated by Exposure
Pre-existing chronic respiratory, skin, or eye diseases or conditions.
Section 3 - Composition/Information on Ingredients
CAS # Component Percent
Not Available Continuous filament glass fibers 71-91
Not Available Acrylic-Based Binder (cured) 14-24
Not Available Melamine formaldehyde binder (cured) <1*
Component Information
* Melamine formaldehyde binder (cured) contains residual formaldehyde. Exposure to free formaldehyde is not expected to
occur. Melamine-formaldehyde is expected to be completely and irreversibly bonded.
General Product Description
White glass fiber mat. No significant odor.
Section 4 - First Aid Measures
First Aid: Inhalation
Remove to fresh air. If symptoms persist contact a physician.
First Aid: Skin
Wash gently with soap and water to remove dust and fibers. Should irritation persist, seek medical attention.
First Aid: Ingestion
Product is not intended to be ingested or eaten. If this product is ingested, do not induce vomiting and seek medical attention
immediately.
First Aid: Eyes
Do not rub or scratch eyes. Dust particles may cause the eye to be scratched. Flush eyes with large amounts of water until
irritation subsides. If irritation persists, seek medical attention.
Page 1 of 5
Safety Data Sheet
Material Name: 8500 Series DuraGlass庐 Mats ID: 1121
First Aid: Ears
Wash exposed skin with soap and water. If irritation develops in the inner ear, seek medical attention.
First Aid: Notes to Physician
Dust from the product may cause mechanical irritation of the eyes, skin, and upper respiratory tract. Treat symptomatically.
Section 5 - Fire Fighting Measures
Flash Point: Not applicable Method Used: Not applicable
Upper Flammable Limit (UFL): Not applicable Lower Flammable Limit (LFL): Not applicable
Auto Ignition: Not determined Flammability Classification: Not determined
Rate of Burning: Not determined
General Fire Hazards
There is no potential for spontaneous fire or explosion. Inorganic glass fibers are naturally non-combustible and non-
flammable.
Extinguishing Media
Carbon dioxide (CO2), water, water fog, dry chemical.
Fire Fighting Equipment/Instructions
No special procedures are expected to be necessary for this product. Normal fire fighting procedures should be followed to
avoid inhalation of smoke and gases.
Section 6 - Accidental Release Measures
Clean-Up Procedures
Pick up large pieces. Vacuum dusts. If sweeping is necessary, use a dust suppressant such as water. Do not dry sweep dust
accumulation. These procedures will help to minimize potential exposures.
Section 7 - Handling and Storage
Handling Procedures
Use protective equipment as described in Section 8 of this safety data sheet when handling uncontained material. Handle in
accordance with good industrial hygiene and safety practices.
Storage Procedures
Warehouse storage should be in accordance with package directions, if any. Material should be kept clean, dry, and in original
packaging.
Section 8 - Exposure Controls / Personal Protection
The Occupational Safety and Health Administration (OSHA) has not adopted specific occupational exposure standards for
fiber glass. Fiber glass is treated as a nuisance dust and is regulated by OSHA as a particulate not otherwise regulated (total
dust) shown in CFR 1910.1000 Table Z-3.
Respirable fraction 5 mg/m3
Total dust 15 mg/m3
JM has adopted the fiber glass industry voluntary Product Stewardship Program (PSP), formerly the NAIMA-OSHA Health and
Safety Partnership Program (HSPP). Under the PSP, JM recommends that exposures be limited to the voluntary concentration
of 1 f/cc TWA for fibers longer than 5 microns with a diameter less than 3 microns. This will help minimize potential irritation
effects. The PSP also includes the PPE recommendations described below.
PERSONAL PROTECTIVE EQUIPMENT
Personal Protective Equipment: Eyes/Face
Safety glasses with side shields are recommended to keep dust out of the eyes.
Personal Protective Equipment: Ears
Use ear protection (earplugs, hood, or earmuffs) to prevent airborne dust or fibers from entering the ear, if necessary.
Personal Protective Equipment: Skin
Leather or cotton gloves should be worn to protect against mechanical abrasion. See also Personal Protective Equipment:
General, below.
Personal Protective Equipment: Respiratory
A respirator should be used if ventilation is unavailable, or is inadequate for keeping dust and fiber levels below the applicable
exposure limits referenced in Section 8 of this SDS. Wear a NIOSH-certified disposable or reusable particulate respirator with
an efficiency rating of N95 or higher (per 42 CFR 84) when dust or fiber concentrations exceed the applicable exposure limits.
Operations such as sawing, blowing, tear out, and spraying may generate airborne fiber concentrations requiring a higher level
of respiratory protection. For exposures up to 50 times the established exposure limits use a full-face respirator, rated N99 or
higher.
Page 2 of 5
Safety Data Sheet
Material Name: 8500 Series DuraGlass庐 Mats ID: 1121
Ventilation
In fixed manufacturing settings, local exhaust ventilation should be provided at areas of cutting, milling or other processing to
remove airborne dust and fibers.
Personal Protective Equipment: General
Protective equipment should be provided as necessary to prevent irritation of the throat, eyes, and skin, and to keep
exposures below the applicable exposure limits identified in Section 8.
Section 9 - Physical & Chemical Properties
Appearance: Odor:
White glass fiber mat No significant odor
Physical State: pH:
Solid Not applicable
Vapor Pressure: Vapor Density:
Not applicable Not applicable
Boiling Point: Melting Point:
Not determined Not determined
Solubility (H2O): Specific Gravity:
Not determined Not determined
Freezing Point: Evaporation Rate:
Not applicable Not applicable
VOC: Not determined
Section 10 - Stability & Reactivity Information
Stability
These products are not reactive.
Hazardous Decomposition
May form carbon dioxide and carbon monoxide.
Hazardous Polymerization
Will not occur.
Section 11 - Toxicological Information
Acute Toxicity
A: General Product Information
Dust from this product is a mechanical irritant, which means that it may cause temporary irritation or scratchiness of the throat,
and/or itching of the eyes and skin.
B: Component Analysis - LD50/LC50
No LD50/LC50's are available for this product's components.
Component Carcinogenicity
Continuous filament glass fibers
ACGIH: A4 - Not Classifiable as a Human Carcinogen
IARC: Group 3 - Not Classifiable (IARC Monograph 81 [2002] (listed under Man-made mineral fibres),
Monograph 43 [1988])
Chronic Toxicity
Continuous Filament Glass Fiber: No chronic health effects are known to be associated with exposure to continuous filament
fiber glass. Results from epidemiologic studies have not shown any increases in respiratory disease or cancer. The
International Agency for Research on Cancer (IARC) has classified continuous filament fiber glass as a Group 3 substance,
not classifiable as to its carcinogenicity to humans. Because of the large diameter of continuous filament fibers, these products
are not considered respirable.
Section 12 - Ecological Information
Ecotoxicity
A: General Product Information
No data available for this product.
B: Component Analysis - Ecotoxicity - Aquatic Toxicity
No ecotoxicity data are available for this product's components.
Section 13 - Disposal Considerations
US EPA Waste Number & Descriptions
A: General Product Information
This product is not expected to be a hazardous waste when it is disposed of according to the U.S. Environmental Protection
Agency (EPA) under Resource Conservation and Recovery Act (RCRA) regulations. Product characterization after use is
recommended to ensure proper disposal under federal and/or state requirements.
Page 3 of 5
Safety Data Sheet
Material Name: 8500 Series DuraGlass庐 Mats ID: 1121
B: Component Waste Numbers
No EPA Waste Numbers are applicable for this product's components.
Disposal Instructions
Dispose of waste material according to Local, State, Federal, and Provincial Environmental Regulations.
Section 14 - Transport Information
International Transport Regulations
These products are not classified as dangerous goods according to international transport regulations.
Section 15 - Regulatory Information
US Federal Regulations
A: General Product Information
SARA 311/312: This product is not classified as hazardous under SARA 311/312.
B: Component Analysis
None of this products components are listed under SARA Section 302 (40 CFR 355 Appendix A), SARA Section 313 (40 CFR
372.65), or CERCLA (40 CFR 302.4).
State Regulations
A: General Product Information
Component CAS #
Methyl Carbamate (trace) 598-55-0
Formaldehyde (potential trace) 50-00-0
TSCA Status
This product and its components are listed on the TSCA 8(b) inventory.
None of the components listed in this product are listed on the TSCA Export Notification 12(b) list.
International Regulations
A: General Product Information
These products are considered articles under both U.S. and international product regulations and as such, these products do
not require registration or notification on the various country-specific inventories.
B: Component Analysis - WHMIS IDL
The following components are identified under the Canadian Hazardous Products Act Ingredient Disclosure List:
Component CAS # Minimum Concentration
Continuous filament glass fibers Not Available 1 % (related to Fibrous glass)
WHMIS Classification
This is not a WHMIS controlled product. This product has been classified in accordance with the hazard criteria of the
Controlled Products Regulations. This SDS contains all the information required by the Controlled Products Regulations.
Section 16 - Other Information
Other Information
Prepared for:
Johns Manville Engineered Products Group
Mats & Reinforcements Division
P.O. Box 5108
Denver, CO 80217-5108
Prepared by:
Johns Manville Technical Center
P.O. Box 625005
Littleton, CO USA 80162-5005
As of the date of preparation of this document, the foregoing information is believed to be accurate and is provided in good
faith to comply with applicable federal and state law(s). However, no warranty or representation with respect to such
information is intended or given.
Date MSDS # Reason
08/13/08 1121-1.0000 Moved mat series from SDS 1112.
Page 4 of 5
Safety Data Sheet
Material Name: 8500 Series DuraGlass庐 Mats ID: 1121
End of Sheet
Page 5 of 5
|