MATERIAL SAFETY DATA SHEET
INSTANT RUST OUT
Iron Out, Inc.
Page 1 of 2
HMIS INFORMATION
Health: 3
Flammability: 1
IRON OUT, INC.
Reactivity: 3
1515 Dividend Road
Fort Wayne, IN 46808-1126
1-800-654-0791
In case of emergency call: CHEMTREC 1-800-424-9300
SECTION 1: PRODUCT INFORMATION
TRADE NAME: Instant Rust Out
DESCRIPTION: Aqueous Chemical Mixture
SECTION 2: HAZARDOUS INGREDIENTS
CAS# PEL TLV
25mg/m3
Ammonium Biflouride 1341-49-7 N/A
SECTION 3: PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE, COLOR, ODOR: Clear liquid with lime-like odor.
BOILING POINT: 2500C
VAPOR PRESSURE: (mmHg): NA VAPOR DENSITY: (AIR=1): NA
EVAPORATION RATE: (water=1): NA SOLUBILITY IN WATER: Extremely Soluble
SP. GRAVITY: (water=1): 1.03 PERCENT VOLATILE: NA
ND=NO DATA NA = NOT APPLICABLE
SECTION 4: FIRE AND EXPLOSION HAZARD
FLASH POINT AND METHOD USED: ND (Aqueous Solution)
EXTINGUISHING MEDIA: Water and foam.
EXPLOSION HAZARD: NA
SECTION 5: CHEMICAL REACTIVITY
STABILITY: NA
CONDITIONS TO AVOID: Strong acids.
HAZARDOUS DECOMPOSITION: None Known
HAZARDOUS POLYMERIZATION: None Known
INSTANT RUST OUT
Iron Out, Inc./Page 2 of 2
SECTION 6: CHRONIC TOXICITY
CARCINOGEN STATUS: NA
INHALATION: Allergic sensitizer.
SKIN CONTACT: ND INGESTION: ND
SECTION 7: ACUTE HEALTH HAZARDS
EYE AND SKIN CONTACT: Minor irritation to prolonged exposure.
INHALATION: Respiratory distress and nasal irritation.
INGESTION: Irritation to throat and mouth.
MEDICAL CONDITIONS EXACERBATED BY OVEREXPOSURE: Asthma, allergies, chronic
respiratory disease.
SECTION 8: FIRST AID
EYE AND SKIN CONTACT: Flush eyes for at least 15 minutes. Seek medical attention. Wash
area with soap and water. Remove contaminated clothing.
INHALATION: Remove to fresh air.
INGESTION (SWALLOWING): Rinse mouth with water. Drink plenty of water.
SECTION 9: HANDLING AND STORAGE
STORAGE & HANDLING: Do not store with reactive materials.
SAFE DISPOSAL: Follow Federal, State, and Local regulations.
IN CASE OF A SPILL: Contain and neutralize. Recontain if possible. Dispose in accordance to
Federal, State, and Local regulations.
SECTION 10: CONTROL MEASURES
PROTECTIVE EQUIPMENT: Use rubber materials for gloves and boots. Use chemical safety
goggles. Use NIOSH approved dust respirator.
VENTILATION: Local exhaust ventilation is acceptable for most applications.
MSDS Prepared by Scott R. Parker, CEA of Ergo Resource Management, Inc., 801 N.
Huntington St., Suite 7, Syracuse, IN 46567
The information in this MSDS was obtained from current and reputable sources. However, date
is provided without warranty, expressed or implied, regarding correctness or accuracy. It is the
user鈥檚 responsibility both to determine safe conditions for use of this product and to assume
liability for loss, injury, damage or expense resulting from improper use of this product.
Revised Date 8-29-2001
|