MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name ANTI-STATIC GEL
155
MSDS Number
- -0
CAS Number
ITW TRANS TECH
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
CUMENE 98-82-8 3% OSHA PEL: 50ppm ACGIH TLV:
50ppm
1,2,4-TRIMETHYL BENZENE 95-63-6 OSHA PEL: 25ppm ACGIH TLV:
25ppm OSHA/NIOSH IDLH TLV*:
Not established.
TRIMETHYL BENZENE 108-67-8 23 % OSHA PEL: 25ppm ACGIH TLV:
25ppm
XYLENES 1330-20-7 3% OSHA PEL: 100ppm ACGIH TLV:
100ppm
AROMATIC 64742-95-6 46 % OSHA PEL: 150 Stel: ACGIH
TLV: 150 Stel
GLYCOL ETHER 107-98-2 4% OSHA PEL: 100ppm ACGIH TLV:
100ppm
3 HAZARDS IDENTIFICATION
Emergency Overview
NI
4 FIRST AID MEASURES
Skin
Remove contaminated clothing. Wash thoroughly with mild soap and warm water. Consult a physician if there is any
persisting irritation.
Eye
Move victim away from exposure to vapors and into fresh air. If irritation or redness develops, seek medical attention. For
direct contact, hold eyelids apart and flush the affected eye(s) with clean water for at least 15 minutes. Seek medical
attention.
Printed On 15-May-06
ND = No Data NA = Not Applicable NI = Not Indicated
155 ANTI-STATIC GEL
Material Id Trade Name 1/ 4
Inhalation
If respiratory symptoms or other symptoms of expsoure develop, move victim away from source of exposure and into fresh
air. If symptoms persist, seek immediate medical attention. If victim is not breathing, artificial respiration should be
administered. If breathing difficulties develop, oxygen should be administered by qualified personnel. Seek immediate
medical attention.
Ingestion
Seek emergency medical attention. This product is slightly toxic by ingestion and an aspiration hazard. If victim is drowsy or
unconscious, place on the left side with the head down and do not give anything by mouth. If victim is conscious, alert and
not spontaneously vomiting, then vomiting should be induced for ingestions of large amounts (more than 5 ounces in an
adult) preferably with syrup of ipecac under direction from a physician or poison control center. If possible do not leave
victim unattended.
Medical Conditions Aggravated by Exposure
Pre-existing kidney and liver disorders may be aggravated by exposure to this material.
Notes to Physician
There is no specific antidote. Treatment of overexposure should be directed at control of the symptoms and the clinical
condition.
5 FIRE FIGHTING MEASURES
Extinguishing Media
"class b" fire extinguishers used in accordance with manufacturers instructions. Alcohol foam co2 dry chemical water fog
Basic Fire Fighting Procedures
Water may be unsuitable for use on burning liquids. Full protective equipment is recommended to protect fire fighters from
any hazardous decomposition products. Water spray may be ineffective. If water must be used, fog nozzles are highly
preferable. Water may be used to cool closed containers to prevent pressure build-up and possible auto-ignition or
explosion when exposed to extreme heat.
Unusual Fire & Explosion Hazards
Keep containers tightly closed. Isolate from heat, sparks and open flames. Closed containers may rupture when exposed to
extreme heat. Water may be used to cool unruptured containers. During emergency conditions, overexposure to
decomposition products may constitute a health hazard. Symptoms may not be immediately apparent. Obtain medical
attention.
114 F
Flash Point
0.5
Flammability Limits in Air, Lower, % by Volume
6
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Spill or Leak Procedure
Using non sparking tools, place leaking containers in a well ventilated area. Eliminate all sources of heat, sparks, or
ignition. Notify proper authorities if public waters or sewers are contaminated. Wear appropriate protective clothing and
respiratory protection equipment when entering the spill area. Shut off leak if it can be done safely. Ventilate the area. Dike
and pump off large spills into salvage or storage containers. Take up residue or small spills with abosrbent material such as
clay or vermiculite. Scoop up all contaminated soil and dispose of in same manner as the product.
7 HANDLING & STORAGE
Handling
NI
Storage
Avoid conditions listed in section v. Avoid prolonged storage at temperatures in excess of 100 f.
Ventilation
Local exhaust recommended when appropriate to control exposure to mist or aerosols. General exhaust is normally
adquate to minimize exposure to vapors.
Printed On 15-May-06
ND = No Data NA = Not Applicable NI = Not Indicated
155 ANTI-STATIC GEL
Material Id Trade Name 2/ 4
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Personal Protection Equipments (PPE)
Safety goggles or full face shield.
Skin Protection: Personal Protection Equipments (PPE)
Rubber or neoprene to minimize skin contact.
General
Impermeable aprons and boots. Safety shower and eye bath should be made available.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Mobile liquid. Faint odor.
248 - 355 F
Boiling Point
< 0.92
Specific Gravity
NI
Melting Point
7.66 lbs. per gallon
Percent Volatile
12.5 @ 25C
Vapor Pressure
slower
Evaporation Rate
heavier
Vapor Density
Slight
Solubility In Water
10 STABILITY & REACTIVITY
Stability/Incompatibility
This mixture is stable and hazardous polymerization will not occur. Strong acids or bases, oxidizing agents and selected
amines. Conditions to avoid: extreme temperatures, sparks, open flames or any other ignition sources.
Hazardous Reactions/Decomposition Products
Thermal decomposition in the presence of air may yield carbon monoxide and/or carbon dioxide.
Hazardous Polymerization
NI
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Primary routes of entry are dermal and inhalation.
12 ECOLOGICAL INFORMATION
13 DISPOSAL CONSIDERATIONS
Waste Disposal
As a hazardous waste, this material must be disposed of in accordance with all federal, state and local ordinances. Inquire
of your local environmental agencies for the exact legal requirements in your area.
14 TRANSPORT INFORMATION
15 REGULATORY INFORMATION
Printed On 15-May-06
ND = No Data NA = Not Applicable NI = Not Indicated
155 ANTI-STATIC GEL
Material Id Trade Name 3/ 4
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 2 Flammability 2 Reactivity 0 Personal Prot. Equip. C
Following ingredients of this product are listed in SARA313
SARA Listed Ingredient Name CAS Number Maximum %
1,2,4-TRIMETHYL BENZENE 95-63-6 23.0
CUMENE 98-82-8 3.0
XYLENES 1330-20-7 3.0
Listed on the following Regulatory List(s)
SARA 313
16 OTHER INFORMATION
Disclaimer
This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of ITW
Trans Tech. The data on this sheet applies only to the specific material designated herein. ITW Trans Tech. assumes no
legal responsibility for use of reliance upon this data.
5/15/2006 4/8/2003
Replaces Sheet Dated
Completed On
ITW TRANS TECH
Completed By
Printed On 15-May-06
ND = No Data NA = Not Applicable NI = Not Indicated
155 ANTI-STATIC GEL
Material Id Trade Name 4/ 4
|