MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name FLOW AGENT VM2
399
MSDS Number
TRANS TECH AMERICA, INC.
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
NAPHTHA, SOLVENT 100 64742-95-6 30 - 40 % OSHA PEL: 100ppm ACGIH TLV:
125ppm
1-METHOXY PROPANOL-2 107-98-2 5 - 10 % ACGIH TLV: 360 mg/m3
3 HAZARDS IDENTIFICATION
Emergency Overview
In all cases of doubt, or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious
person. Unconsciousness: lateral position - call a physician.
Potential Health Effects, Skin
Skin contact may lead to degreasing with resultant dry skin, cracking, irritation and dermatitis.
Potential Health Effects, Eye
Eye contact with liquid or vapor causes severe irritation, redness, tearing, blurred vision.
Potential Health Effects, Inhalation
Excessive inhalation of vapors can cause nasal, throat and respiratory irritation, dizziness, weakness, fatigue, nausea,
headache and possible unconsciousness. Excessive vapor concentration in air, especially in confined spaces, may cause
asphyxiation.
Potential Health Effects, Ingestion
Swallowing may cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Special Toxic Effects
Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Reports have associated
repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage.
Printed On 17-Nov-03
ND = No Data NA = Not Applicable NI = Not Indicated
399 FLOW AGENT VM2
Material Id Trade Name 1/ 4
Effects of Long-Term (Chronic) Exposure
Health studies have shown that many solvents pose potential human health risks which may vary from person to person.
As a precaution, exposure to liquids and vapors should be minimized.
Exposure to liquids and vapors should be minimized.
Prolonged or continuous inhalation of vapors may result in delayed lung damage.
Repeated inhalation of vapor in high concentration can change the blood pressure.
Repeated or prolonged inhalation of vapor may cause liver and kidney damage.
4 FIRST AID MEASURES
Skin
Wash area thoroughly with soap and water and rinse. Do not use solvents or thinners.
Eye
Remove contact lenses, keep eyelids open. Flush with plenty of water (10-15 minutes). Call a physician.
Inhalation
Take the casualty into the fresh air and keep warm. Irregular breathing/no breathing: artificial respiration. Call a
physician.
Ingestion
Do not induce vomiting. Call a physician. Keep at rest.
Medical Conditions Aggravated by Exposure
None known.
5 FIRE FIGHTING MEASURES
Extinguishing Media
Suitable: alcohol resistant foam, CO2, powders, water spray.
Not suitable: water jet
Basic Fire Fighting Procedures
Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard. Use self contained
breathing apparatus to avoid possible fumes.
Unusual Fire & Explosion Hazards
Water may be used to cool endangered containers. Do not allow the quenching water into the sewage system.
35 潞C approx.
Flash Point
0.6
Flammability Limits in Air, Lower, % by Volume
10
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Environmental Precautions
Do not empty into drains. If the product contaminates lakes, rivers or sewer systems, inform appropriate authorities in
accordance with local regulations.
Spill or Leak Procedure
Remove sources of ignition. Ventilate area. Contain and collect spillage with non-combustible absorbent materials, e.g.
sand, earth, vermiculite, diatomaceous earth and place in container for disposal according to local regulations. Clean
preferably with a detergent. Avoid use of solvents.
Printed On 17-Nov-03
ND = No Data NA = Not Applicable NI = Not Indicated
399 FLOW AGENT VM2
Material Id Trade Name 2/ 4
7 HANDLING & STORAGE
Handling
Prevent the creation of flammable or explosive concentrations of vapor in air and avoid vapor concentration higher than the
occupational exposure limits. The product should only be used in areas from which all naked lights and other sources of
ignition have been excluded. Comply with the health and safety at work laws.
Vapors are heavier than air and may spread along floors. Vapors may form explosive mixtures with air. Preparation may
change electrostatically: always use earthing leads when transferring from one container to another. Operators should wear
antistatic footwear and clothing. No sparking tools should be used.
Storage
Containers which are opened must be carefully resealed and kept upright to prevent leakage. Keep container tightly closed.
Never use pressure to empty: container is not a pressure vessel. No smoking. Prevent unauthorized access.
Always keep in containers of same material as the original one. Avoid heating and direct sunlight.
See also instructions on the label.
Ventilation
Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation
and good general extraction. If these are not sufficient in maintaining concentrations of particles and solvent vapor below
the OEL, suitable respiratory protection must be worn.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Personal Protection Equipments (PPE)
Safety goggles.
Skin Protection: Personal Protection Equipments (PPE)
Protective gloves. After washing hands, replace lost skin fat by fat containing skin creams.
Personnel should wear anti static clothing made of natural fiber or of high-temperature-resistant synthetic fiber. All parts of
the body should be washed after contact.
Respiratory Protection: Personal Protection Equipments (PPE)
If workplace limits are exceeded, a gas mask approved for this particular job must be worn.
General
This product is unlikely to harm health, given normal and proper handling and hygienic precautions. Prolonged inhalation
of vapors in high concentrations may lead to headache, giddiness and nausea. In case of contact with the product: danger
of resorption through the skin, irritation of skin/mucous membranes.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Clear liquid with odor of organic solvents
119 - 170 潞C
Boiling Point
0.9 g/cm3 , approx.
Specific Gravity
NI
Melting Point
50 %
Percent Volatile
12 approx.
Vapor Pressure
NI
Evaporation Rate
>1
Vapor Density
no
Solubility In Water
Printed On 17-Nov-03
ND = No Data NA = Not Applicable NI = Not Indicated
399 FLOW AGENT VM2
Material Id Trade Name 3/ 4
10 STABILITY & REACTIVITY
Stability/Incompatibility
Stable under normal conditions of use.
Materials to Avoid: Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid
exothermic reactions.
Hazardous Reactions/Decomposition Products
When exposed to high temperatures may produce hazardous decomposition products such as carbon monoxide and
dioxide, smoke, oxides of nitrogen.
Hazardous Polymerization
none.
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Inhalation, ingestion, skin and eye contact.
12 ECOLOGICAL INFORMATION
13 DISPOSAL CONSIDERATIONS
Waste Disposal
Disposal according to federal, state and local regulations.
14 TRANSPORT INFORMATION
Department of Transportation (DOT) Requirements:
General Transportation Information for Bulk Shipments
Proper Shipping Name Paint Related Material
UN/NA Code 1263
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 2 Flammability 3 Reactivity 1 Personal Prot. Equip. C
16 OTHER INFORMATION
Disclaimer
The details in this material safety data sheet satisfy national legislation. However, we have no knowledge or control over
the individual user's working conditions. The product may not be used for any purpose other than that specified in the
product data sheet unless written consent has been obtained. The user is responsible for the observance of all required
statutory provisions.
11/17/2003 3/12/1998
Replaces Sheet Dated
Completed On
TRANS TECH AMERICA, INC.
Completed By
Printed On 17-Nov-03
ND = No Data NA = Not Applicable NI = Not Indicated
399 FLOW AGENT VM2
Material Id Trade Name 4/ 4
|