MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name HARDENER HT1
TRANS TECH AMERICA, INC.
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
POLYURETHANE RESIN 75 - 80
AROMATIC HYDROCARBONES 64742-95-6 20 - 25 NA
..........**** 45% TRIMETHYL BENZENE 25551-13-7 ACGIH TLV: 25ppm
2-BUTANONE OXIM 96-29-7
Composition Comments
..........****Applies to Aromatic Hydrocarbons ONLY.
3 HAZARDS IDENTIFICATION
Potential Health Effects, Skin
May cause sensitization by skin contact. Sensitized persons may show asthmatic symptoms when exposed to atmospheric
concentrations well below the exposure limits. Absorption may occur through skin. Dries the skin. Repeated contact with
the skin may lead to inflammation.
Potential Health Effects, Eye
Splashes in the eyes may cause pronounced burning pains.
Potential Health Effects, Inhalation
Asthma, allergies, chronic or recurrent respiratory disease aggravated by exposure. Inhalation can cause headaches,
dizziness, tiredness and nausea. Prolonged or repeated inhalation may affect the nervous system and cause kidney and
liver complaints.
Potential Health Effects, Ingestion
If swallowed, stomach complaints and irritation of the digestive organs may result.
Signs & Symptoms of Short-Term (Acute) Exposure
Irritating to respiratory system and skin. May cause sensitization by skin contact.
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
517 HARDENER HT1
Material Id Trade Name 1/ 4
4 FIRST AID MEASURES
Skin
Wash immediately with soap and water. Remove and launder contaminated clothing before reuse. Call a physician. Keep
at rest.
Eye
Rinse immediately with plenty of water. See a physician for medical treatment.
Inhalation
Remove to fresh air and keep warm. If breathing is difficult: artificial respiration. Call for a physician.
Ingestion
GET IMMEDIATE MEDICAL ATTENTION. Do not induce vomiting. In all cases of doubt, or when symptoms persist, seek
medical attention.
5 FIRE FIGHTING MEASURES
Extinguishing Media
Foam, carbon dioxide, chemical powder, sand
Basic Fire Fighting Procedures
Wear self-contained breathing apparatus, wear protective clothing and equipment. Water may be used to cool closed
containers to prevent pressure build-up and possible auto-ignition or explosion when exposed to extreme heat.
Unusual Fire & Explosion Hazards
Vapors are heavier than air and may spread along floors. Vapors may form explosive mixtures with air. Preparation may
charge electrostatically: always use earthing leads when transferring from one container to another. Operators should wear
anti static footwear and clothing. No sparking tools should be used. Avoid heat, open flames, static electricity, electrical
equipment and sparks. Keep container tightly closed. Application to hot surfaces requires special precautions.
45 潞C method used: closed cup
Flash Point
450 潞C
AutoIgnition Temperature
1
Flammability Limits in Air, Lower, % by Volume
7.5
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Environmental Precautions
Dispose of or incinerate in accordance with local, state and federal regulations.
Spill or Leak Procedure
Remove sources of ignition. Ventilate area. Remove by using suitable inert liquid absorbing material, e.g. kieselgur. Do not
breathe vapors. Clean preferably with a detergent. Avoid use of solvents.
7 HANDLING & STORAGE
Handling
FOR INDUSTRIAL USE ONLY! Persons with a history of asthma, allergies, chronic or recurrent respiratory disease should
not be employed in any process in which this preparation is used. Do not breathe vapor. Use only in well ventilated areas.
Prevent the creation of flammable or explosive concentrations of vapor in air. Avoid vapor concentration higher than the
occupational exposure limit. Keep container tightly closed. When using do not eat, drink or smoke. Avoid contact with skin
and eyes.
Storage
Store in cool ventilated area. Keep container tightly closed when not in use and during transport.
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
517 HARDENER HT1
Material Id Trade Name 2/ 4
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering Controls
Use and store with adequate ventilation.
Eye Protection: Personal Protection Equipments (PPE)
Wear chemical safety goggles.
Skin Protection: Personal Protection Equipments (PPE)
Protective Gloves: Required for repeated or prolonged contact, to protect against splash. Wear a protective apron if
splashing or repeated contact is likely.
Respiratory Protection: Personal Protection Equipments (PPE)
If TLV or PEL of one hazardous component is exceeded, use approved combination of charcoal filter and particulate filter
mask or airfed respirators. Its use must be in compliance with all OSHA health and fit testing requirements. Use respiratory
protection when spray painting.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Liquid Characteristic odor.
162 潞C
Boiling Point
1.06
Specific Gravity
n.a.
Melting Point
5
Vapor Pressure
>1
Vapor Density
moderate (parts of solvents)
Solubility In Water
265 grams per liter
Volatile Organic
10 STABILITY & REACTIVITY
Stability/Incompatibility
Incompatible with strong acids, alkalies and oxidizers.
Stable under recommended storage and handling conditions. Avoid high temperatures,
Hazardous Reactions/Decomposition Products
When exposed to high temperatures, dangerous decomposition products such as carbon dioxide, carbon monoxide, soot
and nitrogen oxides can be produced. Butanone oxime is liberated under baking conditions (110-130潞C e.g.).
Hazardous Polymerization
Will not occur.
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Inhalation, ingestion, skin and eye contact.
Carcinogenicity
NATIONAL TOXICOLOGY PROGRAM: No
IARC MONOGRAPHS: No
OSHA: No
EPA: No
12 ECOLOGICAL INFORMATION
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
517 HARDENER HT1
Material Id Trade Name 3/ 4
13 DISPOSAL CONSIDERATIONS
Waste Disposal
Dispose of in accordance with all federal, state, and local regulations. Do not flush to sewer, watershed, or waterway.
14 TRANSPORT INFORMATION
Department of Transportation (DOT) Requirements:
General Transportation Information for Bulk Shipments
Proper Shipping Name Paint Related Material
UN/NA Code 1263
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 2 Flammability 2 Reactivity 0 Personal Prot. Equip. C
Following ingredients of this product are listed in SARA313
SARA Listed Ingredient Name CAS Number Maximum %
1,2,4-TRIMETHYL BENZENE 95-63-6 8.8
16 OTHER INFORMATION
Disclaimer
Information for this material safety data sheet was obtained from sources considered technically accurate and reliable.
While every effort has been made to ensure full disclosure of product hazards, in some cases the data is not available and
is so stated. Since conditions of actual product use are beyond the control of the supplier, it is assumed that users of this
material have been fully trained according to the applicable requirements. No warranty, expressed or implied, is made and
the supplier will not be liable for any losses, injuries or consequential damages which may result from the use or reliance on
any information contained in this form or the use of the material.
1/29/2002 Replaces Sheet Dated
Completed On
TRANS TECH AMERICA, INC.
Completed By
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
517 HARDENER HT1
Material Id Trade Name 4/ 4
|