MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name CLEANER UR3
ITW TRANS TECH
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
SOLVENT NAPHTHA(Petroleum) light 64742-95-6 65 - 70 n.av.
aroma
4-HYDROXY-4-METHYLPENTAN-2-ONE 123-42-2 15 - 20 OSHA PEL: 50ppm ACGIH TLV:
50ppm
N-BUTYLACETATE 123-86-4 15 - 20 ACGIH TLV: 713 mg/m3
Composition Comments
Solvent mixture of aromatic hydrocarbons (C9-C10) and esters.
3 HAZARDS IDENTIFICATION
Potential Health Effects, Skin
Repeated exposure may cause skin dryness or cracking.
Potential Health Effects, Eye
Irritating to eyes.
Potential Health Effects, Inhalation
Inhalation may result in respiratory irritation. Vapors may cause drowsiness and dizziness.
Potential Health Effects, Ingestion
May cause lung damage if swallowed.
4 FIRST AID MEASURES
Skin
Wash away with soap and water and rinse. DO NOT use solvents or thinners.
Eye
Flush with plenty of water (10-15 minutes). Call a physician.
Inhalation
Remove to fresh air and keep warm. Irregular breathing/no breathing: artificial respiration. Call a physician.
Printed On 5-Jun-07
ND = No Data NA = Not Applicable NI = Not Indicated
632 CLEANER UR3
Material Id Trade Name 1/ 4
Ingestion
Call a physician. Do not induce vomiting. Keep at rest.
5 FIRE FIGHTING MEASURES
Extinguishing Media
Dry powder, sand, foam, carbon dioxide
Water jet should not be used because water is not mixable with a lot of organic solvents and such solvents will spread on
the water surface.
Basic Fire Fighting Procedures
Breathing apparatus with an independent source of air may be required. Cool endangered containers with water in case of
fire.
Unusual Fire & Explosion Hazards
In case of fire, dangerous smoke gases such as carbon dioxide, carbon monoxide and soot can be produced. Therefore,
take suitable precautionary measures for fire fighting. Residues remaining after a fire have to be disposed of appropriately.
42 潞c
Flash Point
420 潞c
AutoIgnition Temperature
0.7
Flammability Limits in Air, Lower, % by Volume
8
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Emergency Action
Keep ignition sources out of area. Provide for sufficient ventilation.
Environmental Precautions
Do not empty into drains. If the product contaminates lakes, rivers or sewer systems, inform appropriate authorities in
accordance with local regulations.
Spill or Leak Procedure
Keep all sources of ignition away. Absorb with inert material (e.g. Kieslgehr, sand and dispose. Observe all local, state and
federal laws and regulations regarding disposal, spill, clean up, removal or discharge. Clean preferably with a detergent:
avoid use of solvents. Proper ventilation of workplace.
7 HANDLING & STORAGE
Handling
Prevent the creations of flammable or explosive concentration of dust in air and avoid dust concentration higher then the
occupational exposure limits. Additionally, the product should only be used in areas from which all naked lights and other
sources of ignition have been excluded. Comply with the health and safety at work laws. Vapors are heavier than air and
may spread along floors. Vapors may form explosive mixtures with air. Preparation may change electrostatically: always
use earthing leads when transferring from one container to another. Operators should wear antistatic footwear and clothing.
No sparking tools should be used.
Storage
Recommended storage temperature: 15-20潞C. Keep containers closed when not in use. Never use pressure to empty:
container is not a pressure vessel. No smoking. Prevent unauthorized access. Containers which are opened must be
carefully resealed and kept upright to prevent leakage.
Keep away from oxidizing agents, from strongly alkaline and strongly acid materials. Always keep in containers of same
material as the original one. Avoid heating and direct sunlight. Keep away from sources of ignition.
Ventilation
Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation
and good general extraction. If these are not sufficient in maintaining concentrations of particles and solvent vapor below
the OEL, suitable respiratory protection must be worn.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Printed On 5-Jun-07
ND = No Data NA = Not Applicable NI = Not Indicated
632 CLEANER UR3
Material Id Trade Name 2/ 4
Eye Protection: Personal Protection Equipments (PPE)
Wear safety glasses.
Skin Protection: Personal Protection Equipments (PPE)
Chemical protection gloves are suitable, which are tested according to EN 374.
Recommendation for protection against components normally found in the products:
For short-term contact (e.g. spray protection) as well as for long-term contact (e.g. cleaning purposes):
Suitable material: LLDPE
Material thickness: 0.06 mm
Penetration time: >480 min.
Protective gloves must always be tested and confirmed with regard to suitability to each specific working environment (e.g.
mechanical resistance, product compatibility, anti static). Follow the instructions and information from the glove
manufacturer in reference to use, storage, care, and frequency of glove exchange. Protective gloves should be immediately
replaced upon being damaged or when showing first signs of wear. Preventive skin protection (skin protective cream) is
recommended. Contaminated skin areas should immediately be washed (follow date sheet for skin protection ZH 1/132).
Working procedures are to be so arranged that the permanent wearing of gloves will not be necessary. We recommend to
set up a hand protection plan, which is adapted to the needs of the local business. Personnel should wear anti static
clothing made of natural fiber or of high-temperature-resistant synthetic fiber. All parts of the body should be washed after
contact. Use re-greasing skin cream.
Respiratory Protection: Personal Protection Equipments (PPE)
Breathing protection equipment required in inadequately ventilated places and during spraying.
General
The usual precautionary measures for the handling of chemicals have to be observed.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Colorless liquid. Characteristic odor.
124 潞C
Boiling Point
0.88
Specific Gravity
20 潞C
Vapor Pressure
20 潞C
Vapor Density
20 潞C
Viscosity
partly mixable
Solubility In Water
10 STABILITY & REACTIVITY
Stability/Incompatibility
Conditions to avoid: Stable under recommended storage and handling conditions. (see section 7)
Materials to Avoid: Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid
exothermic reactions.
Hazardous Reactions/Decomposition Products
When exposed to high temperatures, dangerous decomposition products such as carbon dioxide, carbon monoxide, soot
and nitrogen oxides can be produced.
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Inhalation, ingestion, skin and eye contact.
Printed On 5-Jun-07
ND = No Data NA = Not Applicable NI = Not Indicated
632 CLEANER UR3
Material Id Trade Name 3/ 4
Toxicological Data
Exposure to component solvents vapors concentration in excess of the stated occupational exposure limit may result in
adverse health effect such as mucous membrane and respiratory system irritation and adverse effect on kidney, liver and
central nervous system. Symptoms and signs include headache, dizziness, fatigue, muscular weakness, drowsiness and in
extreme cases, loss of consciousness. Solvents may cause symptoms like described above by absorption through the skin.
Repeated or prolonged contact with the preparation may cause removal of natural fat from the skin resulting in non-allergic
contact dermatitis and absorption through the skin. Splashes in the eyes have an irritant effect. If swallowed, stomach
complaints and irritation of the digestive organs may result.
12 ECOLOGICAL INFORMATION
EcoToxicological Information
There is no data available on the preparation itself. The product should not be allowed to enter drains or watercourses.
13 DISPOSAL CONSIDERATIONS
Waste Disposal
Dispose of in accordance with federal, state, and local regulations. Dispose of only completely emptied containers!
14 TRANSPORT INFORMATION
Department of Transportation (DOT) Requirements:
General Transportation Information for Bulk Shipments
Proper Shipping Name Paint Related Material
UN/NA Code 1263
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 1 Flammability 3 Reactivity 1 Personal Prot. Equip. C
Following ingredients of this product are listed in SARA313
SARA Listed Ingredient Name CAS Number Maximum %
SOLVENT NAPHTHA(Petroleum) light aroma 64742-95-6
4-HYDROXY-4-METHYLPENTAN-2-ONE 123-42-2
N-BUTYLACETATE 123-86-4
Listed on the following Regulatory List(s)
SARA 313
16 OTHER INFORMATION
Disclaimer
According to their chemical structure, the applied raw materials do not contain any antimony, arsenic, soluble barium, lead,
cadmium, chromium, mercury and selenium. Information for this material safety data sheet was obtained from sources
considered technically accurate and reliable. While every effort has been made to ensure full disclosure of product
hazards, in some cases the data is not available and is so stated. Since conditions of actual product use are beyond the
control of the supplier, it is assumed that users of this material have been fully trained according to the applicable
requirements. No warranty, expressed or implied, is made and the supplier will not be liable for any losses, injuries or
consequential damages which may result from the use or reliance on any information contained in this form or the use of
the material.
6/5/2007 Replaces Sheet Dated
Completed On
Completed By
Printed On 5-Jun-07
ND = No Data NA = Not Applicable NI = Not Indicated
632 CLEANER UR3
Material Id Trade Name 4/ 4
|