MATERIAL SAFETY DATA SHEET
Perma Lok庐
SECTION I 鈥? CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Distributed By: Allied Rubber & Gasket Company ARGCO
2610 Commerce Way
Vista, CA 92081
(800)854-1015
Product Number: 82-9832 Product Name: PERMA-LOK庐 LK 150
CAS Number of Product: Unassigned Synonyms: NONE
In case of emergency call: 908-685-5000 Date Prepared: 1/23/2007
SECTION II 鈥? COMPOSITION / INFORMAION OF INGREDIENTS
Chemical Family 鈥? Anaerobic Adhesive / Sealant
Component CAS Number Concentration Ranges (%)
Tetraethylene Glycol 109-17-1 >1
Dimethacrylate
SECTION III 鈥? HAZARDS IDENTIFICATION
Eye Irritant, Harmful if swallowed.
Eye: Irritating, may injur eye tissue if not removed promptly.
Skin contact: Frequent or prolonged contact may irritate and cause dermatitis. May cause skin sensitization, a
partial or whole body dermatitic rash experienced after exposure, however minimal.
Inhalation: Based on its low volatility, product is not considered to be a respiratory hazard under normal
conditions of use. Irritating and/or toxic vapors may be released at elevated temperatures.
Ingestion: Ingestion effects have not been caused but are assumed to cause nausea and vomiting.
SECTION IV 鈥? FIRST AID MEASURES
Eye: Immediately flush eyes with large amounts of water for at least 15 minutes, lifting upper and
lower lids. Get prompt medical attention.
Skin Contact: Flush exposed areas thoroughly with soap and water until all chemical is removed. Remove
contaminated clothing and launder before reuse.
Inhalation: First aid in not normally required. Remove to fresh air. If breathing is difficult, give oxygen. If
breathing has stopped, give artificial respiration. Get medical attention.
1
Ingestion: DO NOT induce vomiting. If individual is conscious, give milk or water to dilute stomach
contents. Keep warm and quiet. Get prompt medical attention. DO NOT attempt to give
anything by mouth to an unconscious person.
SECTION V 鈥? FIRE FIGHTING MEASURES
AutoIgnition: Not determined
Flash Point: 230 F (Setaflash Closed Tester)
Extinguishing Media: CO2, Dry Chemical, Foam, Water fog.
Special Firefighting: Fire fighters should be equipped with self-contained breathing apparatus.
Procedures: To protect against potentially toxic and irritating fumes, cool exposed equipment
with water spray.
Fire & Explosion Hazards: Polymerization may take place at elevated temperatures.
Upper Explosion Limit (%): Not Applicable
Lower Explosion Limit (%): Not Applicable
NFPA Flammability Hazard: 1=Slight
Class
SECTION VI 鈥? ACCIDENTAL RELEASE MEASURES
Spill and Leak Procedures:
Wear protective clothing. Stop leak if you can do it without risk. For small spills take up with sand or other
inert absorbent material and place in a container for later disposal. Note: In bulk quantities, product
absorbed on inert material may polymerize generating significant heat and pressure. Vent disposal
container to prevent build-up of pressure. Can carefully solidify with anaerobic surface conditioner and
dispose of as solid waste.
For safety and environmental precautions, please review entire Material Safety Data Sheet for necessary
information.
SECTION VII 鈥? HANDLING AND STORAGE
Storage Temperature: Room temperature
Special Sensitivity: Avoid excessive heat.
Handling and Storage: Store out of direct sunlight in a dry area. Maximum storage temperature is 100潞F.
Ventilation Requirements: General
SECTION VIII 鈥? EXPOSURE CONTROL/PERSONAL PROTECTION
Ventilation Requirements: General
Eye Protection Requirements: Safety glasses, goggles or face shield to protect against splashing.
2
Glove Requirements: Employee must wear appropriate protective gloves to prevent contact with
this substance.
Clothing Requirements: No special clothing required for low volume activity.
Change/Removal of Clothing: Remove clothing and launder before reuse if contaminated with product.
Wash Requirements: Wash hands with soap and water if contact with product occurs or before
eating, drinking, smoking, or using toilet facilities.
Respirator Requirements: None required under normal handling conditions. Use NIOSH approved
respirator if vapor or mist levels are irritating.
SECTION IX 鈥? PHYSICAL AND CHEMICAL PROPERTIES
Pure Substance or Mixture: Mixture Specific Gravity (Water =1): 1.070
Physical Form: Liquid Bulk Density: 8.91 lbs/gal
Appearance/Odor: White Paste; mild, pleasant odor Evaporation Rate: N/A
Odor Threshold: Not available Vapor Pressure (mm HG): 0.01 (77F)
pH as IS: N/A Vapor Density(air=1) 1.01
pH in (1% solution): N/A Viscosity: 200,000 cps
Boiling Point: Polymerize before BP attained Volatiles: Less than 1%
Melting/Freezing Point: N/A Volatile Organic Compounds: 0.09 lbs/gal (10g/l)
Solubility in Water: Insoluble AutoIgnition: Not determined
Partition Coefficient: N/A Flash Point: 230潞 F
Oxidizing Properties: N/A
(n=octanol/water)
SECTION X鈥? STABILITY AND REACTIVITY
Stability: Stable
Material to Avoid: Metals and their salts, PERMA-LOK庐 Anaerobic Surface Conditioners
NFPA Reactivity Hazard Class: 2= Moderate
Hazardous Decomposition Products:
Thermal decomposition could produce carbon monoxide, carbon dioxide, and unidentified organic compounds.
Hazardous Polymerization Condition:
Note: PERMA-LOK庐 products are anaerobic and polymerize in the absence of air. Sunlight, excessive heat,
and contamination by metals or anaerobic surface conditioner in large quantities, will also cause
polymerization.
SECTION XI 鈥? TOXOLGICAL INFORMATION
CHRONIC (LONG TERM) EFFECTS OF EXPOSURE
Routes of Entry: Skin contact, eye contact, ingestion
Effects on Chronic Exposure: In certain individuals, sensitization may occur causing dermatitis with
even minimal contact.
Target Organs: Skin, eyes
Special Health Effects: None Known
TOXICOLOGY INFORMATION
3
Raw Material Name: Tetraethylene Glycol Dimethacrylate.
Notes on Oral Toxicity: Low order of toxicity.
Notes on Dermal Toxicity: Irritating to the skin. Causes skin sensitization, a partial or whole-body
dermatitic rash experienced after exposure, however minimal.
Notes on Inhalation: Irritating to eyes and respiratory tract. Vapors and/or aerosols which may
be formed at elevated temperatures may be irritating to eyes and
respiratory tract.
Notes on Eyes Irritation: Irritating, but does not injure eye tissue.
Other Notes on Toxicity: Sensitize
SECTION XII 鈥? ECOLOGICAL INFORMATION
Not Available
SECTION XIII 鈥? DISPOSAL CONSIDERATIONS
Waste Disposal Methods: Waste disposal should be in accordance with existing federal, state and local
environmental regulations.
Empty Container Warnings: Empty containers may contain product residue; follow MSDS and label
warnings even after they have been emptied.
SECTION XIV 鈥? TRANSPORTATION INFORMATION
DOT INFORMATION
DOT Shipping Name: None
DOT Hazard Class: Not Regulated
DOT Reportable Quantity: None
UNITED NATIONS INFORMATION
U.N. Number: N/A
U.N. Class: N/A
Disclaimer
The information contained herein is accurate and reliable as of the date issued to the best of the manufacturer鈥檚
knowledge. ARGCO doesn鈥檛 warrant or guarantee its accuracy or reliability and shall not be liable for any
loss or damage arising from the use thereof. It is the user鈥檚 responsibility to satisfy itself that the information
offered for its consideration is suitable for its particular use.
END OF MATERIAL SAFETY DATA SHEET
4
|