MATERIAL SAFETY DATA SHEET
TUF-CUT鈩? THREADING OIL- DARK
SECTION I 鈥? PRODUCT INFORMATION
Distributor鈥檚 name: Allied Rubber & Gasket Company, Inc. 鈥? ARGCO
2610 Commerce Way
Vista, Ca 92081
In case of emergency: Contact your local poison control center
For information call: (800) 854-1015
Date prepared: 8/8/2007
Product name: Tuf-Cut鈩? Threading Oil
SECTION II 鈥? COMPOSITION/INFORMATION ON INGREDIENTS
Component CAS No. Amount (Vol%)
99
SEVERELY SOLVENT REFINED HEAVY 64741-88-4
PARAFFINIC PETROLEUM OIL
1
PROPRIETARY ADDITIVES PROPRIETARY
EXPOSURE GUIDELINES (SEE SECTION 15 FOR ADDITIONAL EXPOSURE LIMITS)
CAS No. Governing Body Exposure Limits
SECTION III 鈥? HAZARDS IDENTIFICATION
3. HAZARDS IDENTIFICATION
鈥? EMERGENCY OVERVIEW
Poses little or no immediate hazard.
Hazards Ratings:
Key: 0 = least, 1 = slight, 2 = moderate, 3 = high, 4 = extreme
Health Fire Reactivity PPI
NFPA 0 1 0
X
HMIS 0 1 0
鈥? POTENTIAL HEALTH EFFECTS
PRE-EXISTING MEDICAL CONDITIONS
The following diseases or disorders may be aggravated by exposure to this product: Skin,
INHALATION
No acute effects expected.
no data
LC50 (mg/l):
no data
LC50 (mg/m3):
no data
LC50 (ppm):
1
SKIN
Practically non-toxic if absorbed through the skin. May cause minimal skin irritation.
no data
Draize Skin Score: Out of 8.0
no data
LD50 (mg/kg):
EYES
No eye effect expected.
INGESTION
Practically non-toxic if ingested.
no data
LD50 (g/kg):
SECTION IV 鈥? FIRST AID MEASURES
鈥? INHALATION
No specific treatment is necessary since this material is not likely to be hazardous by inhalation. If
exposed to excessive levels of dusts or fumes, remove to fresh air and get medical attention if
cough of other symptoms develop.
鈥? SKIN
Wash with soap and water. Get medical attention if irritation develops or persists. Wash clothing
before reuse.
鈥? EYES
Hold eyelids apart and flush eyes with plenty of water for at least 15 minutes. If eye irritation
persists, obtain medical treatment.
鈥? INGESTION
Material is practically non-toxic. Induction of vomiting is not required. Get medical attention
immediately.
SECTION V 鈥? FIRE FIGHTING MEASURES
鈥? EXTINGUISHING MEDIA
Water spray. Regular foam. Dry chemical. Carbon dioxide
鈥? FIRE FIGHTING INSTRUCTIONS
Wear structural fire fighting gear. As in any fire, wear self-contained breathing apparatus
pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear.
FLAMMABLE PROPERTIES
Typical Minimum Maximum Text Result Units Method
F COC
345
Flash Point
725 F N/A
ESTIMATED
Autoignition
Temperature
no data % N/A
Lower Explosion Limit
no data % N/A
Upper Explosion Limit
2
SECTION VI 鈥? ACCIDENTAL RELEASE MEASURES
Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.
Use appropriate personal protective equipment as stated in Section 8 of this MSDS. Advise the
Environmental Protection Agency (EPA) and appropriate state agencies, if required. Absorb spill
with inert material (e.g., dry sand or earth), then place in a chemical waste container. Vacuum or
sweep up material and place in a disposal container.
SECTION VII 鈥? HANDLING AND STORAGE
鈥? HANDLING
Wash thoroughly after handling.
鈥? STORAGE
NFPA class IIIB storage. Flash point is greater than 200 degrees F.
SECTION VIII 鈥? EXPOSURE CONTROLS/PERSONAL PROTECTION
Consult With a Health and Safety Professional for Specific Selections
鈥? ENGINEERING CONTROLS
Use with adequate ventilation. Ventilation is normally required when handling or using this
product to keep exposure to airborne contaminants below the exposure limit. Mechanical
ventilation recommended.
鈥? PERSONAL PROTECTION
EYE PROTECTION
Safety glasses (with side shields) recommended. Splash proof chemical goggles are
recommended to protect against the splash of product.
GLOVES or HAND PROTECTION
Protective gloves are recommended when prolonged skin contact cannot be avoided. The
glove(s) listed below may provide protection against permeation. Gloves of other chemically
resistant materials may not provide adequate protection. Neoprene; Nitrile; Viton;
RESPIRATORY PROTECTION
Concentration in air determines the level of respiratory protection needed. Use only NIOSH certified respiratory
equipment. Respiratory protection is not usually needed unless product is heated or misted.. Half-mask air
purifying respirator with dust / mist filters or HEPA filter cartridges is acceptable for exposures to ten (10) times
the exposure limit. Full-face air purifying respirator with dust / mist filters or HEPA filter cartridges is acceptable
for exposures to fifty (50) times the exposure limit. Protection by air purifying respirators is limited. Use a positive
pressure-demand full-face supplied air respirator or SCBA for exposures greater than fifty (50) times the exposure
limit. If exposure is above the IDLH (Immediately Dangerous to Life and Health) or there is the possibility of an
uncontrolled release, or exposure levels are unknown, then use a positive pressure-demand full-face supplied air
respirator with escape bottle or SCBA. Wear a NIOSH/MSHA-approved (or equivalent) full-facepiece airline
respirator in the positive pressure mode with emergency escape provisions.
OTHER
Where splashing is possible, full chemically resistant protective clothing (e.g., acid suit) and boots are required.
Polyvinyl alcohol (PVA); The following materials are acceptable for use as protective clothing: Polyvinyl chloride
(PVC); Neoprene; Nitrile; Viton; Polyurethane; Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Remove contaminated clothing and wash before reuse. For non-
3
fire emergencies, respiratory protection may be necessary and wear appropriate protective clothing to avoid
contact with material.
SECTION IX 鈥? PHYSICAL AND CHEMICAL PROPERTIES
Physical Property Typical Units Text Result Reference
Appearance N/A Dark
Boiling Point F no data
Bulk Density lb/gal no data
Melting Point F no data
Molecular Weight g/mole no data
Octanol/Water N/A no data
Coefficient
pH no data
N/A
0.87 N/A
Specific Gravity
wt % NIL
Solubility In
Water
N/A Little Odor
Odor
ppm no data
Odor Threshold
Vapor Pressure mmHg <0.0001 @ 20 C
Viscosity (F) 150 SUS @ 100 F
Viscosity (C) CsT @ 40 C
% Volatile 17.7
wt %
SECTION IX STABILITY AND REACTIVITY
鈥? STABILITY
Stable
鈥? CONDITIONS TO AVOID
Avoid heat, sparks and open flame.
鈥? INCOMPATIBILITY
Strong oxidizers
鈥? HAZARDOUS DECOMPOSITION PRODUCTS
Combustion may produce carbon monoxide, carbon dioxide and other asphyxiants.
4
鈥? HAZARDOUS POLYMERIZATION
Will not polymerize.
11. ECOLOGICAL INFORMATION
No data available
12. DISPOSAL CONSIDERATIONS
Follow federal, state and local regulations. This material is not a RCRA hazardous waste, if not
contaminated. If material has been "used", RCRA criteria (ignitability, reactivity, corrosivity and
toxicity) must be determined. Do not flush material to drain or storm sewer. Contract to
authorized disposal service.
13. TRANSPORT INFORMATION
Governing Body Mode Proper Shipping Name
DOT Ground Petroleum Lubricating Oil
Governing Body Mode Hazard Class UN/NA No. Label
DOT Ground N/A N/A Not Regulated
14. REGULATORY INFORMATION
Regulatory List Component CAS No.
Title III Classifications Sections 311,312:
鈥? Acute: NO
鈥? Chronic: NO
鈥? Fire: NO
鈥? Reactivity: NO
鈥? Sudden Release of Pressure: NO
5
15. OTHER INFORMATION
Limits for the product- 5mg/m3, Oil Mist Limit, (OSHA PEL/ACGIH TLV) WHMIS Classification:
not controlled. Please refer to the material safety data sheet for complete information
Disclaimer
The information contained herein is accurate and reliable as of the date issued to the best of the manufacturer鈥檚
knowledge. ARGCO doesn鈥檛 warrant or guarantee its accuracy or reliability and shall not be liable for any
loss or damage arising from the use thereof. It is the user鈥檚 responsibility to satisfy itself that the information
offered for its consideration is suitable for its particular use.
END OF MATERIAL SAFETY DATA SHEET
6
|