Material Safety Data Sheet
IDENTIFICATION
Product Number: QMI 529HT Product Name: Die Attach Adhesive
Synonyms: Silver Filled Thermoset Adhesive
INGREDIENT DISCLOSURE
CAS number Name % Potential Hazard
7440-22-4 Silver 60 - 95 argyria (gray discoloration of the skin)
Proprietary Proprietary 鈮? 10 combustible/polymerization
Methacrylates
polymerization
Proprietary Proprietary 鈮? 10
Maleimides
polymerization
Proprietary Proprietary Polymer 鈮?1
TSCA Status: Each of these ingredients are listed, or covered by a low volume exemption under section
5(h)(4).
PHYSICAL AND CHEMICAL PROPERTIES
Vapor Pressure: N/E Density g/ml: 4.15
Water Solubility: Insoluble Boiling Pt 掳C: N/A
Vapor Pressure: Negligible Polymerization Temp: 150掳C
Physical State, Appearance and Odor: A viscous gray paste with mild odor.
FIRE AND EXPLOSION HAZARD DATA
Flash Point 掳F: > 200 掳F
Extinguishing Media: carbon dioxide, dry chemical, water fog
Special Fire Fighting Procedures: Wear self-contained breathing apparatus and protective clothing to
prevent inhalation or contact of combustion products.
Unusual Fire and Explosion Hazards: Hazardous polymerization will not occur.
Rev. A 1 of 3
Product Number: QMI 529HT Product Name: Die Attach Adhesive
REACTIVITY DATA
Material is stable under normal storage and recommended use conditions (-40 掳C, and < 35掳C,
respectively).
Incompatibilities: Strong Oxidizers, acids, bases.
Hazardous Combustion or Decomposition Products: CO2, CO, NOx, and hydrocarbons from incomplete
combustion.
TOXICITY AND HEALTH HAZARD DATA
Potential Routes of Entry: Ingestion, skin and eye exposure.
Is material listed in National Toxicology Program, Third Annual Report on Carcinogens? No
Has the material been found to be a potential carcinogen by the International Agency for Research
on Cancer? No
Acute Effects: May cause eye and skin irritation on contact. Inhalation of fumes evolved during the
product's cure may irritate the respiratory tract. Ingestion may cause irritation to the gastrointestinal
tract.
To the best of our knowledge, the chemical, physical and toxicological properties of this material
have not been thoroughly investigated.
First Aid:
Inhalation - Remove to fresh air and consult a physician. If not breathing give artificial respiration. If
breathing is difficult give oxygen. Call a physician
Eyes - Flush with water for at least 15 minutes and contact a physician.
Skin - Remove contaminated clothing as needed. Wash affected area with soap and water.
Ingestion - Drink large quantities of water. Do not induce vomiting. Contact a physician. Never
give liquids to an unconscious person.
Rev. A 2 of 3
Product Number: QMI 529HT Product Name: Die Attach Adhesive
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Protective equipment: Safety glasses and chemical-resistant gloves
Handling protocols: Good personal hygiene must be maintained. Do not allow eating, smoking, or
drinking in storage or use areas. Avoid ingestion and contact with skin and eyes. Use product in a
well-ventilated area.
Storage conditions: Store at -40掳C until required for use.
SPILL OR LEAK PROCEDURES
Steps to be taken if material is released or spilled:
Small spills: Wipe up spilled material and package in storage drums for disposal.
Large spills: Shovel material in to storage drums for disposal.
Waste disposal method: Destructive Incineration in a permitted facility is the preferred method of
disposal. Observe all federal, state and local laws.
TRANSPORT INFORMATION
DOT/IATA Proper shipping Name Not Regulated
DOT/IATA Packing Group Not Regulated
DOT/IATA Label Not Regulated
DOT/IATA UN Number Not Regulated
REGULATORY INFORMATION
This product contains a toxic chemical(s) subject to the reporting requirements of SARA 313
(40CFR372). Silver
OTHER INFORMATION
The information contained herein relates only to the specific material identified. Loctite Corporation
believes that such information is accurate and reliable as of the date of this material safety data
sheet, but no representation, guarantee or warranty, express or implied, is made as to the accuracy,
reliability, or completeness of the information, Loctite Corporation urges persons receiving this
information to make their own determination as to the information鈥檚 suitability and completeness for
their particular application.
Latest Revision By Bill Wood, Dated 12/15/03
Loctite Corporation
9938 Via Pasar, San Diego, CA 92126
Phone: (858) 695-1716 fax: (858) 695-0951
Rev. A 3 of 3
|