Search    ENTER KEYWORD
MSDS Material Safety Data Sheet
CAS

7440-22-4
28064-14-4
2461-15-6

File Name: fujitsu-nt_com---yihua-_9144-msds.asp
                                                       Yi-Hua Co., Ltd.
MATERIAL SAFETY DATA SHEET NO.3, Lane320, Kao-yang south Rd..
Lungtan Shiang, Taoyuan, Taiwan 325
*PRODUCT NAME:YizBond-9144
*INGREDIENT CODE NUMBER:Not applicable EMERGENCY PHONE�
*HMIS:HEALTH-2 FIRE-1 REACTIVITY-1 China: 020-84921608
*ANSI CODEï¼?3 TAIWANï¼?00-886-3-4719415
*Carcinogen:NTP(No) IARC(No) OSHA(No) DATE ISSUED�12/26/2003
*HMIS and ANSI CODE ratings are estimated by Yi-Hua Co., Ltd.



â…?. IDENTIFICATION & PHYSICAL DATA

PERCENT VOTLATILEï¼? <0.5 VAPOR PRESSUREï¼? NA
BOILING POINTï¼? NA SOLUBILITY IN WATERï¼? Low
VAPOR DENSITYï¼? >Air EVAPORATION RATEï¼? APPEARANCEï¼? Silver Paste SPECIFIC GRAVITYï¼? NA
ODORï¼? Mild



â…?. HAZARDOUS INGREDIENTS

HAZARDOUS INGREDIENTS CAS# WT% TOXICITY DATA
Silver Flake 7440-22-4 <80 See Ingrediend Sheet 310200
Bisphenol F 28064-14-4 <15 See Ingrediend Sheet 708003
2-Ethylhexyl glycidyl ether 2461-15-6 <5 See Ingrediend Sheet 100000

Silver is the only 9114FCA ingredient that requires MSDS reporting per Mass. RTK. Bisphenol F require
reporting according to OSHA Communication Standards,under 29CFR�1910.1200.

â…?. FIRE & EXPLOSION DATA

FLASH POINTï¼? >200F
EXTINGUISHING MEDIA� Dry chemical,foam,carbon dioxide.
UNUSUAL FIRE & EXPLOSION HAZARDSï¼? Avoid fumes liberated by heat.
SPECIAL FIRE FIGHTING PROCEDURESï¼? Wear self contained breathing apparatus and complete personal
protective equipment. Remove all ignition sources. Use a water spray
to cool fire exposed containers.



â…?. REACTIVITY DATA

STABILITYï¼? Stable
HAZARDOUS POLYMERIZATIONï¼? Will not occur.
CONDITIONS TO AVOIDï¼? Excessive heat.
MATERIALS TO AVOIDï¼? Strong oxidizing and reducing agents.
HAZARDOUS DECOMPOSITION Fumes produced when heated to decomposition may include carbon monoxideï¼?
PRODUCTS� carbon dioxide,and nitros oxides.

To the best of our knowledge,the information contained herein is accurate Yi-Hua Co., Ltd., however�
assumes no liability for the accuracy or completeness of the information contained herein. Final
determination of suitability of any material is the sole responsibility of the user. All materials may present
unknown health hazards and should be used with caution. Although certain hazards are described hereinï¼?
we cannot guarantee that these are the only hazards which exist.
â…?. HEALTH HAZARD DATA

EFFECTS OF OVEREXPOSURE
INGESTIONï¼? No specific information available. Contains materials that may be moderately toxic.
INHALATION� No specific information available. Hot vapors could cause headaches,nausea�
dizziness,and respiratory irritation,if inhaled.
SKIN CONTACTï¼? May cause dermatitis in some individuals.
EYE CONTACTï¼? Irritating to the eyes. Can cause injury.
CHRONIC EFFECTS OF No specific information available. See Ingredient Sheets 708003ï¼?301200 and 100000.
OVER EXPOSUREï¼?

EMERGENCY & FIRST AID PROCEDURES
EYE CONTACT� In case of eye contact,flush with water for at least 15 minutes. Get medical attention
immediately.
SKIN CONTACT� In case of skin contact,clean with soap and water. Do not use solvents. Remove
contaminated clothing.
INGESTIONï¼? Get medical attention immediately.
INHALATION� Remove employee to fresh air. If discomfort persists,get medical attention.

â…?. SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE Eliminate ignition sources. Use eye and skin protection. Place leaking
MATERIAL IS SPILLEDï¼? containers in a well ventilated area.
Absorb spillage with inert material and dispose.
WASTE DISPOSAL METHODï¼? Incinerate or use hazardous waste treatment procedures that are in accordance
with federal,state and local regulations.



â…?. SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTIONï¼? Wear a NIOSH approved respirator whenever high level exposure to vapors or mist
is anticipated.
VENTILATIONï¼? Locale exhaust recommended for exposure control.
PROTECTIVE GLOVES� Impervious gloves � neoprene or equivalent. A combination of barrier
cream,applied before exposure,and gloves is recommended. Do not apply cream
after exposure.
EYE PROTECTIONï¼? Chemical splash goggles recommended where applicable.
OTHER PROTECTIVE For operations where contact can occur,use a face shield and impervious apron.
EQUIPMENTï¼? A safety shower and eye wash facility should be available.



â…?. SPECIAL PRECAUTIONSï¼?
Avoid contact with skin and eyes. Avoid breathing vapors. Keep containers closed when not in use. Remove
all contaminated clothing immediately and wash. Wash skin thoroughly with soap and water after handling.
Solvents should not be used to clean skin because of increased penetration potential.
REGULATORY INFORMATION
PRODUCT NAMEï¼? YizBond 9144
DATE ISSUEDï¼? 12/26/2003



1. SARA TITLE III SECTION 313 SUPPLIER NOTIFICATION

This product contains the following toxic chemicals subject to the reporting requirements of Section 313
of the Emergency Planning and Community Right to know Act of 1986 (40 CFR 372):None

2. TSCA Inventory Status

All the components of this product are listed on the TSCA Inventory.

3. RCRA Status

This product contains the following chemicals listed on the 40 CFR part 261.33:None

4. CERCLA Status

This product contains the following chemicals listed on the 40 CFR part 302.4:None

5. Transportation
DOT / IATA Shipping Nameï¼? Not Regulated (Up to 300ml cartridges)
Hazard Classï¼? None
Marine Pollutantï¼? None
ID Numberï¼? None
Transport Label(s)� Environmentally hazardous substance,solid,N.O.S.




The information contained herein is given in good faith. However,no guarantee or warranty of any kind
expressed or implied is made with respect to this information.

Search    ENTER KEYWORD
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP
NAMECAS
fff_saint-gobain_com---op_series_msds.asp N/A
fiberwrap_com---tyfo_fca__msds.asp N/A
fiberwrap_com---tyfo_fcb_msds.asp N/A
fiberwrap_com---tyfo_sa_msds.asp N/A
fiberwrap_com---tyfo_sb_msds.asp N/A
firth_co_nz---firth_handicrete_28aug07.asp 2007-08-2
firth_co_nz---firth_mortar_plaster_28aug07.asp 2007-08-2
firth_co_nz---msds_concrete_dec_05.asp 65997-15-1 14-12-0
firth_co_nz---msds_handicrete_mar_06.asp 2005-09-2
firth_co_nz---msds_mortarplaster_mar_06.asp 2005-09-2
fujifilmsericol_com_au---serijetsj.asp N/A
fujitsu-nt_com---3m-cover_tape-msds.asp N/A
fujitsu-nt_com---ablestik-8340-msds.asp 7440-22-4
fujitsu-nt_com---acme-ecr-msds.asp 9003-55-8 1333-86-4
fujitsu-nt_com---acme-tube_pvc-msds.asp N/A
fujitsu-nt_com---asm_-_lead_frame-msds.asp N/A
fujitsu-nt_com---avery-label-msds.asp N/A
fujitsu-nt_com---cheil-sl7300hx-msds.asp 82-31-4 60676-86-0 14464-46-1 1309-64-4 1333-86-4
fujitsu-nt_com---fusheng-c151_lead_frame-msds.asp 0242-22-7
fujitsu-nt_com---henkel-qmi3555r-msds.asp 7440-22-4 20667-12-3 1309-60-0 1314-62-1 7446-07-3 7439-92-1
fujitsu-nt_com---henkel-qmi_529ht-msds.asp 7440-22-4
fujitsu-nt_com---heraeus-au_wirehd-msds.asp N/A
fujitsu-nt_com---hipec-q14939-msds.asp N/A
fujitsu-nt_com---hitachi-a42_lead_frame-msds.asp N/A
fujitsu-nt_com---hitachi-cel9210hf-msds.asp N/A
fujitsu-nt_com---hitachi-mf202_lead_frame-msds.asp N/A
fujitsu-nt_com---hwayeon-tube-msds.asp 86-21-5
fujitsu-nt_com---jh-c194-msds.asp N/A
fujitsu-nt_com---lead_lock_tape-r970a-msds.asp N/A
fujitsu-nt_com---mth-lead_frame-msds.asp N/A
fujitsu-nt_com---nfme-pure_sn_plating-msds.asp N/A
fujitsu-nt_com---qpl-_cu_with_ag_plate-msds.asp 7440-50-8 7439-89-6 7440-21-3 7439-96-5 7440-02-0 7440-67-7 7723-14-0 7440-66-6 7439-95-4 7439-92-1 7440-47-3 7440-48-8 7440-31-5 7429-90-5 7440-22-4 9003-18-3 79922-55-7 28453-20-5
fujitsu-nt_com---shinon-tray-msds.asp N/A
fujitsu-nt_com---tanaka-al_wire-msds.asp 952-53-2 952-52-6 7429-90-5
fujitsu-nt_com---tanaka-au_wire-msds.asp 952-53-2 952-52-6 7440-57-5
fujitsu-nt_com---winifred-_shielding_bag-msds.asp N/A
fujitsu-nt_com---yihua-_9144-msds.asp 7440-22-4 28064-14-4 2461-15-6
fujitsu-nt_com---yonghong-lead_frame-msds.asp N/A
galmet_com_au---blue_plus_aerosol_msds.asp 64742-88-7 108-88-3 64742-95-6 115-10-6
galmet_com_au---cold_galvanizing_aerosol_msds.asp 115-10-6 108-88-3 64742-95-6 1302-78-9
galmet_com_au---cold_galvanizing_msds.asp 64742-95-6
galmet_com_au---duragal_aerosol_msds.asp 115-10-6 108-88-3 64742-95-6 123-86-4
galmet_com_au---duragal_msds.asp 1330-20-7 64742-95-6 64742-88-7
galmet_com_au---enamel_spray_thinner_300c_msds.asp 64742-95-6
galmet_com_au---etch_thinner_500e_msds.asp 78-93-3
galmet_com_au---fence_gutter_and_facia_aerosol_msds.asp 115-10-6 108-88-3 1330-20-7 123-86-4 141-78-6
galmet_com_au---gloss_shield_clear_gloss_rejuvenator_msds.asp 34590-94-8
galmet_com_au---hammered_metal_finish_aerosol_msds.asp 108-88-3 1330-20-7 67-64-1 115-10-6
galmet_com_au---hammered_metal_finish_msds.asp 64742-82-1
galmet_com_au---industrial_primer_msds.asp 64742-82-1 64742-95-6

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com | Ads link:HBCCHEM.INC