Search    ENTER KEYWORD
MSDS Material Safety Data Sheet
CAS

115-10-6
75-28-5
74-98-6
110-54-3

File Name: clearcoproducts_com---msds-600.asp
                                                                    MATERIAL SAFETY DATA SHEET



MANUFACTURED FOR: PREPARATION DATE: 01/18/02nc

CLEARCO PRODUCTS CO. PREPARED BY:
3430-G PROGRESS DR
BENSALEM, PA. 19020 EMERGENCY PHONE #:
Telephone: 1 (800) 533 5823 CHEM-TEL: 1 (800) 255 3924
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
HAZARD RATING

Health-2 Reactivity-1 Flammability-4 Special Hazard-Unk
--------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION I - GENERAL INFORMATION
Trade Name & Syn... CLEARCO MIST ADHESIVE SPRAY 600
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION II - INGREDIENTS

INGREDIENT % Weight CAS Skin
DESCRIPTION Number TLV TLV TLV Desig- Carcinog SARA
TWA STEL Ceiling nation mmHg en 313

Dimethyl Ether 15% 115-10-6 1000 ppm. No Info No Info NO 4039.0 NO NO

Isobutane 10% 75-28-5 800 ppm. No Info No Info NO 1603.2 NO NO

Propane 10% 74-98-6 1000 ppm. No Info No Info NO 5688.6 NO NO

Hexane 50% 110-54-3 50 ppm. No Info No Info NO 125.0 NO NO



-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION III - PHYSICAL DATA

-44- 500?F
Boiling Point (F).............
Vapor Density (Air=1)......... Above 1.0
Product Density............... 5.8 lbs./gal (U.S.)
Solubility.................... Negligible
Evaporation Rate ............. Is faster than Butyl Acetate
Volatile by Weight............ 82.2%
Volatile by Volume............ 87.8%
Appearance ................... White Liquid
Odor.......................... Mint when wet
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION IV - FIRE AND EXPLOSION HAZARD DATA

FLAMMABILITY CLASSIFICATION:

-156?F
Flash Point .................... LEL: 1.0% UEL: 18.0%
(Pensky-Martens Closed Cup)

OSHA - FLAMMABLE LIQUID - CLASS 1A
DOT - CONSUMER COMMODITY ORM-D

Extinguishing Media......................Water Fog Dry Chemical Carbon Dioxide Foam
Unusual Fire & Explosion Hazards.............Vapors are heavier than air and travel along the ground or may be moved by ventilation and ignited by
ignition sources at locations distant from material handling point. All 5 gal pails and larger should be grounded and/or bonded during material transferal.
For aerosol products - exposure to temperatures over 130?F may cause containers to burst, releasing highly flammable gas.
Special Fire-fighting Procedures...........Wear self-contained breathing apparatus with a full face-piece operated in pressure-demand or other positive
pressure mode when fighting fires.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION V - HEALTH HAZARD DATA

Effects of Over Exposure....Eye contact: can cause severe irritation, redness, tearing, blurred vision. Skin Contact: Prolonged or repeated contact can
cause moderate irritation de-fatting, dermatitis. Inhalation: Excessive inhalation of vapors can cause nasal and respiratory irritation, dizziness, weakness,
fatigue, nausea, headache, possible unconsciousness, and even asphyxiation. Overexposure may cause damage to the nervous system.
Medical Conditions Prone to Aggravation by Exposure: Central Nervous System Disorders.
Primary Routes of Entry: Inhalation Dermal

Emergency and First Aid Procedures: Skin contact: Thoroughly wash exposed area with soap and water. Remove contaminated clothing. Launder
contaminated clothing before re-use. Get medical attention if irritation persists. Eye Contact: Flush with large amount of water, lifting upper and lower
lids occasionally, get medical attention. Ingestion: Do not induce vomiting. Give two glasses of water if conscious. Never give anything by mouth to an
unconscious person. Get immediate medical attention. Inhalation: Remove individual to fresh air. If breathing is difficult, administer oxygen. Give
artificial respiration if breathing has stopped. Keep person warm, quiet. Get medical attention.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VI - REACTIVITY DATA

Stability This product is stable under normal storage conditions
Hazardous Polymerization Will Not occur under normal storage conditions
Hazardous Decomposition Products: Carbon Monoxide and Carbon Dioxide. Various Hydrocarbons
Conditions to Avoid Heat, Sparks, Flame, Red Hot Metal
Incompatibilities Oxidizing Agents, Reducing Agents
Bromide.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VII - SPILL OR LEAK PROCEDURES

Steps to be taken in case Material is Released or Spilled: Eliminate sources of ignition & ventilated area. Persons not properly equipped should be
excluded from area. Stop spill at source - prevent spreading. Avoid Inhalation of vapors. Avoid skin contact with liquid. Soak up on absorbent material
and place into container for disposal. Use plastic scoops for flammable materials.

Waste Disposal Method: Dispose of in accordance with all local, state and federal regulations.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VIII - SAFE HANDLING AND USE INFORMATION

Respirator Protection If workplace exposure limits of product or any component is exceeded, a NIOSH/MSHA approved air supplied respirator is
advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators (Negative Pressure Type) under
specified conditions. See your safety equipment supplier. Engineering or administrative controls should be implemented to reduce exposure.
Ventilation: Provide sufficient mechanical ventilation (General and/or local exhaust)
Ventilation to Maintain Exposure Below TLV(s):
Protective Gloves Wear resistant gloves such as: PVC/NITRILE, NEOPRENE
Eye Protection OSHA approved chemical splash goggles are advised, however, OSHA regulations also permit other type safety glasses. (Consult
your safety equipment supplier)
Other Protective Equipment: To prevent repeated or prolonged skin contact, wear impervious clothing and boots.
Hygienic Work Practices Wash hands before eating or smoking. Smoke in designated areas only. Remove and launder clothing.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION IX - SPECIAL PRECAUTIONS

Precautions to be Taken in Handling and Storage: It is recommended that this material be stored in a cool, dry, ventilated area. Keep away from heat
sources, open flame, sparks. Do not store above 120?F. Do not store in direct sunlight. Do not transfer to unmarked containers. Keep from reach of
children. Do not puncture, incinerate, or place aerosol product containers in compactors.

Other Precautions: Containers of this material may be hazardous when emptied, since containers retain product residues (vapor, liquid, and/or solid).
All hazard precautions given must be observed. Do not flame cut, braze, or use welding torch. Intentional misuse by deliberately concentrating and
inhaling this product may be harmful or fatal.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION X - SHIPPING HAZARD DATA

HM-181 DOT Proper Shipping Name Consumer Commodity IATA Proper Shipping Name Aerosols, Flammable N.O.S.
HM-181 DOT Hazard Classification ORM-D IATA Class or Division 2
HM-181 United Nations Number None IATA Subsidiary Risk 3
HM-181 Label(s) Required None IATA Hazard Labels (2) Flammable Gas
DOT Emergency Response Guide Number 12 United Nations Number 1950

National Motor Freight Class Compounds, Lubricating #50303, Class 55
-------------------------------------------------------------------------------------------------------------------------------------------------------------------
DISCLAIMER

The information on this data sheet represents our current data and is believed to be accurate but is not warranted whether originating with the company or
not. Any use of this product which is not in conformance with this data sheet or which involves the use of this product in combination with any other
product or any other process is the responsibility of the user.

Search    ENTER KEYWORD
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP
NAMECAS
chemmasters_net---safecureseal20.asp N/A
chemmasters_net---safeseal.asp N/A
chemmasters_net---safeslip.asp N/A
chemmasters_net---safeslipconcentrate.asp 64741-88-4 67784-80-9
chemmasters_net---safethane.asp 111-77-3 872-50-4 7732-18-5
chemmasters_net---silencure.asp N/A
chemmasters_net---skiddaddle.asp 5989-27-5 25498-49-1 68439-45-2 27176-87-0 102-71-6 64-02-8 7732-18-5
chemmasters_net---spallguard40.asp N/A
chemmasters_net---spallguardwb10.asp 7732-18-5
chemmasters_net---speedpatch.asp 14808-60-7
chemmasters_net---speedpatchhw.asp 14808-60-7
chemmasters_net---spray-cure___seal_25a.asp N/A
chemmasters_net---spraycurecleardrwreddye07.asp 8052-41-3 95-63-6 108-87-8
chemmasters_net---spraycureseal25.asp N/A
chemmasters_net---spraycuresealplus.asp 64742-88-7 64742-95-6
chemmasters_net---sprayfilm.asp 7732-18-5 681155-00-0 106-14-9
chemmasters_net---sprayfilm_tds.asp N/A
chemmasters_net---surelockwb05.asp 7732-18-5 111-76-2
chemmasters_net---texturedii.asp 14808-60-7 7732-18-5 13463-67-7 14567-73-8 14807-96-6 107-21-1
chemmasters_net---texturedot.asp 14808-60-7 7732-18-5 13463-67-7 14567-73-8 14807-96-6 111-76-2 112-34-5
chemmasters_net---traz25.asp 64742-95-6 28262-63-7
chemmasters_net---traz_25-a.asp N/A
chemmasters_net---traz_25.asp N/A
chymeragroup_com---rst5_msds.asp N/A
clearcoproducts_com---msds-285.asp 9003-13-8
clearcoproducts_com---msds-444.asp 67-64-1 110-54-3 75-28-5 74-98-6
clearcoproducts_com---msds-600.asp 115-10-6 75-28-5 74-98-6 110-54-3
clearcoproducts_com---msds-877.asp 110-54-3 74-98-6 115-10-6 110-82-7 67-64-1
clearcoproducts_com---msds-clearslip2m.asp 64742-47-8 63148-62-9
clearcoproducts_com---msds-psf-10cs.asp 63148-62-9
clearcoproducts_com---msds-psf-20cs.asp 63148-62-9
clearcoproducts_com---msds-psf-5cs.asp 63148-62-9
clearcoproducts_com---msds-psf-hi-viscosity.asp 63148-62-9
clearcoproducts_com---msds_110_high_temp.asp N/A
clearcoproducts_com---msds_125_high_temp.asp N/A
clearcoproducts_com---np-silver_zinc_primer_70.asp N/A
clearcoproducts_com---np-zinc_rich_primer.asp N/A
coatingkare_com---msds-3100-spot-remover.asp 68081-81-2 111-76-2
coatingsolutions_saint-gobain_com---9217_&_9271_msds_16.asp 13-04-2 9004-34-6
coatingsolutions_saint-gobain_com---ekonol_msds.asp 26099-71-8
coatingsolutions_saint-gobain_com---msds_cordon_corindon_noir_50_diam._475mm_a.asp 1344-28-1 1318-23-6 13463-67-7 102-71-6
coatingsolutions_saint-gobain_com---ruby_msds_16.asp 13-04-2 1344-28-1
conklin_com---1529.msds.asp 1330-20-7 67-56-1 75-28-5 74-98-6
conklin_com---36616-6.msds.asp N/A
conklin_com---37465.msds.asp 112-34-5 75-21-8 57-55-6 102-71-6 111-42-2
coulter_com---477436ac.asp N/A
coulter_com---819247aa.asp 1314-13-2 64742-52-5
coulter_com---a07793aa.asp 26628-22-8
coulter_com---im0846aa.asp N/A
coulter_com---im1167aa.asp N/A

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com | Ads link:HBCCHEM.INC