Material Safety Data Sheet
CONKLIN COMPANY, INC.
Date Prepared: February 27, 2001 MSDS Number: 5022
SECTION 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Identifier General Use
Pre-Waush Laundry stain removal
Manufacturer鈥檚 Name Emergency Telephone Number
Conklin Company (800) 228-5635
Address (Number, Street, City, State, ZIP) Phone Number for Additional Information
551 Valley Park Drive (952) 445-6010
Shakopee, MN 55379
SECTION 2 - COMPOSITION/INFORMATION ON INGREDIENTS
COMPONENT CAS # (% by wt.)
CHEMICAL INGREDIENTS
Butyl Carbitol 112-34-5 5%
Ethylene Oxide 75-21-8 <1%
Propylene Glycol 57-55-6 12%
Triethanolamine 102-71-6 4%
Diethanolamine 111-42-2 < .5%
See Section 8 for exposure guidelines
SECTION 3 - HAZARDS IDENTIFICATION
Emergency Overview
May cause eye irritation
HMIS: Health 2 Flammability 1 Reactivity 0
Potential Health Effects
EYE: Moderate eye irritant
SKIN CONTACT: May be slight skin irritant
INGESTION: Moderately toxic by ingestion
INHALATION: Expected to be a low inhalation hazard
Date Prepared: February 27, 2001 Page: 2 of 4
MSDS Number: 5022
CHRONIC EFFECTS/CARCINOGENICITY: May contain traces of Ethylene oxide. The trace amounts
are not expected to result in either acute or chronic health hazard. You should be aware that ETO is
a cancer and reproductive hazard.
SECTION 4 - FIRST AID MEASURES
EYES: Flush with water for at least 15 minutes. If irritation persists, see a Physician.
SKIN: If skin irritated flush with plenty of water.
INGESTION: Do not induce vomiting unless at direction of a Physician or Poison Control Center.
Never give anything by mouth to an unconscious person.
INHALATION: Remove individual to fresh air. If condition persists, get medical attention.
SECTION 5 - FIRE FIGHTING MEASURES
FLASH POINT: Over 2000 F, PMCC
EXTINGUISHING MEDIA: CO2, Dry chemical, Foam
SPECIAL FIRE FIGHTING PROCEDURES: Wear self -contained breathing Apparatus in positive
pressure demand mode.
SECTION 6 - ACCIDENTAL RELEASE MEASURES
SPILL OR LEAK PROCEDURE Dike and contain. Remove with vacuum tracks or pump to
storage/salvage vessels. Soak up residue with absorbent.
SECTION 7 - HANDLING AND STORAGE
STORAGE TEMPERATURE: Store at room temperature
HANDLING AND STORAGE PRECAUTIONS: Store in cool dry place with adequate ventilation
SECTION 8 - PERSONAL PROTECTION/EXPOSURE CONTROLS
EYE PROTECTION REQUIREMENTS: Wear eye protection in an industrial environment when
handling large quantities.
SKIN PROTECTION REQUIREMENTS: Wear gloves in Industrial environment.
RESPIRATORY PROTECTION: Wear approved NIOSH respirator if PEL, TWA exceeded. If
Ethylene Oxide exceeds 1 ppm, a respirator is required.
Date Prepared: February 27, 2001 Page: 3 of 4
MSDS Number: 5022
OSHA ACGIH
COMPONENTS PEL/TWA TLV/TWA STEL
5mg/M3
Triethanolamine
Diethanolamine .46 PPM
PEL = Permissible Exposure Limit
TLV = Threshold Limit Value
TWA = Time-weighted average (8 hour day)
STEL = Short term exposure limit (15 minutes), no more than 60 min./day
(CL) = Ceiling (not to be exceeded under any condition)
(s) = Skin
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL FORM liquid SOLUBILITY IN WATER: Soluble
COLOR: Yellow to Amber SPECIFIC GRAVITY (Water = 1):
ODOR: Pleasant EVAPORATION RATE (Butyl Acetate = 1): >1
BOILING POINT: VAPOR PRESSURE (mm Hg): NA
MELT POINT: VAPOR DENSITY (Air = 1): NA
pH: 8.16 DENSITY: 8.376 lb/gal
SECTION 10 - REACTIVITY
STABILITY: Stable
INCOMPATIBILITIES: Oxidizers
DECOMPOSITION PRODUCTS: Carbon monoxide
Date Prepared: February 27, 2001 Page: 4 of 4
MSDS Number: 5022
SECTION 11 - TOXICOLOGICAL INFORMATION
SECTION 12 - ECOLOGICAL INFORMATION
This product does not contain nor was it directly manufactured with any class I or class II ozone
depicting substances
SECTION 13 - DISPOSAL CONSIDERATIONS
Waste Disposal Method: According to federal, state and local regulations.
SECTION 14 - TRANSPORTATION INFORMATION
Not regulated as a DOT Hazardous Material
SECTION 15 - REGULATORY INFORMATION
Chemicals in this product are listed on the EPA/TSCA inventory of chemical substances
SECTION 16 - OTHER INFORMATION
This MSDS replaces the June 19, 1995 version. This version was revised for flash point and phone
number information only.
The information contained in this Material Safety Data Sheet is based on data available to us and is
believed to be true and correct; however, Conklin makes no warranty, express or implied, regarding the
accuracy of this data or results obtained from the use of this product. Conklin and its employees
assume no responsibility for injury or damage from the use of this product.
|