**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| Not available |2,3,3-Trichlorotetrahydrofuran | 98 | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Moisture
sensitive.The toxicological properties of this material have not been
fully investigated.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
Causes respiratory tract irritation. The toxicological properties of
this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Vapors may be heavier
than air. They can spread along the ground and collect in low or
confined areas. Containers may explode when heated.
Extinguishing Media:
Do NOT get water inside containers. Use water spray, dry chemical,
carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Provide
ventilation. Do not get water inside containers.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation. Use with adequate ventilation. Do not allow
contact with water. Wash clothing before reuse. Keep from contact
with moist air and steam.
Storage:
Store in a cool, dry place. Keep container closed when not in use.
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from moisture.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low. Use process
enclosure, local exhaust ventilation, or other engineering controls
to control airborne levels.
Exposure Limits
CAS# 0-00-1:
Personal Protective Equipment
Eyes:
Wear chemical splash goggles.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear almost colorless
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 66 deg C @ 11 mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: >160 deg C
Solubility in water: insoluble
Specific Gravity/Density: 1.4800g/cm3
Molecular Formula: C4H5Cl3O
Molecular Weight: 175.44
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Moisture, excess heat.
Incompatibilities with Other Materials:
Moisture, strong oxidizing agents.
Hazardous Decomposition Products:
Hydrogen chloride, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, chlorine.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 0-00-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
2,3,3-Trichlorotetrahydrofuran -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 0-00-1: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 0-00-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 0-00-1 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #7 Date: 4/27/2005
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
1-Methyl-2-pyrrolidinone, 99+%, spectrophotometric grade
| 872-50-4 |
|
1-Methyl-2-pyrrolidinone, 99%
| 872-50-4 |
|
Sodium Iodide, 99.999%
| 7681-82-5 |
|
Guanidine Hydrochloride, 99% (Contains 0.2-0.4% SiO2 as Anti-Caking
| 50-01-1 |
|
Guanidine Hydrochloride, 98%
| 50-01-1 |
|
Phenoxy resin, average m.w. 70000
| 26402-79-9 |
|
N,N-Dimethylbenzylamine, 98%
| 103-83-3 |
|
N,N-Dimethylformamide, 99%
| 68-12-2 |
|
2-Methylbutane, 99+%
| 78-78-4 |
|
2-Methylbutane, 99+%, spectrophotometric grade
| 78-78-4 |
|
N,N-Dimethylformamide, P.A.
| 68-12-2 |
|
Polyethyleneglycol 300 Monononylether (Fractionated, Fraction 5)
| 39587-22-9 |
|
Polyethyleneglycol 300 Monooctylether
| 27252-75-1 |
|
Polyethyleneglycol 300 Monooctylether (Fractionated, Fraction 2)
| 27252-75-1 |
|
6-Ketocholestanol, 99%
| 1175-06-0 |
|
Polyethyleneglycol 300 monooctylether (Fractionated, Fraction 5)
| 27252-75-1 |
|
Dicyandiamide, 99.5%
| 461-58-5 |
|
Nitrazine Yellow, Indicator Grade
| 5423-07-4 |
|
Polyethyleneglycol 400 Monooctylether
| 27252-75-1 |
|
Polyethyleneglycol 600 Monooctylether
| 27252-75-1 |
|
N,N-Dimethylformamide for HPLC
| 68-12-2 |
|
N,N-Dimethylformamide, Reagent ACS
| 68-12-2 |
|
N,N-Dimethylformamide, Nonaqueous Titration Grade, 99+% (GC)
| 68-12-2 |
|
2-Isonitrosoacetophenone, 99%
| 532-54-7 |
|
N,N-Dimethylformamide, Reagent ACS, Spectro Grade, 99.8% (GC)
| 68-12-2 |
|
N,N-Dimethylformamide, 99+% Spectrophotometric Grade
| 68-12-2 |
|
R(+)-alpha-methylbenzyl isocyanate, 95%
| 33375-06-3 |
|
s-(-)-1-Phenylethylamine, 98% (uv-vis)
| 2627-86-3 |
|
r-(+)-1-Phenylethylamine, 98% (uv-vis)
| 3886-69-9 |
|
1,4-Dichlorobutane, 99+%
| 110-56-5 |
|
(-)-Taddol, 98%, (99% e.e.)
| 93379-48-7 |
|
3-Methyltetrahydrofuran, 99%
| 13423-15-9 |
|
Merrifield's peptide resin, 2% cross- linked, 2-2.5 meq cl/g, 200-400
| 9036-15-1 |
|
Cyclohexanone, 99.8%
| 108-94-1 |
|
1-Bromo-3-chloropropane, p.a.
| 109-70-6 |
|
2-Octenoic acid, 90-95% trans
| 1871-67-6 |
|
Fluorene (Techn), 90% (UV-Vis)
| 86-73-7 |
|
Chrysene, 98%
| 218-01-9 |
|
Aluminum chloride hexahydrate, 99%
| 7784-13-6 |
|
Carmine certified alum lake
| 1390-65-4 |
|
Carmine, high purity biological stain, (alum lake of carminic
| 1390-65-4 |
|
Trichlorovinylsilane, 96%
| 75-94-5 |
|
p-Xylene, 99%
| 106-42-3 |
|
p-Xylene, scintillation grade, 99%
| 106-42-3 |
|
Cyclooctanemethanol, 97%
| 3637-63-6 |
|
m-Xylene, spectro grade
| 108-38-3 |
|
2,3,3-Trichlorotetrahydrofuran, 98%
| 0-00-1 |
|
4-Chloro-1-(2,5-Dimethylphenyl)-1-Butanone
| 71526-84-6 |
|
4-Chloro-1-(2,4-Dimethylphenyl)-1-Butanone
| 74298-65-0 |
|
Fast Green FCF, High Purity Biological Stain
| 2353-45-9 |
|
|