Search   
MSDS 
:
 Polyethyleneglycol 300 monooctylether (Fractionated, Fraction 5)
CAS 
:
 27252-75-1
SYNONYMS 
:
 None.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 27252-75-1 |Polyethyleneglycol 300 Monooctylether | ca 100. | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 19 36/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
May form explosive peroxides. Irritating to eyes and skin.The
toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation. The toxicological properties of this
material have not been fully investigated.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. May form explosive
peroxides. Vapors may be heavier than air. They can spread along
the ground and collect in low or confined areas. Containers may
explode when heated.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with
flooding quantities of water until well after fire is out. Use water
spray, dry chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Isolate
area and deny entry. Provide ventilation. Place under an inert
atmosphere.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Remove contaminated clothing and wash before reuse. Use with
adequate ventilation. Avoid contact with skin and eyes. Keep
container tightly closed. Avoid ingestion and inhalation. If
peroxide formation is suspected, do not open or move container. Avoid
contact with air and sunlight. Unused chemicals should not be
returned to the container. Do not distill since this removes
peroxide-inhibitors.
Storage:
Do not store in direct sunlight. Store in a cool, dry,
well-ventilated area away from incompatible substances. Deep freeze
(below -20C). Regularly check inhibitor levels to maintain peroxide
levels below 1%. Do not break the seal on the container until it is
needed. Label the container with the date it was first opened.
Long-term storage is not recommended.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use explosion-proof ventilation equipment. Use adequate ventilation
to keep airborne concentrations low.
Exposure Limits
CAS# 27252-75-1:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: almost colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 90 - 230 deg C @ .30mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 176 deg C ( 348.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: soluble
Specific Gravity/Density: .9640g/cm3
Molecular Formula:
Molecular Weight:

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
On long term storage, substances with similar functional groups form
explosive peroxides. Explosive peroxides may form on concentration.
Peroxides can be detonated by friction, impact, or heating. Tends to
form explosive peroxides; especially when anhydrous. Peroxide
formation may occur in containers that have been opened and remain
in storage.
Conditions to Avoid:
Incompatible materials, exposure to air, strong oxidants.
Incompatibilities with Other Materials:
Strong bases, strong acids, strong oxidizing agents, strong reducing
agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 27252-75-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Polyethyleneglycol 300 Monooctylether -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 19 May form explosive peroxides.
R 36/38 Irritating to eyes and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 37/39 Wear suitable gloves and eye/face
protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 27252-75-1: 2
Canada
CAS# 27252-75-1 is listed on Canada's DSL List.
CAS# 27252-75-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 27252-75-1 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 2/19/1999 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
1-Methyl-2-pyrrolidinone, 99+%, spectrophotometric grade 872-50-4
1-Methyl-2-pyrrolidinone, 99% 872-50-4
Sodium Iodide, 99.999% 7681-82-5
Guanidine Hydrochloride, 99% (Contains 0.2-0.4% SiO2 as Anti-Caking 50-01-1
Guanidine Hydrochloride, 98% 50-01-1
Phenoxy resin, average m.w. 70000 26402-79-9
N,N-Dimethylbenzylamine, 98% 103-83-3
N,N-Dimethylformamide, 99% 68-12-2
2-Methylbutane, 99+% 78-78-4
2-Methylbutane, 99+%, spectrophotometric grade 78-78-4
N,N-Dimethylformamide, P.A. 68-12-2
Polyethyleneglycol 300 Monononylether (Fractionated, Fraction 5) 39587-22-9
Polyethyleneglycol 300 Monooctylether 27252-75-1
Polyethyleneglycol 300 Monooctylether (Fractionated, Fraction 2) 27252-75-1
6-Ketocholestanol, 99% 1175-06-0
Polyethyleneglycol 300 monooctylether (Fractionated, Fraction 5) 27252-75-1
Dicyandiamide, 99.5% 461-58-5
Nitrazine Yellow, Indicator Grade 5423-07-4
Polyethyleneglycol 400 Monooctylether 27252-75-1
Polyethyleneglycol 600 Monooctylether 27252-75-1
N,N-Dimethylformamide for HPLC 68-12-2
N,N-Dimethylformamide, Reagent ACS 68-12-2
N,N-Dimethylformamide, Nonaqueous Titration Grade, 99+% (GC) 68-12-2
2-Isonitrosoacetophenone, 99% 532-54-7
N,N-Dimethylformamide, Reagent ACS, Spectro Grade, 99.8% (GC) 68-12-2
N,N-Dimethylformamide, 99+% Spectrophotometric Grade 68-12-2
R(+)-alpha-methylbenzyl isocyanate, 95% 33375-06-3
s-(-)-1-Phenylethylamine, 98% (uv-vis) 2627-86-3
r-(+)-1-Phenylethylamine, 98% (uv-vis) 3886-69-9
1,4-Dichlorobutane, 99+% 110-56-5
(-)-Taddol, 98%, (99% e.e.) 93379-48-7
3-Methyltetrahydrofuran, 99% 13423-15-9
Merrifield's peptide resin, 2% cross- linked, 2-2.5 meq cl/g, 200-400 9036-15-1
Cyclohexanone, 99.8% 108-94-1
1-Bromo-3-chloropropane, p.a. 109-70-6
2-Octenoic acid, 90-95% trans 1871-67-6
Fluorene (Techn), 90% (UV-Vis) 86-73-7
Chrysene, 98% 218-01-9
Aluminum chloride hexahydrate, 99% 7784-13-6
Carmine certified alum lake 1390-65-4
Carmine, high purity biological stain, (alum lake of carminic 1390-65-4
Trichlorovinylsilane, 96% 75-94-5
p-Xylene, 99% 106-42-3
p-Xylene, scintillation grade, 99% 106-42-3
Cyclooctanemethanol, 97% 3637-63-6
m-Xylene, spectro grade 108-38-3
2,3,3-Trichlorotetrahydrofuran, 98% 0-00-1
4-Chloro-1-(2,5-Dimethylphenyl)-1-Butanone 71526-84-6
4-Chloro-1-(2,4-Dimethylphenyl)-1-Butanone 74298-65-0
Fast Green FCF, High Purity Biological Stain 2353-45-9

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net