Search   
MSDS 
:
 4-Picoline, 98%
CAS 
:
 108-89-4
SYNONYMS 
:
 2-Methylpyridine
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 108-89-4 |4-Picoline | 99+ | 203-626-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: T
Risk Phrases: 10 20/22 24 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Flammable. Harmful by inhalation and if swallowed. Toxic in contact
with skin. Irritating to eyes, respiratory system and
skin.Hygroscopic (absorbs moisture from the air).

Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis and
corneal damage.
Skin:
Causes skin irritation. Harmful if absorbed through the skin. May
cause reddening of the skin. May cause skin rash and eruptions.
Substance is readily absorbed through the skin. May cause cyanosis
of the extremities.
Ingestion:
May cause irritation of the digestive tract. Ingestion of large
amounts may cause CNS depression. Intoxication may include weight
loss, diarrhea, weakness, ataxia (failure of muscular coordination),
and unconsciousness.
Inhalation:
Causes irritation of mucous membrane. Aspiration may lead to
pulmonary edema. Vapors may cause dizziness or suffocation. Exposure
may give rise to flushing of face, skin rash, an increase in heart
and respiration rates, headaches, giddiness, nausea, and vomiting.
May cause burning sensation in the chest.
Chronic:
May cause liver and kidney damage. Effects may be delayed.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Immediately flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid immediately. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If breathing
is difficult, give oxygen. Get medical aid. Do not use mouth-to-mouth
resuscitation if victim ingested or inhaled the substance; induce
artificial respiration with the aid of a pocket mask equipped with a
one-way valve or other proper respiratory medical device.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. During a
fire, irritating and highly toxic gases may be generated by thermal
decomposition or combustion. Will burn if involved in a fire. Use
water spray to keep fire-exposed containers cool. Containers may
explode in the heat of a fire. Flammable liquid and vapor. Vapors
may be heavier than air. They can spread along the ground and
collect in low or confined areas.
Extinguishing Media:
Use water spray to cool fire-exposed containers. Water may be
ineffective. Do NOT get water inside containers. Do NOT use straight
streams of water. For large fires, use water spray, fog or regular
foam. For small fires, use dry chemical, carbon dioxide, water spray
or regular foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Remove all sources of ignition. Use
a spark-proof tool. Do not get water inside containers. A vapor
suppressing foam may be used to reduce vapors.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Ground and bond containers when transferring material. Use
spark-proof tools and explosion proof equipment. Avoid contact with
eyes, skin, and clothing. Empty containers retain product residue,
(liquid and/or vapor), and can be dangerous. Keep away from heat,
sparks and flame. Avoid ingestion and inhalation. Do not pressurize,
cut, weld, braze, solder, drill, grind, or expose empty containers
to heat, sparks or open flames. Keep from contact with moist air and
steam.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
Flammables-area. Store protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate general or
local explosion-proof ventilation to keep airborne levels to
acceptable levels.
Exposure Limits
CAS# 108-89-4:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: slight clear yellow
Odor: disagreeable odor
pH: Not available.
Vapor Pressure: 5.77 mm Hg @25C
Viscosity: Not available.
Boiling Point: 144 deg C
Freezing/Melting Point: 3.6 deg C
Autoignition Temperature: 500 deg C ( 932.00 deg F)
Flash Point: 40 deg C ( 104.00 deg F)
Explosion Limits, lower: 1.30 vol %
Explosion Limits, upper: 8.70 vol %
Decomposition Temperature: Not available.
Solubility in water: soluble
Specific Gravity/Density: .9570g/cm3
Molecular Formula: C6H7N
Molecular Weight: 93.13

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures. Hygroscopic: absorbs
moisture or water from the air.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Moisture, water, oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 108-89-4: UT5425000
LD50/LC50:
CAS# 108-89-4: Draize test, rabbit, eye: 20 mg/24H Moderate;
Inhalation, mouse: LC50 = 4 gm/m3; Oral, mouse: LD50 = 350 mg/kg;
Oral, rat: LD50 = 440 mg/kg; Skin, rabbit: LD50 = 270 uL/kg.
Carcinogenicity:
4-Picoline -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: PICOLINES
Hazard Class: 3
UN Number: 2313
Packing Group: III
IMO
Shipping Name: PICOLINES
Hazard Class: 3.3 (8)
UN Number: 2313
Packing Group: III
RID/ADR
Shipping Name: PICOLINES
Hazard Class: 3
UN Number: 2313
Packing group: III

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: T
Risk Phrases:
R 10 Flammable.
R 20/22 Harmful by inhalation and if swallowed.
R 24 Toxic in contact with skin.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 9 Keep container in a well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 33 Take precautionary measures against static
discharges.
S 36 Wear suitable protective clothing.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 108-89-4: 2
Canada
CAS# 108-89-4 is listed on Canada's DSL List.
CAS# 108-89-4 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 108-89-4 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/02/1997 Revision #5 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
8-Hydroxyjulolidine 41175-50-2
(R)-2-Hydroxybutyl p-tosylate, 98+% 103745-07-9
TETRACHLOROETHYLENE DENSITY STANDARD 127-18-4
Tetrachloroethylene, 98% (GC) 127-18-4
Tetraethylammonium Bromide, 98% 71-91-0
Tetrahydrofuran, P.A., Stabilized with 0.025% BHT 109-99-9
Tetrahydrofuran, anhydrous, 99.9% Packaged under nitrogen. Stabilized 109-99-9
Tetrahydrofuran, 99.5+%, spectrophotometric grade 109-99-9
Unpreserved Tetrahydrofuran 109-99-9
Tetrahydroxy-P-Quinone Monohydrate, 99% (Titr.) 319-89-1
Ethyl L-Lactate,95% (GC) 687-47-8
N,N'-Dicyclohexylcarbodiimide, 99% 538-75-0
Tetramethylammonium hydroxide pentahydrate , 97% (48-52 wt% tma-oh) 10424-65-4
Tetramethylammonium hydroxide, 10% in water 75-59-2
Triphenyl phosphate 115-86-6
Benzamide, 99% 55-21-0
Thiosalicylic Acid, 98% 147-93-3
4-Iodobenzoic acid, 98% 619-58-9
Thiamine Hydrochloride, 98.5-101.5% (on the Anhydrous Substance) 67-03-8
Mercaptoacetic Acid, 98% 68-11-1
Mercaptoacetic acid 68-11-1
P-Anisidine, 99% 104-94-9
Thiourea, 99% 62-56-6
Thiourea, Reagent ACS, 99+% (Titr.) 62-56-6
Sebacoyl Chloride, Tech. 90-95% Active Chlorine 111-19-3
Quinaldine, 97% 91-63-4
Toluene, 99% 108-88-3
Toluene, Scintillation Grade 108-88-3
Tetrapropylammonium Chloride, 94% (Titr.) 5810-42-4
Toluene, Reagent ACS, Spectro Grade, 99.5% (GC) 108-88-3
Toluene, Reagent ACS 108-88-3
Toluene for HPLC 108-88-3
Himic anhydride, 99% 826-62-0
Tributyl Phosphate, 99% 126-73-8
Tributylamine, 99% 102-82-9
4-Picoline, 98% 108-89-4
Trichloroethylene, 99+% (Stabilized) 79-01-6
Titanium Rod 6.35mm Diam. 99.97% 7440-32-6
3-Amino-1H-1,2,4-triazole 61-82-5
Alizarin Complexone Dihydrate, Indicator Grade 3952-78-1
Phenylphosphate, disodium salt dihydrate, 98% 3279-54-7
Toluene-d8, 99+ atom % D 2037-26-5
Toluene-d8, packaged in 0.50 ml ampules, 100.0 atom % D 2037-26-5
Farnesol, mixture of isomers, 96% 4602-84-0
2,4-Dihydroxybenzaldehyde, 98% 95-01-2
tris-(Hydroxymethyl)-aminomethane, 99+% 77-86-1
Tris(hydroxymethyl)aminomethane, reagent acs 77-86-1
Hexyl alcohol 111-27-3
Sodium phosphate, tribasic dodecahydrate, p.a. 7601-54-9
4-Nitro-1,2-Phenylenediamine, 98% 99-56-9

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net