Search   
MSDS 
:
 Farnesol, mixture of isomers, 96%
CAS 
:
 4602-84-0
SYNONYMS 
:
 2,6,10-Dodecatrien-1-ol, 3,7,11-trimethyl-;     3,7,11-Trimethyl-2,6,10-dodecatrien-1-ol; Farnesyl alcohol
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 4602-84-0 |Farnesol, mixture of isomers | 96 | 225-004-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Not available.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. Expected to be a low
ingestion hazard.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
This material is lighter than water and insoluble in water. The fire
could easily be spread by the use of water in an area where the water
cannot be contained. In case of fire, use carbon dioxide, dry
chemical powder or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Avoid ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 4602-84-0:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Clear liquid
Color: colorless - light yellow
Odor: floral-like
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 149 deg C @ 4.00mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: 96 deg C ( 204.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: immiscible
Specific Gravity/Density: .8800g/cm3
Molecular Formula: C15H26O
Molecular Weight: 222.37

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, excess heat.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 4602-84-0: JR4979000
LD50/LC50:
CAS# 4602-84-0: Oral, mouse: LD50 = 7400 mg/kg; Oral, rat: LD50 = 6
gm/kg.
Carcinogenicity:
Farnesol, mixture of isomers -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 4602-84-0: No information available.
Canada
CAS# 4602-84-0 is listed on Canada's DSL List.
CAS# 4602-84-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 4602-84-0 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/02/1997 Revision #4 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
8-Hydroxyjulolidine 41175-50-2
(R)-2-Hydroxybutyl p-tosylate, 98+% 103745-07-9
TETRACHLOROETHYLENE DENSITY STANDARD 127-18-4
Tetrachloroethylene, 98% (GC) 127-18-4
Tetraethylammonium Bromide, 98% 71-91-0
Tetrahydrofuran, P.A., Stabilized with 0.025% BHT 109-99-9
Tetrahydrofuran, anhydrous, 99.9% Packaged under nitrogen. Stabilized 109-99-9
Tetrahydrofuran, 99.5+%, spectrophotometric grade 109-99-9
Unpreserved Tetrahydrofuran 109-99-9
Tetrahydroxy-P-Quinone Monohydrate, 99% (Titr.) 319-89-1
Ethyl L-Lactate,95% (GC) 687-47-8
N,N'-Dicyclohexylcarbodiimide, 99% 538-75-0
Tetramethylammonium hydroxide pentahydrate , 97% (48-52 wt% tma-oh) 10424-65-4
Tetramethylammonium hydroxide, 10% in water 75-59-2
Triphenyl phosphate 115-86-6
Benzamide, 99% 55-21-0
Thiosalicylic Acid, 98% 147-93-3
4-Iodobenzoic acid, 98% 619-58-9
Thiamine Hydrochloride, 98.5-101.5% (on the Anhydrous Substance) 67-03-8
Mercaptoacetic Acid, 98% 68-11-1
Mercaptoacetic acid 68-11-1
P-Anisidine, 99% 104-94-9
Thiourea, 99% 62-56-6
Thiourea, Reagent ACS, 99+% (Titr.) 62-56-6
Sebacoyl Chloride, Tech. 90-95% Active Chlorine 111-19-3
Quinaldine, 97% 91-63-4
Toluene, 99% 108-88-3
Toluene, Scintillation Grade 108-88-3
Tetrapropylammonium Chloride, 94% (Titr.) 5810-42-4
Toluene, Reagent ACS, Spectro Grade, 99.5% (GC) 108-88-3
Toluene, Reagent ACS 108-88-3
Toluene for HPLC 108-88-3
Himic anhydride, 99% 826-62-0
Tributyl Phosphate, 99% 126-73-8
Tributylamine, 99% 102-82-9
4-Picoline, 98% 108-89-4
Trichloroethylene, 99+% (Stabilized) 79-01-6
Titanium Rod 6.35mm Diam. 99.97% 7440-32-6
3-Amino-1H-1,2,4-triazole 61-82-5
Alizarin Complexone Dihydrate, Indicator Grade 3952-78-1
Phenylphosphate, disodium salt dihydrate, 98% 3279-54-7
Toluene-d8, 99+ atom % D 2037-26-5
Toluene-d8, packaged in 0.50 ml ampules, 100.0 atom % D 2037-26-5
Farnesol, mixture of isomers, 96% 4602-84-0
2,4-Dihydroxybenzaldehyde, 98% 95-01-2
tris-(Hydroxymethyl)-aminomethane, 99+% 77-86-1
Tris(hydroxymethyl)aminomethane, reagent acs 77-86-1
Hexyl alcohol 111-27-3
Sodium phosphate, tribasic dodecahydrate, p.a. 7601-54-9
4-Nitro-1,2-Phenylenediamine, 98% 99-56-9

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net