**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 26183-52-8 |Decyl alcohol, ethoxylated | ca 100 | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 19 36/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
May form explosive peroxides. Irritating to eyes and skin.The
toxicological properties of this material have not been fully
investigated.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Get medical aid. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. May form
explosive peroxides.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Isolate area and
deny entry. Provide ventilation. Place under an inert atmosphere.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use only in a well-ventilated area. Avoid contact
with eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation. If peroxide formation is suspected, do not
open or move container. Avoid contact with air and sunlight. Unused
chemicals should not be returned to the container. Do not distill
since this removes peroxide-inhibitors.
Storage:
Do not store in direct sunlight. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances. Deep freeze (below -20C). Regularly check
inhibitor levels to maintain peroxide levels below 1%. Do not break
the seal on the container until it is needed. Label the container
with the date it was first opened. Long-term storage is not
recommended.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use explosion-proof ventilation equipment. Facilities storing or
utilizing this material should be equipped with an eyewash facility
and a safety shower. Use adequate ventilation to keep airborne
concentrations low.
Exposure Limits
CAS# 26183-52-8:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Clear liquid
Color: clear yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: 304 deg C ( 579.20 deg F)
Flash Point: 224 deg C ( 435.20 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: soluble
Specific Gravity/Density:
Molecular Formula:
Molecular Weight:
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions. On long term storage, substances with
similar functional groups form explosive peroxides. Explosive
peroxides may form on concentration. Peroxides can be detonated by
friction, impact, or heating. Tends to form explosive peroxides;
especially when anhydrous. Peroxide formation may occur in
containers that have been opened and remain in storage.
Conditions to Avoid:
Incompatible materials, exposure to air, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Not available.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 26183-52-8: TR1581182
LD50/LC50:
CAS# 26183-52-8: Draize test, rabbit, eye: 100 uL/24H Severe; Draize
test, rabbit, skin: 500 uL/24H Moderate.
Carcinogenicity:
Decyl alcohol, ethoxylated -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 19 May form explosive peroxides.
R 36/38 Irritating to eyes and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 37/39 Wear suitable gloves and eye/face
protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 26183-52-8: 2
Canada
CAS# 26183-52-8 is listed on Canada's DSL List.
CAS# 26183-52-8 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 26183-52-8 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 5/19/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Tin, Granular, 0.1-0.8mm, P.A.
| 7440-31-5 |
|
Tin, 97.5%, foil 0.0125 mm thickness, 300 x 300mm
| 7440-31-5 |
|
Tin, 20 Mesh, Reagent ACS (Granular)
| 7440-31-5 |
|
Tin, 30 Mesh, Reagent ACS (Granular)
| 7440-31-5 |
|
Tin (Shot), Reagent ACS, 99.5% (Titr.)
| 7440-31-5 |
|
1-Bromohexadecane, 97%
| 112-82-3 |
|
Anthraquinone, 97%
| 84-65-1 |
|
2-(1-Piperazinyl)Pyrimidine, 98+%
| 0-01-1 |
|
Indocyanine Green, 99% (uv-vis)
| 3599-32-4 |
|
Sodium Carbonate Decahydrate, P.A.
| 6132-02-1 |
|
3-Phenylpropionaldehyde, 90-95%
| 104-53-0 |
|
Cesium Bicarbonate, 99.9%
| 15519-28-5 |
|
Methyl Acetoacetate, 99+%
| 105-45-3 |
|
2-Methoxyethylamine
| 109-85-3 |
|
3-Amino-1-Phenyl-2-Pyrazolin-5-One, 99+%
| 4149-06-8 |
|
Methyl 4-(1-Hydroxyethyl)Benzoate, Tech., 90% (GC)
| 79322-76-2 |
|
2,2,6-Trimethyl-4H-1,3-dioxin-4-one, 90-95% (GC)
| 67-64-1 |
|
P-Toluenesulfonic Acid,Sodium Salt, 99% (TLC)
| 657-84-1 |
|
Hexadecyltrimethylammonium hydroxide titrant (0.5M in water with 10%
| 67-56-1 |
|
P-Methoxycinnamic Acid, 99%, Predominantly Trans
| 830-09-1 |
|
Tetramethylammonium Acetate, 50% Aqueous Solution
| 7732-18-5 |
|
Sulfuryl Chloride, 98.5%
| 7791-25-5 |
|
4-Nitrophenyl Isocyanate, 99% (GC)
| 100-28-7 |
|
Chloromethylated polystyrene: 2% divinylbenzene copolymer beads
| 70024-51-0 |
|
Propionic anhydride, 97%
| 123-62-6 |
|
Propionic anhydride, 99% (gc)
| 123-62-6 |
|
Benzalkonium chloride, alkyl distribution from C8H17 to C16H33
| 7732-18-5 |
|
Cellulose Acetate, Average M.W. 61000
| 9004-35-7 |
|
Cellulose acetate trimellitate
| 52907-01-4 |
|
4,4'-Methylenedianiline
| 101-77-9 |
|
Platinum, powder, 99.99%
| 7440-06-4 |
|
Heptaldehyde, 95%, stabilized with 100 ppm hydroquinone
| 111-71-7 |
|
Methyl Chloroacetate, 98%
| 96-34-4 |
|
Chloroacetone, 96% stabilized with 0.5% CaCO3
| 78-95-5 |
|
4-Methoxy-1-Naphthonitrile
| 5961-55-7 |
|
(+)-2,3-O-Isopropylidene-L-threitol, 99%
| 50622-09-8 |
|
3,3' -Diaminobenzidine tetrahydrochloride, 97%
| 7411-49-6 |
|
9(10H)-Acridone
| 578-95-0 |
|
Polyvinylpyrrolidone K15 (average m.w.10.000)
| 9003-39-8 |
|
Polyvinylpyrrolidone, K30
| 9003-39-8 |
|
Polyvinylpyrrolidone K12
| 9003-39-8 |
|
Polyvinylpyrrolidone
| 9003-39-8 |
|
N,N-Diethyl-m-toluamide, 98%, min. 95% meta-isomer
| 134-62-3 |
|
Sodium Bis-(Trimethylsilyl)-Amide, 98+ %
| 1070-89-9 |
|
Linolenic acid, tech. 90% (remainder lino leic acid)
| 463-40-1 |
|
o-Toluidine, 99%
| 95-53-4 |
|
Polyethyleneglycol 300 Monodecylether (Fractionated, Fraction 5)
| 26183-52-8 |
|
4-Oxo-4-Phenylamino-2-Butenoic Acid
| 37902-58-2 |
|
Cesium Sulfate, 99+%
| 10294-54-9 |
|
Bilirubin, 99% (uv)
| 635-65-4 |
|
|