**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 6132-02-1 |Sodium Carbonate Decahydrate | 100 | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes.
Potential Health Effects
Eye:
Contact with eyes may cause severe irritation, and possible eye
burns.
Skin:
Contact with skin causes irritation and possible burns, especially
if the skin is wet or moist.
Ingestion:
May cause severe gastrointestinal tract irritation with nausea,
vomiting and possible burns.
Inhalation:
May cause irritation of the respiratory tract with burning pain in
the nose and throat, coughing, wheezing, shortness of breath and
pulmonary edema.
Chronic:
Prolonged or repeated inhalation may cause nosebleeds, nasal
congestion, erosion of the teeth, perforation of the nasal septum,
chest pain and bronchitis.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of soap and water for at
least 15 minutes while removing contaminated clothing and shoes. Wash
clothing before reuse.
Ingestion:
Do NOT induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid.
Inhalation:
Remove from exposure to fresh air immediately. If not breathing,
give artificial respiration. If breathing is difficult, give oxygen.
Get medical aid if cough or other symptoms appear. Do NOT use
mouth-to-mouth resuscitation.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Wear
appropriate protective clothing to prevent contact with skin and
eyes. Wear a self-contained breathing apparatus (SCBA) to prevent
contact with thermal decomposition products. Vapors may be heavier
than air. They can spread along the ground and collect in low or
confined areas.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use only in a well-ventilated area. Do not get in
eyes, on skin, or on clothing. Keep container tightly closed. Avoid
ingestion and inhalation. Wash clothing before reuse.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Good general ventilation should be sufficient to control airborne
levels. Facilities storing or utilizing this material should be
equipped with an eyewash facility and a safety shower.
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
Follow the OSHA respirator regulations found in 29CFR
1910.134 or European Standard EN 149. Always use a
NIOSH or European Standard EN 149 approved respirator
when necessary.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Solid
Appearance: white
Odor: None reported
pH: 11.5 @ 1% solution
Vapor Pressure: Not applicable.
Viscosity: Not applicable.
Boiling Point: Not applicable.
Freezing/Melting Point: 33-34C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: 21.5% @ 0C
Specific Gravity/Density: 1.44
Molecular Formula: Na2CO3.10H2O
Molecular Weight: 286.1118
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Reacts explosively with red hot aluminum metal. Incompatible with
ammonia and silver nitrate, 2,4-dinitrotoluene,
2,4,6-trinitrotoluene, sulfuric acid, sodium sulfide and water,
lithium, phosphorus pentoxide and fluorine.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide, toxic fumes of sodium oxide, sodium oxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 6132-02-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Sodium Carbonate Decahydrate -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Ecotoxicity:
No information found
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Shipping Name: Not regulated.
Dangerous Goods Code:
UN Number:
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36 Irritating to eyes.
Safety Phrases:
S 22 Do not breathe dust.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
WGK (Water Danger/Protection)
CAS# 6132-02-1: 1
United Kingdom Occupational Exposure Limits
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 6132-02-1 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 6132-02-1 is not on the TSCA Inventory. It is a hydrate and
exempt from TSCA Inventory requirements (40CFR720.3(u)(2)).
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 7/24/1998 Revision #1 Date: 8/02/2000
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Tin, Granular, 0.1-0.8mm, P.A.
| 7440-31-5 |
|
Tin, 97.5%, foil 0.0125 mm thickness, 300 x 300mm
| 7440-31-5 |
|
Tin, 20 Mesh, Reagent ACS (Granular)
| 7440-31-5 |
|
Tin, 30 Mesh, Reagent ACS (Granular)
| 7440-31-5 |
|
Tin (Shot), Reagent ACS, 99.5% (Titr.)
| 7440-31-5 |
|
1-Bromohexadecane, 97%
| 112-82-3 |
|
Anthraquinone, 97%
| 84-65-1 |
|
2-(1-Piperazinyl)Pyrimidine, 98+%
| 0-01-1 |
|
Indocyanine Green, 99% (uv-vis)
| 3599-32-4 |
|
Sodium Carbonate Decahydrate, P.A.
| 6132-02-1 |
|
3-Phenylpropionaldehyde, 90-95%
| 104-53-0 |
|
Cesium Bicarbonate, 99.9%
| 15519-28-5 |
|
Methyl Acetoacetate, 99+%
| 105-45-3 |
|
2-Methoxyethylamine
| 109-85-3 |
|
3-Amino-1-Phenyl-2-Pyrazolin-5-One, 99+%
| 4149-06-8 |
|
Methyl 4-(1-Hydroxyethyl)Benzoate, Tech., 90% (GC)
| 79322-76-2 |
|
2,2,6-Trimethyl-4H-1,3-dioxin-4-one, 90-95% (GC)
| 67-64-1 |
|
P-Toluenesulfonic Acid,Sodium Salt, 99% (TLC)
| 657-84-1 |
|
Hexadecyltrimethylammonium hydroxide titrant (0.5M in water with 10%
| 67-56-1 |
|
P-Methoxycinnamic Acid, 99%, Predominantly Trans
| 830-09-1 |
|
Tetramethylammonium Acetate, 50% Aqueous Solution
| 7732-18-5 |
|
Sulfuryl Chloride, 98.5%
| 7791-25-5 |
|
4-Nitrophenyl Isocyanate, 99% (GC)
| 100-28-7 |
|
Chloromethylated polystyrene: 2% divinylbenzene copolymer beads
| 70024-51-0 |
|
Propionic anhydride, 97%
| 123-62-6 |
|
Propionic anhydride, 99% (gc)
| 123-62-6 |
|
Benzalkonium chloride, alkyl distribution from C8H17 to C16H33
| 7732-18-5 |
|
Cellulose Acetate, Average M.W. 61000
| 9004-35-7 |
|
Cellulose acetate trimellitate
| 52907-01-4 |
|
4,4'-Methylenedianiline
| 101-77-9 |
|
Platinum, powder, 99.99%
| 7440-06-4 |
|
Heptaldehyde, 95%, stabilized with 100 ppm hydroquinone
| 111-71-7 |
|
Methyl Chloroacetate, 98%
| 96-34-4 |
|
Chloroacetone, 96% stabilized with 0.5% CaCO3
| 78-95-5 |
|
4-Methoxy-1-Naphthonitrile
| 5961-55-7 |
|
(+)-2,3-O-Isopropylidene-L-threitol, 99%
| 50622-09-8 |
|
3,3' -Diaminobenzidine tetrahydrochloride, 97%
| 7411-49-6 |
|
9(10H)-Acridone
| 578-95-0 |
|
Polyvinylpyrrolidone K15 (average m.w.10.000)
| 9003-39-8 |
|
Polyvinylpyrrolidone, K30
| 9003-39-8 |
|
Polyvinylpyrrolidone K12
| 9003-39-8 |
|
Polyvinylpyrrolidone
| 9003-39-8 |
|
N,N-Diethyl-m-toluamide, 98%, min. 95% meta-isomer
| 134-62-3 |
|
Sodium Bis-(Trimethylsilyl)-Amide, 98+ %
| 1070-89-9 |
|
Linolenic acid, tech. 90% (remainder lino leic acid)
| 463-40-1 |
|
o-Toluidine, 99%
| 95-53-4 |
|
Polyethyleneglycol 300 Monodecylether (Fractionated, Fraction 5)
| 26183-52-8 |
|
4-Oxo-4-Phenylamino-2-Butenoic Acid
| 37902-58-2 |
|
Cesium Sulfate, 99+%
| 10294-54-9 |
|
Bilirubin, 99% (uv)
| 635-65-4 |
|
|