Search    ENTER KEYWORD
MSDS Material Safety Data Sheet
CAS

28-32-5
28-45-6

File Name: hycordiagnostics_com---MSDS_050_04_IgE_sample_diluent.asp
                                                                                                                     Page 1 of 5
HYCOR BIOMEDICAL INC.

MATERIAL SAFETY DATA SHEET
Date Updated: 01 Aug. 2006
Revision Number: MSDS 50.04
SECTION 1. PRODUCT and COMPANY INFORMATION
Commercial Product: ALLERGY REAGENTS 鈥揝AMPLE DILUENT
Name : IgE Sample Diluent
List Number(s): 72001, 72004, 72005, 72009, 74123, 309046, 319046
Product Classification: Component of in vitro diagnostic device
Manufacturer Company: Hycor Biomedical Inc. Distributor: (As appropriate)
7272 Chapman Ave.
Garden Grove, CA 92841 (USA)

Emergency Telephone No.:
USA No. 1-(714)- 933-3000 Attention: Randy Wilson

SECTION 2. COMPOSITION / INFORMATION ON INGREDIENTS
Composition: Bottles contain less than 0.1% Sodium Azide (NaN3),
Hazardous substances (chemical): sodium azide
See EEC directive 67/548/EEC and amendments.
Substance %w/w Health Class CAS No. EINECS ANNEX 1
No.
Sodium azide (sodium azoture) 0.095 T+; N R:28-32-50/53 26628-22-8 247-852-1 011-004-00-7
% S: (1/2)-28-45-60-61

See section 16 for spelling of R and S phrases.

SECTION 3. HAZARDS IDENTIFICATION
Classification: Product is chemically classified as a non-dangerous preparation
However, avoid repeated exposures and/or ingestion of preparation containing sodium azide, toxic if swallowed, even if
its concentration is below allowed limits.

SECTION 4. FIRST AID MEASURES
Ingestion: Do not induce vomiting. Give large quantities of water. Consult a physician or poison control center
immediately. Never give anything by mouth to an unconscious person.

Skin Care: Wipe off excess material from skin then immediately flush skin with plenty of soap and water for at least 15
minutes. Remove contaminated clothing and wash before reuse. Get medical attention.
Eyes contact: promptly flush eyes with large amounts of water for 15 minutes, lifting eyelids occasionally. Seek medical
attention
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
medical attention immediately.
In any case consult a physician and show the container and / or label.




MSDS 050.04 01 Aug 06
Page 2 of 5

Commercial Product: Sample Diluent

SECTION 5. FIRE-FIGHTING MEASURES
Extinguishing Media: water spray, dry chemical, foam or carbon dioxide. No restriction.
Special Fire Fighting Procedures: In case of fire, wear a full protective clothing and NIOSH-approved self-contained
respirator with full-face piece operated in the pressure demand or other positive.
Unusual Fire Fighting Procedures: Keep away from heat, sparks and flames. Contact with strong oxidizing or reducing
agents may create an exothermic reaction. Although sodium azide reacts with both copper and lead to produce
explosive azides, at this concentration there is no serious danger.
Thermal Decomposition: Dangerous decomposition is not anticipated.

SECTION 6. ACCIDENTAL RELEASE MEASURES
Steps To Be Taken After Spillage: Wear appropriate personal protective equipment (rubber gloves and protective
clothing) Absorb with an inert material (vermiculite, dry sand, earth) and place in a chemical waste container. Wash
contaminated area with dilute bleach or soap. . If sample diluent has already diluted serum specimens, disinfect
carefully.

Absorbant Material: Do not use combustible materials, as sawdust.

Waste Disposal Method: Consult a specialist for disposal of the spilled substance.

SECTION 7. HANDLING AND STORAGE
Handling: Keep in its original container, tightly closed. Protect from physical damage. Open and handle container
carefully. Wear rubber gloves and protective clothing. Do not swallow. Avoid a prolonged and excessive contact with
skin.
Storage: Store between +2掳C (35,6掳F) and +8掳C (46,4掳F).
Other Precautions: Do not store near heat or ignition sources.

SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Product TLV: Not known.
Sodium azide TLV (pure substance): 0.29 mg/m3 (Ceiling)
Respiratory Protection: None
Eye Protection: Maintain eye wash fountain and quick-drench facilities in work area.
Hand Protection: One-way rubber gloves. Wash hands before breaks and at end of the work.
Other Protective Equipment: Protective Clothing




MSDS 050.04 01 Aug 06
Page 3 of 5

Commercial: Sample Diluent

SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State: liquid
Ignition Temperature: N/A
Color: N/A
Explosion limits: N/A
Odor: N/A
Vapor Pressure: N/A
pH Value: 6-9
Solubility In Water: N/A
Boiling Point: N/A
In: N/A
Melting Point: N/A
Viscosity: N/A
Flash Point: N/A

SECTION 10. STABILITY AND REACTIVITY
Stable under ordinary conditions of use and storage (2梅8掳C; 35,6梅46,4掳F).

Hazardous Decomposition Products: carbon monoxide, carbon dioxide, nitrogen oxides.

Hazardous Decomposition Products: Nitrogen oxides

Hazardous Polymerization: will not occur.

Incompatibilities: oxidizing agents, bases and heavy metals
Conditions to avoid

SECTION 11. TOXICOLOGICAL INFORMATION
Referred to Sodium azide (in pure form)
Referred to the product:
LD50 Oral (rat): 27mG/kG
LD50 Oral: Not known
LD50 Oral (mouse): 27 mg/kg
LDLO Oral (woman): 14 mg/kg
LD50 Skin: Not known
LDLO Oral (man): 29 mg/kg
LD50 Skin (rabbit): 20mG/kG
LD50 Inhalation: Not known
LD50 Skin (rat): 50 mg/kg
LD50 Subcutaneous (rat): 45100 碌g/kg
Irritation, skin: Not known
LD50 Inhalation (rat): 37 mG/M3
Irritation, eyes: Not known LD50 Irritation, skin (rat): 50mG/kG
LD50 Intravenous (rat): 47500 碌g/kg
IARC category: none

Product Toxicological Information: The toxicological properties have not been determined. May be harmful by ingestion
or prolonged contact with skin. Toxicological properties have not been thoroughly investigated.




MSDS 050.04 01 Aug 06
Page 4 of 5

Commercial: Sample Diluent

SECTION 12. ECOLOGICAL INFORMATION
Use product according with good laboratory practices and avoid releasing to the environment.
Ecotoxicity (aquatic toxicity): Product contains 0,095% sodium azide. Sodium azide concentration is below EC
directives allowed limits (0,25%, w/w). So the product is classified as not harmful to the aquatic environment, according
to the legislation in force (1999/45/CE and amendments). However, because the sodium azide LC50/96H values for fish
are less than 1 mg/L, do not empty product into water or drains.
Mobility: Product is not expected to selectively partition and absorb to soil or sediments.
Persistence and Degradability: when released into the soil, or into water, this product is not expected to persist in the
environment.
Bioaccumulative potential: The product is not expected to significantly bioaccumulations
Other adverse effects: None

SECTION 13. DISPOSAL CONSIDERATIONS
Observe all Federal, State and Local laws concerning Health and Pollution.

SECTION 14. TRANSPORT INFORMATION
Transport in accordance with national and international regulations.
Is not subject to current regulations for transportation of hazardous goods (eg.GGUS/ADR, GGUE/RID, IMDG,
IATA/ICAD.
Must be transport at controlled temperature (2梅8 掳C; 36.6梅46.4 掳F). Do not compromise container integrity.

SECTION 15. REGULATORY INFORMATION
Label information:

Hazard Symbol: none

Indication of danger: none

Risk phrases: none

Safety phrases: none




MSDS 050.04 01 Aug 06
Page 5 of 5

Commercial: Sample Diluent

SECTION 16. OTHER INFORMATION

The information herein is believed to be correct as of the date hereof but is provided without warranty of any kind. The
recipient of our products is responsible for observing any laws and guidelines applicable.
Use the product according with box insert and MSDS information. Please, read well instructions for use and warning.

Legend:
R phrases:
R 28: Very toxic if swallowed
R 32: Contact with acids liberates very toxic gas
R 50/53: Very toxic to aquatic organisms may cause long-term adverse effects in the aquatic environment.

S phrases:
S 1/2:Keep locked up and out of the reach of children
S 28: After contact with skin, wash immediately with plenty of water
S 45: In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible)
S 60: This material and its container must be disposed of as hazardous waste
S 61: Avoid release to the environment. Refer to special instructions/safety data sheets




MSDS 050.04 01 Aug 06

Search    ENTER KEYWORD
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP
NAMECAS
hp_com---pcgreenlabel.asp N/A
hp_com---supcode.asp N/A
hse_gov_uk---indg353.asp N/A
Hurricane.asp 111-76-2
hycorbiomedical_com---87155.asp 9002-88-4
hycorbiomedical_com---MSDS_01_07_Kova_Trol-2006-Abnormal.asp 13746-66-2 151-50-8 28-29-4
hycorbiomedical_com---Msds_030.05-substrate.asp 22-38-4 28-32-5 28-45-6
hycorbiomedical_com---MSDS_031_05-allergen_disc.asp 28-32-5 28-45-6
hycorbiomedical_com---MSDS_048_03-HYTEC_Calibrators.asp 28-32-5 28-45-6
hycorbiomedical_net---MSDS_03.03-LiquaTrol.asp 13746-66-2 151-50-8 28-29-4 28836-03-5
hycordiagnostics_com---MSDS_050_04_IgE_sample_diluent.asp 28-32-5 28-45-6
hycordx_com---MSDS_01.05-KovaTrol.asp 13746-66-2 151-50-8 28-29-4
hycordx_com---MSDS_03_04-LiquaTrol.asp 13746-66-2 151-50-8 28-29-4 28836-03-5
hydro-gardens_com---Calcium_Nitrate.asp 15245-12-2
hyvac_com---Flushing_Oil_MSDS.asp 64741-88-4
iaq-usa_com---Shockwave_MSDS.asp 7732-18-5 68391-01-5 68956-79-6 9016-45-9 497-19-8 64-02-8
ibex_ca---50-013_ChonAC_rec_sucrose_5_10IUmL_Rev00_Jul05.asp 9047-57-8
ifa_hawaii_edu---Nickel_Alloys.asp N/A
iftkorea_co_kr---GetekFR4PrepregMSDSDecember2006Final.asp 65997-17-3 80-05-7 37-41-4 85-68-7 84-74-2
igcl_com---MSDS.asp N/A
igs_nigc_ir---M-SF-233.asp N/A
iko_com---1511MsdscInsulIkothermCrc.asp N/A
iko_com---1911MsdscInsulIkothermHr.asp N/A
image_snapon_com---blpbc18_blpbc24_blpbc30_blpbc36.asp N/A
image_snapon_com---blpgss1462npa.asp N/A
image_snapon_com---blpptss3822.asp N/A
image_snapon_com---btqs500_btqs600_btqshd400_btqs1000npa.asp N/A
image_snapon_com---cj9180npa.asp N/A
image_snapon_com---exdms48npa.asp N/A
image_snapon_com---fsdr_fsdr9pk.asp N/A
image_snapon_com---glove301_glove302.asp N/A
image_snapon_com---imdm390.asp N/A
image_snapon_com---lbuk3_lbuk3pk.asp N/A
image_snapon_com---ldtsp4.asp N/A
image_snapon_com---stsm18e.asp N/A
image_snapon_com---torch6.asp N/A
image_snapon_com---uim2lt.asp N/A
imaging_mallinckrodt_com---Gallium_Citrate.asp 41183-64-6 7647-14-5 100-51-6 6132-04-3 7732-18-5
immcodiagnostics_com---M1027K.asp N/A
industrialbolt_com---BrakePartsCleanerII.asp 110-54-3 64-17-5 124-38-9 67-56-1
industrialbolt_com---ChokeCarbCleaner.asp 108-88-3 67-56-1 67-64-1 124-38-9
innotrac_fi---ddimer.msds.en.asp N/A
innotrac_fi---hcg.msds.se.asp N/A
innotrac_fi---msds.gr.Buffer.concentrate.asp 10035-04-8 78491-02-8 6381-92-6 7365-45-9 9005-64-5
innotrac_fi---troponin.msds.en.asp N/A
innovationinks_ca---msds.asp 64742-46-7 61789-52-4 8030-70-4
inovadx_com---508509.asp 7664-93-9 7732-18-5
interferonsource_com---MSDS4004_Human-IFN_Omega_ELISA_kit.asp 55965-84-9
invitrogen_com---11668.asp N/A
invivogen_com---MSDS_EKLPS.asp 20-01-0 23-09-0

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com | Ads link:todaystock.net