INNOVATION PRINTING INKS - MSDS
MATERIAL SAFETY DATA SHEET
Innovation Printing Inks Inc.
3475 Griffith Preparation date : April 2004
Ville St-Laurent, Quebec Prepared by : regulatory department
Canada H4T 1W5
Hazard Ratings
Minimal 0 Health 1
Flammability 1
Slight 1
Reactivity 0
Moderate 2
Serious 3
Severe 4
WHMIS (Canada) : Non controlled product.
SECTION I PRODUCT IDENTIFICATION
Trade names : Cyber II, Durobynd, Gemini, Multi-Set High Tack (MSHT), OFC
Application of the product : lithographic printing ink
Appearance & odor : Colored paste, oily smell
SECTION II HAZARDOUS INGREDIENTS
Ingredient CAS # Wt % TLV (ACGIH) PEL (OSHA)
3.5 mg/m3 3.5 mg/m3
Organic pigments Various 15-30
Synthetic resins Various 20-35
Vegetable oils 8001 15-30
Hydro treated petroleum distillates 64742-46-7 0-25
10 mg/m3 (as dust) 15 mg/m3 (as dust)
Polymeric wax blend - 0-10
Cobalt drier 61789-52-4 0-2
Manganese drier 8030-70-4 0-1
SECTION III PHYSICAL DATA
Boiling Range : > 260掳C (500掳F)
Evaporation rate : slower than butyl acetate
Freezing point : N/A
Odor threshold : N/A
Specific gravity : 0.88 鈥? 1.05
Vapor pressure : less 0.04 psi
Vapor density : heavier than air
Volatiles : 17-25% (ASTM D2369)
Page 1 of 4
INNOVATION PRINTING INKS - MSDS
SECTION IV HEALTH & HAZARD DATA
Eye contact : Direct contact may cause irritation
Skin contact : Prolonged contact or repeated exposure may cause minor irritation.
Inhalation : Excess inhalation of mist or vapor may cause dizziness, nausea or irritation of nasal and
respiratory passages.
Ingestion : May cause gastrointestinal irritation, nausea and vomiting.
Medical conditions aggravated by normal exposure : persons with dermatitis should avoid skin contact.
Target organs : skin, eyes, lungs
Primary route of entry : Eyes, inhalation, dermal
SECTION V FIRST AID PROCEDURES
Eye contact : Flush with large amounts of water until irritation subsides. If irritation persists, contact a
physician.
Skin contact : Wash with soap and water. Remove contaminated clothing and wash thoroughly.
Ingestion : If swallowed, do not induce vomiting. Call a physician.
SECTION VI FIRE & EXPLOSION DATA
Flash Point : > 102掳C (215掳F)
OSHA classification : Combustible liquid 鈥? Class IIIB
Explosion Limits : N/A (PEL)
Extinguishing media : Foam, carbon dioxide, dry chemical.
Water spray may be applied to exposed containers.
Unusual fire & explosion hazards : Dense smoke may be generated when burning. Carbon monoxide and
carbon dioxide generated as combustion products.
Special fire fighting procedures : Self contained breathing apparatus recommended.
SECTION VII ACCIDENTAL RELEASE
Procedure when material is spilled : Wipe up and dispose of rags in approved waste containers. If petroleum
hydrocarbon is used in clean-up, provide adequate ventilation.
SECTION VIII HANDLING & STORAGE
Handling : Avoid storage above 32掳C (90掳F)
Other precautions : None required.
SECTION IX SPECIAL PROTECTION INFORMATION
Ventilation : Use sufficient ventilation.
Page 2 of 4
INNOVATION PRINTING INKS - MSDS
Eye protection : Goggles recommended.
Protective gloves : Gloves recommended
Respiratory protection : None required.
Other protection : None required.
SECTION X REACTIVITY DATA
Product stability : Stable.
Conditions to avoid : Strong oxidizing agents. Avoid storage above 32掳C (90掳F). Keep containers closed and when
not in use.
Hazardous decomposition products : None.
Hazardous polymerization : Will not occur.
SECTION XI TOXICOLOGICAL DATA
Carcinogen : Contains no materials that are considered carcinogenic by the Nation Toxicological Programs (NAP).
Mutagen : No
Teratogen : No
Reproductive toxicity : No
SECTION XII WASTE DISPOSAL INFORMATION
Local and/or state/provincial regulations may apply. Spill should be contained and absorbed with suitable absorbent
material and placed in a suitable container for disposal in a licensed facility. Do not discharge in water ways or
sewers.
Federal, Research Conservation and Recovery Act (RCRA) : Not regulated as hazardous waste under RCRA.
SECTION XIII TRANSPORTATION INFORMATION
TDG (Canada) : not regulated
DOT (HM181) : not regulated
Shipping Labels : none required
SECTION XIV REGULATORY INFORMATION
TSCA (USA - Toxic Substances Control Act) : All ingredients listed in TSCA inventory
DSL (Canada 鈥? Domestic Substances Listing) : All ingredients listed in DSL
CERCLA Super (40 CFR 117.302) : Contains no reportable materials.
Sara Title III : Superfund Amendment and Reauthorization Act III sec. 313 : 2% cobalt and 1% manganese
compound, barium compounds in some colors.
OSHA Hazard communication 29CFR 1910.1900 : carbon black in blacks PEL 3.5 mg/m3, manganese compound
PEL 5 mg/m3.
Page 3 of 4
INNOVATION PRINTING INKS - MSDS
FDA : This printing ink is not a food additive and has no FDA status.
California Proposition 65 : Those inks which contain barium compounds are based on pigment red 53:1 (D&C)
which is listed on the California list of heavy metals.
CONEG legislation : Meets all current heavy metal limitations.
WHMIS (Canada) : Non controlled product.
The information is furnished without warranty, expressed or implied by Les Encres d鈥橧mprimerie Innovation Inc. 鈥?
Innovation Printing Inks Inc. It represents a compilation of information from MSDS鈥檚 supplied by raw material
supplier and a, review of applicable government regulations. It covers only the specific products listed and their
use in normal manufacturing or operating conditions.
Page 4 of 4
|