BEHNKE LUBRICANTS INC Approval Date 2/1/2007
Supersedes Date 11/14/2006
Material Safety Data Sheet
Section I. Chemical Product and Company Identification
JAX MULTITRAN III A.T.F. (DEXRON III) 48000
Product
Product Name/
ID No.
Trade Name
BEHNKE LUBRICANTS INC.
Supplier Emergency Contact
W134 N5373 CAMPBELL DRIVE For Chemical Emergency, Spill, Leak, Fire,
MENOMONEE FALLS, WI 53051 USA Exposure or Accident, Call CHEMTREC:
NORTH AMERICA 800-424-9300
INTERNATIONAL +01-703-527-3887 Collect
Synonym(s) None
Chemical Name Petroleum lubricating oil
JAX: 262-781-8850
Non-Emergency
JAX/FAX: 262-781-3906
Contact
Chemical Family Petroleum hydrocarbon oil blend
Chemical Formula Mixture
Material Uses Multipurpose power transmission fluid
Section II. Composition and Information on Ingredients
Name PEL/TLV, Source CAS # % by Weight
PROPRIETARY FORMULA.
Petroleum naphtha NE 64742-88-7 3-5
LC50, LD50 of Ingredients Not available
Section III. Hazards Identification
Emergency Overview Potential health risks vary from person to person. As a precaution, exposure to liquids, vapors, mists or fumes should be
minimized. In an accident involving high-pressure equipment, this product may be injected under the skin, resulting in a small,
sometimes bloodless puncture wound. Immediate treatment at a surgical emergency center is recommended.
Potential Health Effects:
Eye Contact May cause slight irritation and redness.
Contact with skin is not expected to cause prolonged or significant irritation. Not expected to be harmful to internal organs if
Skin Contact
absorbed through the skin. High-Pressure Equipment Information: Accidental high-velocity injection under the skin of materials of
this type may result in serious injury. Seek medical attention at once should an accident like this occur. The initial wound at the
injection site may not appear to be serious at first, but if left untreated, could result in disfigurement or amputation of the affected
part.
Ingestion Ingestion may cause irritation of the digestive tract. Aspiration into lungs can cause pneumonitis, which can be fatal.
Inhalation Vapor inhalation under ambient temperature conditions is not normally a problem. May cause respiratory irritation or other
pulmonary effects following prolonged or repeated inhalation of oil mist at airborne levels above the recommended oil mist
exposure limit.
Continued on Next Page
JAX MULTITRAN III A.T.F. (DEXRON III) PAGE 2 OF 4
Section III. Hazards Identification (cont'd)
1 1 0
HMIS Code Health: Fire: Reactivity:
1 1 0
NFPA Code Health: Fire: Reactivity:
Section IV. First Aid Measures
Remove contact lenses, if wearing, and flush eyes with water. If irritation persists, consult a physician.
Eye Contact
Remove clothing and shoes, if contaminated. Wash skin with soap and water. Wash or clean contaminated clothing before
Skin Contact
resuse and discard oil-soaked shoes. If irritation persists, consult a physician.
If swallowed, DO NOT induce vomiting. As a precaution, give the person a glass of water to drink and seek medical attention.
Ingestion
Never give anything by mouth to an unconscious person. Consult a physician.
If exposed to excessive levels of material in the air, move the exposed person to fresh air. Seek medical attention if coughing or
Inhalation
respiratory discomfort occurs.
Section V. Fire and Explosion Data
Autoignition Temperature Not available Sensitivity to Impact Not available
Flash Point 356掳F (180掳C), ASTM D 92 Sensitivity to Static Discharge Not available
Flammable Limits (Approx.) LOWER Flammable Limit: Not available UPPER Flammable Limit: Not available
See Lower and Upper Flammable Limits
Explosion Hazards
Carbon monoxide, carbon dioxide, aldehydes, smoke and irritating vapors as products of incomplete combustion.
Products of Combustion
Fire Fighting Media Dry chemical, alcohol foam, and carbon dioxide type extinguishing agents may all be suitable for extinguishing fires involving
and Instructions this type of product, depending on the size or potential size of fire and circumstances related to the situation. Plan fire
protection and response strategy through consultation with local fire protection authorities or appropriate specialists. The
following procedures for this type of product are based on the recommendations in the National Fire Protection Association's
Fire Protection Guide on Hazardous Materials. Use water to keep fire-exposed containers cool. If a leak or spill has not ignited,
use water spray to disperse the vapors and to provide protection for men attempting to stop a leak. Water spray may be used
to flush spills away from explosives. Firefighters should wear full protective gear, including helmet. Use supplied-air breathing
equipment for enclosed or confined spaces or as otherwise needed.
For fires involving this material, do not enter any enclosed or confined fire space without proper protective equipment, including
Special Remarks -
self-contained breathing apparatus. Leaks/ruptures in high-pressure systems using materials of this type can create a fire
Fire and Explosion
hazard when in the vicinity of ignition sources (open flame, pilot lights, sparks or electric arcs).
Hazards
Section VI. Accidental Release Measures
Recover free product. Add sand, earth, or other suitable absorbent material to the spill area. Minimize breathing vapors.
Release or Spill
Minimize skin contact. Open all windows and doors. Keep product out of sewers and watercourses by diking or impounding.
Advise authorities if the product has entered or may enter sewers, watercourses, or extensive land areas.
Environmental Impact Report spills as required to the appropriate authorities. U.S Coast Guard Regulations require immediate reporting of spills that
could reach any waterway including intermittent dry creeks. Report spill to the Coast Guard toll-free number 800-424-8802.
Section VII. Handling and Storage
Handling Container is not designed to contain pressure. Do not use pressure to empty container or it may rupture with explosive force.
"Empty" containers retain product residue and can be dangerous. Do not pressurize, cut, weld, braze, solder, drill, grind, or
expose such containers to heat, flame, sparks, static electricity, or other sources of ignition as they may explode and can cause
injury or death. Do not smoke when using this product. Empty container should be promptly returned to a drum reconditioner.
Do not use in high-pressure systems in the vicinity of flames, sparks, and hot surfaces. Keep container closed. Do not store
Storage
near heat, sparks, open flame, pilot lights, static electricity, or where temperature may exceed 120掳F (49掳C). Do not store in direct
sunlight. Keep out of reach of children.
Continued on Next Page
JAX MULTITRAN III A.T.F. (DEXRON III)
PAGE 3 OF 4
Section VIII. Exposure Controls and Personal Protection
Respiratory Protection Use respiratory protection if needed to keep airborne levels below recommended oil mist exposure limits.
Ventilation Use in a well-ventilated area. See Engineering Controls.
Protective Gloves Any lined non-permeable rubber gloves.
Eye Protection Chemical splash goggles or face shield in compliance with OSHA regulations are advised when eye contact may occur.
Personal Hygiene Wash skin thoroughly after contact, before breaks and meals and at end of work period. Product is readily removed from skin
by waterless hand cleaners followed by washing thoroughly with soap and water.
Engineering Controls If user operations generate an oil mist, use process enclosures, local exhaust ventilation, or other engineering controls to
control airborne levels below the recommended oil mist exposure limits.
Exposure Limit
Section IX. Physical and Chemical Properties
Appearance/Odor Red colored lube oil with little or no odor Vapor Pressure Nil
Vapor Density Not available
Percent Volatile Nil
Odor Threshold Not available
Evaporation Rate Nil
Specific Gravity 0.8639
Not available
Not available Viscosity
Density
Not available Solubility in Water Nil
Molecular Weight
Coefficient of Water/Oil Not available
Not available
pH
Distribution
Boiling Point Not available
Liquid
Physical State
Freezing/Melting Point Not available
Section X. Stability and Reactivity Data
Stable under normal temperatures and pressures.
Stability
Not available
Conditions of Instability
Conditions of Reactivity Not available
Conditions and Materials Avoid heat, sparks, open flames, acids, and oxidizing materials.
to Avoid
Hazardous Polymerization Hazardous polymerization will not occur.
Hazardous Decomposition Carbon monoxide, carbon dioxide, aldehydes, smoke and irritating vapors as products of incomplete combustion.
Products
Section XI. Toxicological Information
Dermal contact, eye contact, inhalation, ingestion.
Routes of Entry
Toxicity to Animals Not available
Effects of Acute Exposure Not available
Acute Effects of Not available
Sensitization
Ingestion Not available
Inhalation Not available
Toxically Synergistic Not available
Products
Chronic Effects on Humans:
Carcinogenic Effects This product does not contain a carcinogen or potential carcinogen as listed by NTP, IARC, or OSHA [29 CFR 1910.1200(D)#4].
Mutagenic Effects No data available to indicate any components present at greater than 0.1% may present a mutagenic hazard.
Continued on Next Page
JAX MULTITRAN III A.T.F. (DEXRON III) PAGE 4 OF 4
Section XI. Toxicological Information (cont'd)
Teratogenic Effects No data available to indicate any components present at greater than 0.1% may present a teratogenic hazard.
Reproductive Effects No data available to indicate any components present at greater than 0.1% may present a reproductive hazard.
Section XII. Ecological Information
There is no data available on the adverse effects of this material on the environment.
Ecotoxicity
Section XIII. Disposal Considerations
Consult federal, state or local authorities for proper disposal and reporting procedures. All disposals must comply wtih federal,
Waste Disposal
state and local regulations.
Section XIV. Transportation Information
U.S. D.O.T.
Shipping Name: UN Number:
Not regulated None
Hazard Class: Packing Group:
None None
Remarks None
Section XV. Regulatory Information
U.S. Federal Regulations:
Release of the following chemical(s) at quantities equal to or greater than the reportable quantities (RQ), is regulated by
CERCLA
40 CFR 302.4 :
None
SARA (Section 313) This product contains the following chemical(s) listed in Section 313 at or above the de minimis concentrations:
None
This product contains greater than 1.0% of the following chemical(s) on the SARA Extremely Hazardous Substances List:
SARA Extremely
Hazardous List None
TSCA Inventory All components of this material are on the U.S. TSCA Inventory.
California Prop. 65 WARNING: This product contains the following chemical(s) known to the State of California to cause birth defects or other
reproductive harm:
Toluene
International Regulations:
Canada All components are in compliance with the Canadian Environmental Protection Act. This product has been classified in
accordance with the hazard criteria of the CPR and this MSDS contains all the information required by CPR.
Japan MITI Not available
Australia Not available
Switzerland Not available
Section XVI. Other Information
2/1/2007
Approval Date
11/14/2006
Supersedes Date
Technical Services 262-781-8850
Prepared by
Section I
Sections Revised
Since Last Version
The information and recommendations contained herein are, to the best of Behnke Lubricant Inc.'s knowledge and belief, accurate and reliable as of the date
issued. Behnke Lubricants Inc. makes no warranty or guarantee, expressed or implied, of their accuracy or reliability, and Behnke Lubricants Inc. shall not be
liable for any loss or damage based up on the criteria supplied by the developers of these rating systems, together with Behnke Lubricants Inc.'s interpretation
of the available data.
|