Food Service Products
Sure Shine
Stainless Steel For Use On:
Stainless Steel
Cleaner Aluminum
Chrome
DESCRIPTION
A blend of cleaning solvents, polish & surface preservative agents
designed for cleaning, polishing and protecting stainless steel, chrome
and aluminum. Removes grease, fingerprints and light soil. Provides
a thin, protective, water-resistant film. Prevents rusting, corrosion
and discoloration. Contains no chlorinated solvent, no wax or
harsh abrasives.
DIRECTIONS
1. Apply a light amount of product onto surface that is to be polished.
2. Wipe immediately with a soft, clean cloth until the surface is shiny.
3. For vertical surfaces, or if sprayed next to upholstery, apply directly
onto cloth, then polish.
DO NOT USE ON FLOORS.
PRODUCT SPECIFICATIONS
Active Ingredients: 100% Abrasives: None
Color: Clear Wax: None
Odor: Lemon Chlorinated Solvents: None
pH: N/A Flash Point: 127 0F (TCC)
Solubility in water: Insoluble Storage/Stability: One year
Viscosity: Slight viscous Weight Per Gallon: 6.91 lbs. per gallon
Foam: None
Misco Products Corporation 鈥? Reading, PA 鈥? (800) 548-4568 FAX (610) 926-1194
www.miscoprod.com
SRS MATERIAL SAFETY DATA SHEET N/A= Not Applicable
Prepared by: Regulatory Affairs Dept. Effective Date: 2/02 Revision: n/a
(Prepared According to 29 CFR 1910.1200)
SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION
Manufacturer鈥檚 Name: Product Name: Sure Shine Supplier鈥檚 Name:
Misco Products Corporation Generic Name: Stainless Steel Polish
Manufacturer鈥檚 Address: Supplier鈥檚 Address:
Chemical Family: Mineral Oil Blend
1048 Stinson Drive Reading, PA 19605 Formula: Proprietary
Manufacturer鈥檚 Phone #: (610) 926-4106 Supplier鈥檚 Phone #:
SECTION 2-INGREDIENT INFORMATION
CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV
Petroleum Distillate 64742-88-7 20 to 30 500 ppm 100 ppm N/A
Mineral Seal Oil 64742-55-8 20 to 30 N/A N/A N/A
White Mineral Oil 8042-47-5 40 to 60 N/A N/A N/A
SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA
Boiling Point (掳F): 316 F. Initial Specific Gravity: 0.828 Flash Point (Method Used): 127掳 F. (TCC)
Vapor Pressure: <10mm Hg @ 68 F. Vapor Density (Air=1): >1 Upper Explosion Limit: N/A Lower Explosion Limit: N/A
% Volatile: < 30% pH: N/A Extinguishing Media: Foam, CO2, Dry Chemical
Solubility in Water: Nil Evaporation Rate (Water=1): <1 Special Firefighting Procedures: Do Not Use Water.
Physical Description: Slightly viscous clear liquid with solvent odor. Unusual Fire and Explosion Hazards: Drums heated by fire can explode.
SECTION 5-REACTIVITY DATA
Stability: Stable Hazardous Polymerization: None
Hazards Decomposition Products: Carbon monoxide possible if burned. Incompatibility (Materials to Avoid): Strong oxidizers.
SECTION 6-STORAGE AND HANDLING INFORMATION
Combustible liquid 鈥? Avoid contact with heat, spark or open flame. Use only with adequate ventilation. Avoid breathing of vapors or mists. Keep out of reach of children.
For use by trained personnel only. Keep container closed during storage. For institutional and industrial use only. Avoid contact with eyes, skin and clothing. Wash
thoroughly with soap and water after handling.
SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION
Effects of Overexposure: Respiratory Protection: Use with adequate ventilation. Use NIOSH/MSHA
Skin: Prolonged or repeated contact may cause irritation or dermatitis. approved hydrocarbon canister or respirator when using in poorly ventilated areas.
Eyes: Eye irritant. May cause redness, swelling, or blurred vision. Ventilation Requirements: Provide mechanical exhaust to keep TLV of Section 2
ingredients below acceptable limit.
Inhalation: May cause dizziness or drowsiness.
Protective Gloves: Solvent proof rubber or neoprene.
Ingestion: May cause dizziness, drowsiness or narcosis. Aspiration of material into
the lungs can cause pneumonitis. Eye Protection: Chemical splash goggles.
Other Protective Equipment: Fire extinguisher should be located nearby when
using.
First Aid Procedures: SECTION 9-SPILL OR LEAK PROCEDURES
Skin: Remove contaminated clothing. Wash with soap and water. Seek medical Steps to be taken in Case Material is Released or Spilled: Floors will become
attention if irritation persists. slippery. Avoid walking in product. Keep unessential personnel away. Mop up or
otherwise absorb and hold disposal. Avoid discharge to sewer or open waterways.
Eyes: Flush with large quantities of water, holding eyelids open. Seek medical
attention. Waste Disposal Method: Any method in accordance with local, state and federal
laws. Best method is to recycle or reuse for intended purpose. Consult local
Inhalation: Get to fresh air. If breathing is difficult, give oxygen. Seek medical
authorities for disposal in public sewer. Do not dispose of into storm drain, stream,
attention if symptoms persist.
river or to ground. Rinse container thoroughly before discarding in trash.
Ingestion: Do not induce vomiting. Seek medical attention immediately.
SECTION 10-REGULATORY INFORMATION
SARA Title III - Section 311/312 -Hazard Categories: Shipping Information: HMIS Hazardous Materials
Yes - Fire Hazard FOR CONTAINERS > 1 Gallon : Cleaning Compound Identification System
No - Sudden Release of Pressure Hazard Health 1
No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Cleaning Compound Flammability 2
Yes - Immediate (acute) Health Hazard Reactivity 0
No - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Cleaning Compound Personal Protection C
FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act
of 1986 and of 40 CFR 372.
CAS# Chemical Name Percent by Weight
None
This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.
CAS# Chemical Name Percent by Weight
None
SECTION 11-OTHER INFORMATION
This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the
application of this information, or the safety and suitability of our products either alone or in combination with other products. It is the responsibility of the user to
provide a safe workplace, using the health and safety information contained herein as a guide. This company will accept no liability for damages or loss incurred from the
improper handling and use of this product
|