Floor Finishes & Waxes
FLOOR COATING AND FINISHING MATERIAL
AS TO SLIP RESISTANCE ONLY
17SU
X-Cel Plus
High Performance For Use On:
Rubber Tile
Vinyl Tile
Extended Wear Terrazzo
Vinyl Asbestos
Sealed Wood
Asphalt Tile
Quarry Tile
Linoleum
Finish DESCRIPTION
A fast drying ultra durable floor finish with exceptional buffability. Tests on
high traffic floor produce wear levels dramatically superior to conventional
floor polishes on the market today. This unique product is ready for traffic
immediately after application without burnishing. After weeks of wear it will
snap back to its original beauty with the aid of a spray buff or mop-on restorer.
DIRECTIONS
PREPARATION: If stripping is necessary, use a high quality stripper and
follow directions accordingly. If floor is in good condition and stripping is not
necessary; sweep up excess dirt and dust and then clean with a good quality
cleaner to remove dirt and oils. Follow with a thorough rinsing and allow to
dry completely.
FINISHING: Spread a liberal coat of finish evenly across the floor with a
clean mop or applicator. Allow each coat to dry at least 30 minutes before
applying the next coat. Two or three coats are desired initially, depending on
the condition of the floor and gloss desired.
MAINTENANCE: The floor may be maintained using a quality floor cleaner
and damp mopping regularly. Spray buffing or mop-on restoring may also be
done after sweeping up loose dirt and dust. Follow directions for each product
accordingly.
This product meets the maximum content requirements for Volatile Organic
Compounds (VOCs) as established by state and Federal regulations.
PRODUCT SPECIFICATIONS
Type: Highly crosslinked Buffability: Spray buff or restorer
acrylic Removability: With instant type
strippers
20.0卤0.5%
Non-volatile solids:
Detergent Resistance: Excellent
Color: Milky white
Waterspot Resistance: Excellent
Odor: Mild
Heel Mark Resistance: Excellent
pH: 8.5 - 9.0
VOC Content: 0.35 lbs./gal.
Dry/Recoat Time: 45 minutes min.
Storage/Stability: 2 years
.5 min. by ASTM D2047
Slip Resistance:
Freeze/Thaw Stability: Keep from freezing
Gloss: 90+ specular
Weight per Gallon: 8.62 lbs./gal.
Leveling: Excellent
Coverage: 2000-2500 ft2 per gal.
Misco Products Corporation Reading, PA (800) 548-4568 FAX (610) 926-1194
www.miscoprod.com
XCE MATERIAL SAFETY DATA SHEET N/A=Not Applicable
Prepared by: Regulatory Affairs Dept. Effective Date: 5/99 Revision: n/a
(Prepared According to 29 CFR 1910.1200)
SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION
Product Name: X-Cel Plus
Manufacturer鈥檚 Name:
Misco Products Corporation Generic Name: Ultra High Wear Floor Finish
Manufacturer鈥檚 Address: Chemical Family: Acrylic Wax Blend
1048 Stinson Drive Reading, PA 19605 Formula: Proprietary
Manufacturer鈥檚 Phone #: (610) 926-4106
SECTION 2-INGREDIENT INFORMATION
CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV
Water 7732-18-5 to 100
Acrylic Copolymer Dispersion 63744-68-3 45 to 50
Resin Solution 65405-63-2 5 to 10
Polyethylene Wax 68441-17-8 5 to 10
Tributoxy Ethyl Phosphate 78-51-3 0 to 5
Diethylene Glycol Monomethyl Ether 111-77-3 0 to 5
SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): N/A
Boiling Point (掳F): 212 F. Specific Gravity: 1.035
Upper Explosion Limit: N/A Lower Explosion Limit: N/A
Vapor Pressure: 20mm Hg @ 68 F. Vapor Density (Air=1): >1
Extinguishing Media: N/A
% Volatile: 75+ pH: 8.5-9.0
Special Firefighting Procedures: Non Flammable
Solubility in Water: Complete Evaporation Rate (Water=1): <1
Unusual Fire and Explosion Hazards: N/A
Physical Description: Thin milky liquid with characteristic odor.
SECTION 5-REACTIVITY DATA
Stability: Stable Hazardous Polymerization: None
Hazards Decomposition Products: Will not occur. Incompatibility (Materials to Avoid): None
SECTION 6-STORAGE AND HANDLING INFORMATION
Keep out of reach of children. For use by trained personnel only. Keep unauthorized personnel away when applying to floor. Keep container closed during storage. For
institutional and industrial use only. Avoid contact with eyes, skin and clothing. Avoid breathing of vapors. Use in well-ventilated area.
SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION
Effects of Overexposure: Respiratory Protection: Use in well-ventilated area.
Skin: Prolonged or repeated contact may cause dermatitis. Ventilation Requirements: Provide local exhaust to keep TLV of Section 2 in-
Eyes: Eye irritant. May cause redness or swelling. gredients below acceptable limit.
Inhalation: Vapors may cause headache, dizziness, nausea. Protective Gloves: Chemical resistant rubber or neoprene.
Ingestion: May be irritating to the mouth, throat, and gastrointestinal system. Eye Protection: Safety glasses or chemical splash goggles
Vomiting and diarrhea expected with large doses. Other Protective Equipment: Protective foot wear (rubber boots) should be worn
when using product on floor.
First Aid Procedures: SECTION 9-SPILL OR LEAK PROCEDURES
Skin: Flush with water. Seek medical attention if irritation persists. Steps to be taken in Case Material is Released or Spilled: Floors will become
slippery. Avoid walking in product. Keep unessential personnel away. Mop up or
Eyes: Flush with large quantities of water, holding eyelids open. Seek medical
otherwise absorb and hold disposal. Avoid discharge to sewer or open waterways.
attention.
Waste Disposal Method: Any method in accordance with local, state and federal
Inhalation: Remove victim to fresh air and monitor.
laws. Best method is to recycle or reuse for intended purpose. Consult local
Ingestion: Dilute with 2 glasses of water. Seek medical attention if symptoms
authorities for disposal in public sewer. Do not dispose of into storm drain, stream,
persist.
river or to ground. Rinse container thoroughly before discarding in trash.
SECTION 10-REGULATORY INFORMATION
HMIS Hazardous Materials
SARA Title III - Section 311/312 -Hazard Categories: Shipping Information:
No - Fire Hazard FOR CONTAINERS > 1 Gallon : Liquid Floor Wax Identification System
No - Sudden Release of Pressure Hazard Health 1
No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Liquid Floor Wax Flammability 0
Yes - Immediate (acute) Health Hazard Reactivity 0
No - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Liquid Floor Wax Personal Protection A
FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act
of 1986 and of 40 CFR 372.
CAS# Chemical Name Percent by Weight
None
This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.
CAS# Chemical Name Percent by Weight
None
SECTION 11-OTHER INFORMATION
This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the
application of this information, or the safety and suitability of our products either alone or in combination with other products. It is the responsibility of the user to
provide a safe workplace, using the health and safety information contained herein as a guide. This company will accept no liability for damages or loss incurred from the
improper handling and use of this product
|