Wurth USA, Inc. Wurth USA, Inc. Wurth USA, Inc. Wurth USA, Inc.
1486 East Cedar St. 8501 Parkline Blvd. 385 Kimberly Dr. 93 Grant St.
Ontario, CA 91761 Orlando, FL 32809 Carol Stream, IL 60188 Ramsey, NJ 07446
(800) W眉rth US (800) W眉rth US (800) W眉rth US (800) W眉rth US
24-Hour Wurth MSDS Fax Hotline (201) 995-9905 or 1-888-WURTH-FAX
MATERIAL SAFETY DATA SHEET
DIVISION: Automotive
TRADE NAME: Rubberized Super Glue
PRODUCT NUMBER: 08934103 (Old Number 8934103)
DATE PREPARED: April 16, 2001
1. HAZARDOUS INGREDIENTS CAS# PERCENT OSHA PEL ACGIH TLV
Ethyl cyanoacrylate 7085-85-0 85-90 - -
Ethylene copolymer rubber 54545-50-5 5-10 - -
Carbon black 1333-86-4 1-3 3.5mg/m3 3.5mg/m3
Phthalic Anhydride 85-44-9 0.1-1 1PPM 6.1mg/m3 1PPM 6.0mg/m3
Hydroquinone 123-31-9 0.1-0.5 2mg/m3 2mg/m3
THIS PRODUCT CONTAINS THE FOLLOWING CHEMICALS SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION
313 TITLE III OF THE SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 & 40 CFR PART 372.
2. PHYSICAL AND CHEMICAL CHARACTERISTICS
BOILING POINT: VOLATILE ORGANICS: N/D
>300掳F
VAPOR DENSITY (AIR=1): Approx. 3 PERCENT VOLATILE: N/D
VAPOR PRESSURE (mm HG): PH: N/D
<2mm @ 80掳F
EVAPORATION RATE: N/D MELTING POINT: N/D
SOLUBILITY IN WATER: Polymerized by water VISCOSITY: N/D
SPECIFIC GRAVITY: APPEARANCE AND ODOR: Viscous, black liquid/
1.1 @ 80掳F
sharp/ irritating
3. FIRE AND EXPLOSION HAZARD
FLASHPOINT AND TEST METHOD USED: 150-200掳F TCC
FLAMMABLE LIMITS: LEL: N/A UEL: N/A
EXTINGUISHING METHOD: Dry chemical, foam, carbon dioxide
SPECIAL FIRE FIGHTING PROCEDURES: None
UNUSUAL FIRE AND EXPLOSION HAZARDS: None
NFPA HAZARD CLASS: HEALTH: 2 FIRE: 2 REACTIVITY: 1
4. REACTIVITY DATA
STABILITY: Yes
HAZARDOUS POLYMERIZATION: No
CONDITIONS TO AVOID: None
MATERIALS TO AVOID: None
HAZARDOUS DECOMPOSITION PRODUCTS: Irritating organic vapors
5. ENVIRONMENTAL DATA
SPILL RESPONSE: Flood with water to polymerize completely. Solid polymer is non hazardous
RECOMMENDED DISPOSAL: Dispose of in accordance with the EPA/RCRA
PRECAUTIONS TO BE TAKEN WHEN HANDLING OR STORING: Store at or below 75掳F. Avoid contact with eyes
and skin. Avoid breathing vapors.
Wurth USA, Inc. Wurth USA, Inc. Wurth USA, Inc. Wurth USA, Inc.
1489 East Cedar St. 8501 Parkline Blvd. 385 Kimberly Dr. 93 Grant St.
Ontario, CA 91761 Orlando, FL 32809 Carol Stream, IL 60188 Ramsey, NJ 07446
(800) 346-4198 (800) 829-8316 (800) 99-WURTH (800) 526-5228
24-Hour Wurth MSDS Fax Hotline (201) 995-9905 or 1-888-WURTH-FAX
MATERIAL SAFETY DATA SHEET 鈥? PAGE 2
PRODUCT NUMBER: 08934103 (Old Number 8934103)
6. CONTROL MEASURES
RESPIRATORY PROTECTION: None
VENTILATION: Positive down draft exhaust ventilation should be provided to maintain vapor concentration below TLV
PROTECTIVE GLOVES: Nitrile or polyethylene gloves
EYE PROTECTION: Safety glasses or goggles
OTHER PROTECTIVE MEASURES: Wear long sleeves and long pants. Do not smoke while using this product
7. HEALTH HAZARD DATA
ROUTE OF ENTRY:
INHALATION: X SKIN: X EYES: X INGESTION: X
HEALTH HAZARDS (acute & chronic): May cause dermatitis or asthma like symptoms in sensitive individuals
SIGNS AND SYMPTOMS OF EXPOSURE:
INHALATION: Difficulty in breathing
SKIN: Redness
EYES:
INGESTION: Vomiting
EMERGENCY FIRST AID PROCEDURES:
INHALATION: Remove to fresh air. If symptoms persist, obtain medical attention
SKIN CONTACT: Remove excess adhesive. Soak in warm, soap water. The adhesive will come loose from the skin in
several hours. Cured adhesive does not present a health hazard even when bonded to the skin. In case of skin adhesion,
first immerse the bonded surfaces in warm soapy water. Peel or roll the surfaces apart with the aid of a blunt edge, then
remove adhesive from skin with soap and water. Do not try to pull surfaces apart with a direst opposing action.
Cyanoacrylates give off heat on solidification. In rare cases a large drop will increase from the tissue as described above. It
should never be necessary to use surgery to separate accidentally bonded skin.
EYE CONTACT: In the event that eyelids are stuck together or bonded to the eyeball, wash thoroughly with warm water
and apply a gauze patch. The eye will open without further action, typically in 1-4 days; there will be no
residual damage. Do not try to open the eyes by manipulation. Cyanoacrylate introduced into the eyes
will attach itself to the eye protein and will disassociate from it over intermittent periods, generally
covering several hours. This will cause periods of weeping until clearance is achieved. During the period
of contamination, double vision may be experienced together with a lachrymatory effect, and it鈥檚
important to understand the cause and realize that disassociation will normally occur within a matter of
hours, even with gross contamination
IF SWALLOWED: If lips are accidentally stuck together, apply lots of warm water to the lips and encourage maximum
wetting and pressure from saliva inside the mouth. Saliva will lift the adhesive in one half to two
days. In case a lump forms in the mouth, position the patient to prevent ingestion of the lump when it
detaches
MEDICAL CONDITIONS GENERALLY AGGRAVATED DUE TO EXPOSURE:
CARCINOGENIC:
NPT?*** IARC MONOGRAPHS*** OSHA REGULATED***
*** NOT PRESENTLY ON ANY LIST
ABBREVIATIONS - N/D 鈥? Not Determined N/A 鈥? Not Applicable
THE ABOVE INFORMATION PERTAINS TO THIS PRODUCT AS CURRENTLY FORMULATED, AND IS BASED ON THE
INFORMATION AVAILABLE AT THE TIME. ADDITION OF REDUCERS OR OTHER ADDITIVES TO THIS PRODUCT MAY
SUBSTANTIALLY ALTER THE COMPOSITION AND HAZARDS OF THE PRODUCT. SINCE CONDITIONS OF USE ARE
OUTSIDE OF THEIR CONTROL, WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED. AND ASSUME NO LIABILITY IN
CONNECTION WITH ANY OF THIS INFORMATION.
|