MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name INK TYPE B/HD NT
360
MSDS Number
ITW TRANS TECH
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
BISPHENOL-A-EPOXIRESIN 25068-38-6 10 - 25 % ND
CYCLOHEXANONE 108-94-1 1-5% ACGIH TLV: 100 mg/m3
1-METHOXYPROPYLACETATE-2 108-65-6 10 - 25 % ND
BUTYL GLYCOL ACETATE 112-07-2 10 - 25 % N/A
SOLVENT NAPHTHA 150 64742-94-5 1-5% ND
XYLENE 1330-20-7 1-5 ACGIH TLV: 435mg/m3
3 HAZARDS IDENTIFICATION
Potential Health Effects, Skin
Skin contact may lead to degreasing with resultant dry skin, cracking, irritation and dermatitis.
Potential Health Effects, Eye
Eye contact causes irritation, redness, tearing, blurred vision. Vapors may cause severe eye irritation, redness, tearing
and blurred vision.
Potential Health Effects, Inhalation
Excessive inhalation of vapors can cause nasal, throat and respiratory irritation, dizziness, weakness, fatigue, nausea,
headache and possible unconsciousness. Excessive vapor concentration in air, especially in confined spaces, may cause
asphyxiation.
Potential Health Effects, Ingestion
Swallowing may cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Signs & Symptoms of Short-Term (Acute) Exposure
Excessive vapor concentration in air, especially in confined spaces, may cause asphyxiation. Excessive inhalation of
vapors can cause nasal, throat and respiratory irritation, dizziness, weakness, fatigue, nausea, headache and possible
unconsciousness. Eye contact causes irritation, redness, tearing, blurred vision. Eye contact with liquid or vapor causes
severe irritation, redness, tearing, blurred vision. Vapors may cause severe eye irritation, redness, tearing and blurred
vision. Prolonged skin contact may lead to extraction of natural oils with resultant dry skin, cracking, irritation and
determatitis. Swallowing may cause gastrointestinal irritation, nausea, vomiting and diarrhea. Notice: intentional misuse by
deliberately concentrating and inhaling the contents maybe harmful or fatal.
Printed On 16-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
360 INK TYPE B/HD NT
Material Id Trade Name 1/ 4
Effects of Long-Term (Chronic) Exposure
Health studies have shown that many solvents pose potential human health risks which may vary from person to person.
As a precaution, exposure to liquids and vapors should be minimized. -Prolonged or continuous inhalation of vapors may
result in delayed lung damage. -Repeated or prolonged inhalation of vapor may cause liver and kidney damage. -Repeated
inhalation of vapor in high concentration can change the blood picture.
4 FIRST AID MEASURES
Skin
Wash skin with plenty of soap and water.
Eye
Remove contact lenses, keep eyelids open. Flush with plenty of water (10-15 minutes). Call a physician.
Inhalation
Take the casualty into the fresh air and keep warm. Irregular breathing/no breathing: artificial respiration. Call a
physician.
Ingestion
Do not induce vomiting. Call a physician. Keep at rest.
5 FIRE FIGHTING MEASURES
Extinguishing Media
Suitable: alcohol resistant foam, CO2, powders, water spray.
Not suitable: water jet
Basic Fire Fighting Procedures
Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard. Appropriate
breathing apparatus may be required.
Unusual Fire & Explosion Hazards
Cool endangered containers with water in case of fire. Do not allow the quenching water into the sewage system.
43 潞C
Flash Point
6
Flammability Limits in Air, Lower, % by Volume
10
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Environmental Precautions
Do not empty into drains. If the product contaminates lakes, rivers or sewer systems, inform appropriate authorities in
accordance with local regulations.
Spill or Leak Procedure
Remove sources of ignition. Ventilate area. Contain and collect spillage with non-combustible absorbent materials, e.g.
sand, earth, vermiculite, diatomaceous earth and place in container for disposal according to local regulations. Clean
preferably with a detergent. Avoid use of solvents.
7 HANDLING & STORAGE
Handling
Prevent the creations of flammable or explosive concentration of dust in air and avoid dust concentration higher then the
occupational exposure limits. Additionally, the product should only be used in areas from which all naked lights and other
sources of ignition have been excluded. Comply with the health and safety at work laws.
Vapors are heavier than air and may spread along floors. Vapors may form explosive mixtures with air. Preparation may
charge electrostatically; always use earthing leads when transferring from one container to another. Operators should
wear anti static footwear and clothing. No sparking tools should be used.
Printed On 16-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
360 INK TYPE B/HD NT
Material Id Trade Name 2/ 4
Storage
Containers which are opened must be carefully resealed and kept upright to prevent leakage. Keep container tightly closed.
Never use pressure to empty: container is not a pressure vessel. No smoking. Prevent unauthorized access.
Keep away from oxidizing agents, from strongly alkaline and strongly acid materials. Always keep in containers of same
material as the original one. Avoid heating and direct sunlight.
Ventilation
Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation
and good general extraction. If these are not sufficient in maintaining concentrations of particles and solvent vapor below
the OEL, suitable respiratory protection must be worn.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Personal Protection Equipments (PPE)
Safety glasses
Skin Protection: Personal Protection Equipments (PPE)
Protective gloves. After washing hands, replace lost skin fat by fat containing skin creams.
Respiratory Protection: Personal Protection Equipments (PPE)
If workplace limits are exceeded, a gas mask approved for this particular job must be worn.
General
Personal should wear antistatic clothings made of natural fiber or of high temperature resistant synthetics fiber. All parts of
the body should be washed after contact.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Colorless paste with odor of organic solvents.
137 - 215 潞C
Boiling Point
1.1 - 1.7 (H2O=1)
Specific Gravity
n.a.
Melting Point
30 - 50 %
Percent Volatile
10
Vapor Pressure
n.a. (Butyl Acetate=1)
Evaporation Rate
>1
Vapor Density
no
Solubility In Water
10 STABILITY & REACTIVITY
Stability/Incompatibility
Stable under recommended storage and handling conditions
Materials to Avoid: Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid
exothermic reactions.
Hazardous Reactions/Decomposition Products
When exposed to high temperatures may produce hazardous decomposition products such as carbon monoxide and
dioxide, smoke, oxides of nitrogen.
Hazardous Polymerization
none.
Printed On 16-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
360 INK TYPE B/HD NT
Material Id Trade Name 3/ 4
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Inhalation, ingestion, skin and eye contact.
12 ECOLOGICAL INFORMATION
EcoToxicological Information
If the product contaminates lakes, rivers or sewer systems, inform appropriate authorities in accordance with local
regulations.
13 DISPOSAL CONSIDERATIONS
Waste Disposal
Dispose of in accordance with federal, state, and local pollution control requirements.
14 TRANSPORT INFORMATION
Department of Transportation (DOT) Requirements:
General Transportation Information for Bulk Shipments
Proper Shipping Name Paint Related Material
Hazard Class Flammable liquid - Class II UN/NA Code 1263
Labels Required Flammable liquid
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 2 Flammability 2 Reactivity 1 Personal Prot. Equip. C
16 OTHER INFORMATION
Disclaimer
This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of ITW
Trans Tech. The data on this sheet applies only to the specific material designated herein. ITW Trans Tech. assumes no
legal responsibility for use of reliance upon this data.
6/16/2008 6/26/2007
Replaces Sheet Dated
Completed On
Completed By
Printed On 16-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
360 INK TYPE B/HD NT
Material Id Trade Name 4/ 4
|