MATERIAL SAFETY DATA SHEET PROSOCO, Inc.
I PRODUCT IDENTIFICATION
MANUFACTURER鈥橲 NAME PROSOCO, Inc. EMERGENCY TELEPHONE NUMBERS:
AND ADDRESS: 3741 Greenway Circle 8:00 AM 鈥? 5:00 PM CST Monday-Friday: 785/865-4200
Lawrence, KS 66046 NON-BUSINESS HOURS (INFOTRAC): 800/535-5053
庐
PRODUCT TRADE NAME: Conservare HCT Finishing Rinse
II HAZARDOUS INGREDIENTS
ACGIH
CHEMICAL NAME (COMMON NAME) CAS NO. NFPA CODE OSHA PEL/TWA
TLV/TWA
Contains no hazardous ingredients greater than 1%.
III PHYSICAL DATA
VAPOR
BOILING POINT VAPOR DENSITY EVAPORATION RATE
PRESSURE
(掳F) (Air = 1) (Butyl Acetate = 1)
(mm Hg)
Contains no hazardous ingredients greater than 1%.
SPECIFIC SOLUBILITY APPEARANCE AND
pH
GRAVITY IN WATER ODOR
Clear liquid, slight
Conservare HCT Finishing Rinse 1.000 12.4 >99.50%
powder sediment
IV FIRE AND EXPLOSION HAZARD DATA
EMERGENCY OVERVIEW
庐
Conservare HCT Finishing Rinse is a clear liquid with a slight powder sediment. Contact with the eyes or skin may result in irritation.
Always wear appropriate personal protective equipment when using this product.
FLASH POINT (METHOD): Not applicable.
FLAMMABLE LIMITS: Not applicable.
EXTINGUISHING MEDIA: Not applicable.
SPECIAL FIRE FIGHTING PROCEDURES: None.
UNUSUAL FIRE AND EXPLOSION HAZARDS: There are no known unusual fire or explosion hazards.
V HEALTH HAZARD DATA
PRIMARY ROUTES OF EXPOSURE: Skin, eyes, ingestion.
CARCINOGEN INFORMATION: Not listed (OSHA, IARC, NTP).
MEDICAL CONDITIONS AGGRAVATED BY OVEREXPOSURE: No applicable information found.
EFFECTS OF OVEREXPOSURE: No harmful effects have been reported.
EYE CONTACT: May cause irritation.
SKIN CONTACT: May cause irritation.
INHALATION: No harmful effects from exposure are expected. Direct contact with mists may irritate mucous membranes.
INGESTION: No harmful effects have been reported.
EMERGENCY AND FIRST AID PROCEDURES:
EYE CONTACT: If in eyes, flush with large amounts of water for 15 minutes, holding eyelids apart to ensure flushing of the entire eye
surface. If persistent irritation occurs, get medical attention.
SKIN CONTACT: Wash exposed area with water. Remove contaminated clothing. If persistent irritation occurs, get medical attention.
INHALATION: No harmful effects expected from exposure are expected.
INGESTION: No harmful effects are expected due to ingestion.
VI REACTIVITY DATA
STABILITY: Stable.
CONDITIONS TO AVOID: None.
INCOMPATIBILITY (MATERIALS TO AVOID): None.
HAZARDOUS COMBUSTION OR DECOMPOSITION PRODUCTS: Unknown.
VII SPILL OR LEAK PROCEDURES
SPILL, LEAK, WASTE DISPOSAL PROCEDURES: Control spill with absorbent pads or brooms. If necessary, apply granular or
loose sorbent to spill. When absorbed, sweep or otherwise collect and dispose of properly. Floors may be slippery, care
should be exercised to avoid falls.
WASTE DISPOSAL METHODS: Dispose of in a manner approved for this material. This material is not classified as hazardous under
federal regulations, however, federal law does prohibit disposal of any liquid materials in a sanitary landfill. Solidify cleanup
residuals before disposal. After minor pH modification, liquid residuals may be rinsed into a sanitary sewage drain.
Empty containers must not be reused. Drain all liquid possible from the container before disposal in a sanitary landfill.
庐
Conservare HCT Finishing Rinse - Page 2 of 4
VIII SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: Wear a NIOSH approved dust/mist respirator as needed to avoid unnecessary contact to mists during
application.
VENTILATION: No special ventilation required.
PROTECTIVE CLOTHING: Wear protective clothing such as long sleeved work shirt and pants, work boots, and rubber gloves to
avoid skin contact. Do not allow clothing to become saturated with product. If work practices cannot be adjusted to avoid
excess clothing saturation, splash resistant or Tyvek clothing and boots may be required.
PROTECTIVE GLOVES: Wear liquid resistant gloves as necessary to avoid prolonged skin contact.
EYE PROTECTION: Safety glasses with side shields are recommended. If work practices and application techniques cause a risk of
splashing or excessive wind-drift, then splash resistant goggles may be required.
OTHER PROTECTIVE EQUIPMENT: Access to an eyewash is recommended.
IX SPECIAL PRECAUTIONS
WORK PRACTICES: Proper work practices and planning should be utilized to avoid contact with workers, passersby, and non-
masonry surfaces. Do not atomize during application. Beware of wind drift. . Always follow published application rates. See
the Product Data sheet and label for specific precautions to be taken during use. Smoking, eating and drinking should be
prohibited during the use of this product. Wash hands before breaks and at the end of a shift.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Wear appropriate safety equipment and clothing. Do not get in
eyes, on skin, or clothing. Do not take internally. Avoid breathing mist. Never touch face with hands or gloves that may be
contaminated with this product.
Store in a cool, dry, well-ventilated place. Keep containers tightly closed when not dispensing product. Use care around
spilled material because it will be slippery.
OTHER PRECAUTIONS: None known.
X REGULATORY INFORMATION
SHIPPING: This material is non-hazardous for shipping via domestic or international ground or air transport.
NATIONAL MOTOR FREIGHT CLASSIFICATION: #149980 Sub 2 Rate Class: 55
SARA 313 REPORTABLE:
CHEMICAL NAME CAS UPPERBOUND CONCENTRATION % BY WEIGHT
CALIFORNIA PROPOSITION 65: This product contains no substances listed under California's Proposition 65.
RCRA Waste Classification: This product is not classified as a hazardous waste under federal regulations.
XI OTHER
MSDS Status: Date of Revision: May 15, 2001
For Product Manufactured After: N/A 鈥? no change in formulation
Changes: Included Emergency Overview section, updated information in sections IV, V, and IX.
Item #: 42042
Approved By: Regulatory Department
庐
Conservare HCT Finishing Rinse - Page 3 of 4
DISCLAIMER:
The information contained on the Material Safety Data Sheet has been compiled from data considered accurate. This data is
believed to be reliable, but it must be pointed out that values for certain properties are known to vary from source to source.
PROSOCO, Inc. expressly disclaims any warranty express or implied as well as any liability for any injury or loss arising from
the use of this information or the materials described. This data is not to be construed as absolutely complete since additional
data may be desirable when particular conditions or circumstances exist. It is the responsibility of the user to determine the
best precautions necessary for the safe handling and use of this product for his unique application. This data relates only to
the specific material designated and is not to be used in combination with any other material. Many federal and state
regulations pertain directly or indirectly to the product's end use and disposal of containers and unused material. It is the
purchaser's responsibility to familiarize himself with all applicable regulations.
DATE OF PREPARATION: May 15, 2001
庐
Conservare HCT Finishing Rinse - Page 4 of 4
|