MATERIAL SAFETY DATA SHEET PROSOCO, Inc.
I PRODUCT IDENTIFICATION
MANUFACTURER鈥橲 NAME EMERGENCY TELEPHONE NUMBERS:
PROSOCO, Inc.
AND ADDRESS: 8:00 AM 鈥? 5:00 PM CST Monday-Friday:
3741 Greenway Circle 785-865-4200
NON-BUSINESS HOURS (INFOTRAC):
Lawrence, KS 66046 800/535-5053
庐
PRODUCT TRADE NAME: Enviro Klean Safety Klean
II HAZARDOUS INDREDIENTS
CHEMICAL NAME (COMMON NAME) CAS NO. NFPA CODE ACGIH TLV/TWA OHSA PEL/TWA
Proprietary Organic Salt* (None) Not Available 1,0,1,B Not Established Not Established
Cationic surfactant Cationic surfactant Not Available Not Available Not Established Not Established
*Specific chemical identity withheld as a trade secret pursuant to OSHA regulations.
III PHYSICAL DATA
VAPOR
BOILING POINT VAPOR DENSITY EVAPORATION RATE
PRESSURE
(掳F) (1=Air) (1 = Ethyl ether)
(mm Hg)
Proprietary Organic Salt Not Available Not Available Not Available
212飩癋
Cationic surfactant Not Available Not Available >1.0 >1.0
SPECIFIC SOLUBILITY APPEARANCE AND
GRAVITY IN WATER ODOR
Clear, amber liquid, clean
庐
1.15 100%
Enviro Klean Safety Klean odor
IV FIRE AND EXPLOSION HAZARD DATA
EMERGENCY OVERVIEW
庐
Enviro Klean Safety Klean is an amber-colored liquid with a clean-smelling odor. Wear splash-proof chemical goggles when handling
this product. Product may cause burns to eyes when in direct contact.
FLASH POINT (METHOD): Does not ignite. (ASTM D 3278)
FLAMMABLE LIMITS: Unknown
EXTINGUISHING MEDIA: Any media appropriate for surrounding the type of fire involving this product.
SPECIAL FIRE FIGHTING PROCEDURES: Wear NIOSH/MSHA approved self-contained breathing apparatus with a full face piece
operated in pressure demand or other positive pressure mode and full body protective clothing when fighting fires. Water may
be used to cool closed containers.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Contact with most metals at temperatures above 140 degrees F may cause reaction
and release of hydrogen gas, which can form explosive mixtures with air. Extinguish all nearby sources of ignition.
庐
Enviro Klean Safety Klean 鈥? Page 1 of 4
V HEALTH HAZARD DATA
PRIMARY ROUTES OF EXPOSURE: Ingestion, skin, eyes.
CARCINOGEN INFORMATION: Not listed (IARC, NTP or ACGIH).
MEDICAL CONDITIONS AGGRAVATED BY OVEREXPOSURE: None known.
EFFECTS OF OVEREXPOSURE: None known.
EYE CONTACT: Causes burns to the eyes. Liquid or concentrated vapors can cause eye irritation, severe burns and permanent
damage including blindness even after a short exposure to small amounts.
SKIN CONTACT: Prolonged or repeated contact with liquid can cause irritation.
INHALATION: Not a likely route of exposure due to physical properties of product. Product has a low vapor pressure at room
temperature and is not expected to present a significant inhalation hazard under ambient conditions. Product can be irritating to
the respiratory tract if inhaled as a mist or if the material vaporized.
INGESTION: Unlikely route of exposure. This product may be harmful or fatal if ingested.
EMERGENCY AND FIRST AID PROCEDURES:
EYE CONTACT: Rinse eyes with large quantities of water for at least 15 minutes, holding eyelids apart to ensure flushing of the entire
eye surface. Get medical attention immediately.
SKIN CONTACT: Remove contaminated clothing and flush exposed area with large quantities of water for at least 15 minutes. Launder
contaminated clothing before reuse. Discard contaminated shoes. Get immediate medical attention.
INHALATION: Remove person to fresh air. If breathing stops, administer artificial respiration, preferably mouth-to-mouth. If breathing is
difficult, give oxygen. Get medical attention immediately.
INGESTION: If conscious, give large quantities of water or milk. Do NOT induce vomiting. Get medical attention immediately. Do not
give anything by mouth to an unconscious or convulsing person.
VI REACTIVITY DATA
STABILITY: Normally Stable
CONDITIONS TO AVOID: Avoid excessive heat for prolonged periods of time. Contact with strong bases (alkali), can cause violent
reaction generating large amounts of heat.
INCOMPATIBILITY (MATERIALS TO AVOID): Metals, oxidizing agents, nitric acid, chlorates, sulfides, and cyanides. Contact with
sulfides releases poisonous flammable hydrogen sulfide.
HAZARDOUS COMBUSTION OR DECOMPOSITION PRODUCTS: Fire creates: Carbon monoxide (CO) and Carbon Dioxide (CO2)
Hydrogen gas when contacting metals, hydrogen chloride, carbon monoxide and carbon dioxide. Hydrogen gas generation has
the highest potential for harm in confined or poorly ventilated areas where concentrations can approach flammable or explosive
concentrations.
VII SPILL OR LEAK PROCEDURES
SPILL, LEAK, WASTE DISPOSAL PROCEDURES: Follow all precautionary instructions. Supply adequate ventilation. Contain with
inert material and prevent from reaching drains, sewers and surface waters. Dilute with water and neutralize with baking soda,
lime or other alkaline compound. Collect for disposal. Clean up remaining materials from spill with suitable absorbent.
WASTE DISPOSAL METHODS: Product as supplied is classified as a hazardous waste for the characteristic of corrosivity. Recovered
solids or liquids may be disposed of in a permitted waste management facility. Neutralized materials may be discharged to a
sanitary sewer with approval of the receiving treatment plant. Typical pH range of 6-10 is generally considered appropriate for
discharge. Consult federal, state, and/or local authorities for approved procedure. For additional information regarding handling
and disposal of rinse-water, please review Technical Bulletin 200-CW 鈥淐ontrolled Handling of Cleaning Wastewater鈥?. Empty
containers must be triple rinsed before disposal in a permitted sanitary landfill. Check local restrictions. Empty container should
be rinsed with water to remove all residue before disposal.
庐
Enviro Klean Safety Klean 鈥? Page 2 of 4
VIII SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: Not normally needed if good ventilation is maintained. Wear a NIOSH approved dust/mist respirator
when mists are present.
VENTILATION: Product has low vapor pressure and is not expected to evolve vapors. Provide sufficient general and/or local exhaust
ventilation when mists are present or if working in enclosed spaces.
PROTECTIVE CLOTHING: Wear splash resistant neoprene or PVC rain suit as needed to prevent prolonged skin contact. Wear splash
boots as needed.
PROTECTIVE GLOVES: Nitrile rubber type, neoprene or PVC with acceptable acid resistance.
EYE PROTECTION: Chemical splash goggles and/or full face shield (8 inch minimum) in compliance with OSHA regulations. Do not
wear contact lenses because they may contribute to the severity of an eye injury.
OTHER PROTECTIVE EQUIPMENT: Acid-resistant rubber boots, headgear. An eyewash should be accessible to the work area.
Supply fresh water for rinsing skin.
IX SPECIAL PRECAUTIONS
WORK PRACTICES: Proper work practices and planning should be utilized to avoid contact with workers, passersby, and non-masonry
surfaces. Brush on or apply at the lowest practical pressure. Do not atomize during application. Application equipment,
scaffolding, swing stages and support systems must be constructed of acid resistant materials. Use only well maintained
staging and scaffolding that is equipped with steel cable. Use polypropylene ropes and safety lines. Dilution and application
equipment should be of polypropylene or HDPE construction. Beware of wind drift. Wind-drift hazards may be diminished by
pre-rinsing with low-pressure water before pressure washing. Divert pedestrian traffic around work areas. See the Product
Data sheet and label for specific precautions to be taken during use. Smoking, eating and drinking should be discouraged
during the use of this product. Wash hands after handling or use.
This product is only to be used as supplied and specified. Do not alter, mix with chlorine-type bleaches or other chemicals,
or dilute product except as specified on the label and Product Data sheet.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Use proper safety equipment (see section VIII) when handling. Store
in a cool, well-ventilated area. Separate from oxidizing agents, nitric acid, alkalis, chlorates, sulfides, etc. (see section VI). Do
not remove product label. Material diluted for application must be properly labeled and stored in acid-resistant containers with
rubber-lined steel, polypropylene or polyethylene construction..
Addition of acidic cleaner to water releases heat, which can result in violent boiling and spattering. Always add cleaner to water
slowly and in small amounts. Never use hot water. Never add water to acidic cleaners.
X REGULATORY INFORMATION
SHIPPING: This product is classified as hazardous for shipment by all modes of transport. The Proper Shipping Description is UN3265,
Corrosive Liquid, Acidic, Organic, N.O.S., (Contains Urea Salts), 8, III. Case quantities of 1-gallon, 1-quart and 1-pint
containers are classified as ORM-D Consumer Commodity for domestic ground shipment only. Shipment by air may be
restricted or require special packaging.
SARA 313 REPORTABLE:
CHEMICAL NAME CAS UPPERBOUND CONCENTRATION % BY WEIGHT
None
CALIFORNIA PROPOSITION 65: This product contains no chemicals listed under California鈥檚 Proposition 65.
庐
Enviro Klean Safety Klean 鈥? Page 3 of 4
XI OTHER
MSDS Status: Date of Revision: April 18, 2007
For Product Manufactured After: N/A 鈥? No product reformulation
Changes: Updated Shipping Description (Section X) for DOT Regulation Compliance
Item #: 41035
Approved By: Regulatory Department
DISCLAIMER:
The information contained on the Material Safety Data Sheet has been compiled from data considered accurate. This data is
believed to be reliable, but it must be pointed out that values for certain properties are known to vary from source to source.
PROSOCO, Inc. expressly disclaims any warranty express or implied as well as any liability for any injury or loss
arising from the use of this information or the materials described. This data is not to be construed as absolutely complete
since additional data may be desirable when particular conditions or circumstances exist. It is the responsibility of the user to
determine the best precautions necessary for the safe handling and use of this product for his unique application. This data
relates only to the specific material designated and is not to be used in combination with any other material. Many federal and
state regulations pertain directly or indirectly to the product's end use and disposal of containers and unused material. It is the
purchaser's responsibility to familiarize himself with all applicable regulations.
DATE OF PREPARATION: April 18, 2007
庐
Enviro Klean Safety Klean 鈥? Page 4 of 4
|