MATERIAL SAFETY DATA SHEET
Product Name:
LPG (3560)
SECTION 1 鈥? PRODUCT IDENTIFICATION AND USE
Product name PIN (UN #)
Liquefied petroleum gas (LPG) 1075
Chemical name TDG, DOT class
Liquefied petroleum gas (LPG) 2.1
Common names Packing group
Liquefied petroleum gas (LPG) None
and synonyms Shipping name
Compressed petroleum gas Liquefied petroleum gases;
Product use Fuel, chemical intermediate Or petroleum gases, liquefied
WHMIS classification Compressed Gas Class A
Flammable Gas Class B, Division
Hazard codes NFPA Health HMIS Health
1 1
Flammability 4 Flammability 4
Reactivity 0 Reactivity 0
NFPA & HMIS Ratings: 0=Insignificant/No Hazard. 1=Slight Hazard. 2=Moderate Hazard. 3=High/Serious Hazard. 4=Extreme/Severe Hazard.
Supplier Phone
Irving Oil Limited, Refining Division (506) 202-2000
Emergency
Box 1260, Saint John 1-800-424-9300
(Chemtrec)
Refinery
New Brunswick (506) 202-3000
Canada E2L 4H6
SECTION 2 鈥? HAZARDOUS INGREDIENTS
Ingredients CAS# Wt % ACGIH-TLVs OSHA PELs NIOSH RELs LD50 LC50
(2004) (2004) (2004) (rat, oral) (rat, 4 hr)
658 mg/m 3
LPG, which includes: 106-97-8 100 1000 ppm TWA NAv 800 ppm TWA NAp
Propane 74-98-6 95-100 1000 ppm TWA 1000 ppm TWA 1000 ppm TWA NAp NAv
658 mg/m 3
Butanes 106-97-8 <5 1000 ppm TWA NAv 800 ppm TWA NAp
SECTION 3 鈥? PHYSICAL DATA
853 kPa (8.4 atm) at 21oC
Form Vapour
Gas. May be liquefied by pressurization
pressure rate NAp (gas)
Colour Evaporation
Colourless
-40o to 80 o C (-40 to 176oF)
Odour Boiling point
Very faint petroleum odour
22,000 to 36,000 mg/m 3 -190oC (-310oF) (propane)
Odour Freezing point
threshold
Specific gravity PH
0.5 @ 20潞C NAp
Vapour density Coefficient of water/oil
1.55 (air = 1) 2.36 [log P (oct)]
distribution
SECTION 4 - FIRE AND EXPLOSION HAZARDS
Conditions
Yes No Extremely flammable, explosive gas is released when liquid evaporates.
Flammability
o o
450oC (842oF)
Auto ignition
-104 C (-156 F) (cc)
Flash point
temperature
1.8-1.9% (butane) 9.5%
Lower flammable limit Upper flammable limit
Impac Not considered Static Accumulates static charge by flow or agitation. Ignites in
Explosion data. Sensitivity
to: t to be sensitive discharge response to static charge of sufficient energy.
Means of extinctionStop flow. CO2 or dry chemical
Special precautions It is extremely dangerous to extinguish fire without stopping flow of gas. Gas and air will mix; resultant
explosion could be more destructive than the original fire.
Gas is slightly heavier than air. It may travel a considerable distance to a source of ignition and flash
back to a leak. Can accumulate in confined spaces, resulting in an explosion and/or asphyxiation
hazard. Heating can cause rapid build-up of pressure inside containers, which may rupture
explosively.
Hazardous combustion Smoke. Carbon dioxide. Carbon monoxide.
products
SECTION 5 鈥? REACTIVITY INFORMATION
The information contained in this form is based on data from sources considered to be reliable but Irving Oil Limited does not guarantee the accuracy or completeness thereof. The information is
provided as a service to the persons purchasing or using the material to which it refers and Irving Oil Limited expressly disclaims all liability for loss or damage including consequential loss or for
injury to persons including death. The information shall not be reproduced, published or distributed in any manner without prior consent in writing of Irving Oil Limited
Page 1 of 3
MATERIAL SAFETY DATA SHEET
Product Name:
LPG (3560)
Stability Stable
Conditions to avoid Sources of ignition. Static discharges. High temperatures.
Incompatible May react with strong oxidizing materials.
substances
Hazardous decomposition Carbon dioxide. Carbon monoxide.
products
SECTION 6 鈥? HEALTH HAZARD INFORMATION
Route of Entry Eye Hazardous Contact Eye
Skin absorption ( w ith liquid form) Skin Contact
Inhalation
Ingestion
Acute exposure Contact with liquid will cause freeze injury to eyes or skin. High gas concentrations (% range) can
cause asphyxiation by displacing air and thereby reducing the oxygen available for breathing.
Symptoms include rapid breathing, fatigue, incoordination, excessive salivation, headache, nausea,
vomiting and disorientation. Oxygen concentrations in work spaces must not be permitted to fall below
19%.
Very high concentrations (10,000 ppm) can cause central nervous system (CNS) depression with
symptoms such as headache, nausea, dizziness, drowsiness and confusion.
Chronic Not known to cause chronic effects.
exposure
Carcinogenicity Irritancy Does not cause irritation
Not known to cause cancer. Not identified
by OSHA as a carcinogen. Not classified
by IARC, NTP, NIOSH, ACGIH, or EPA.
Mutagenicity Sensitization Not known to cause sensitization
Not known to be mutagenic
Teratogenicity Reproductive Not known to cause reproductive effects
NAv
toxicity
Toxicologically synergistic
Simple asphyxiants (chemicals that displace air in confined spaces).
products
SECTION 7 鈥? FIRST AID
Inhalation Move affected person to fresh air or remove source of contamination. Give artificial respiration if breathing has
stopped and if a qualified AR administrator is available. Obtain medical attention immediately.
Ingestion Gases do not enter the body by this route.
Eye Flush eye with lukewarm, gently flowing fresh water for at least 15 min. Do not attempt to re-warm. Cover both
eyes with sterile dressing. Do not permit affected person to drink alcohol or smoke. Quickly transport affected
person to an emergency medical facility.
Skin Briefly flush the affected area with lukewarm, gently flowing water until the chemical is removed. Do not
attempt to re-warm the affected area. Do not rub the affected area or apply dry heat. Carefully cut around
clothing that sticks to the skin and remove the remainder of the garment. Loosely cover the affected area with
a sterile dressing. Do not permit affected person to drink alcohol or smoke. Quickly transport affected person
to an emergency medical facility.
SECTION 8 鈥? PRECAUTIONARY MEASURES
Personal Gloves Insulated; preferably nitrile or Responder鈩?
Protective Eye Chemical safety glasses with face shield for working with the liquid product.
Equipment Respiratory NIOSH-approved SCBA or air line respirator with escape cylinder for work in confined
spaces where oxygen deficiency may occur. A qualified occupational health and safety
professional should be consulted for advice on respirator selection.
Clothing & Impervious protective clothing for total skin coverage when working with liquid product.
footwear
Engineering Enclose product to the greatest extent possible. Use appropriate measures to ensure that oxygen
controls concentrations do not fall below 19%.
Handling Eliminate all ignition sources. Use non-sparking equipment, explosion-proof ventilation systems, and
procedures & intrinsically safe electrical equipment. Bond and ground containers during product transfer. Have clean
equipment emergency eyewash and shower readily available in the work area.
Leak & spill Evacuate area and keep it isolated until all gas has dispersed. Eliminate all sources of ignition. Ventilate
procedure area. Stop leak if it can be done safely. Water spray may be used to dissipate gas.
The information contained in this form is based on data from sources considered to be reliable but Irving Oil Limited does not guarantee the accuracy or completeness thereof. The information is
provided as a service to the persons purchasing or using the material to which it refers and Irving Oil Limited expressly disclaims all liability for loss or damage including consequential loss or for
injury to persons including death. The information shall not be reproduced, published or distributed in any manner without prior consent in writing of Irving Oil Limited
Page 2 of 3
MATERIAL SAFETY DATA SHEET
Product Name:
LPG (3560)
Waste disposalConsult local authorities. Controlled release to air may be permitted in certain situations.
Storage Store in a cool, well-ventilated area. Keep away from strong oxidizing materials, excessive heat, and
sources of ignition. Use non-sparking equipment, and explosion-proof ventilation systems. Consider leak
detection and alarm equipment for storage area.
Load at normal temperature (up to 38oC) and pressure. Bond and ground containers for transfer.
Shipping
SECTION 9 鈥? PREPARATION DATE OF MSDS
Prepared by Phone
Irving Oil Limited, Refining Division (506) 202-3000
Revision date To re-order MSDS,
July 27, 2005 (506) 202-2000
phone
The information contained in this form is based on data from sources considered to be reliable but Irving Oil Limited does not guarantee the accuracy or completeness thereof. The information is
provided as a service to the persons purchasing or using the material to which it refers and Irving Oil Limited expressly disclaims all liability for loss or damage including consequential loss or for
injury to persons including death. The information shall not be reproduced, published or distributed in any manner without prior consent in writing of Irving Oil Limited
Page 3 of 3
|