SECTION 1 - PRODUCT IDENTIFICATION AND USE
Hydraulic Safety Fluid - PO
Product Name:
Hydraulic systems fluid, other than petroleum.
Product Class:
Not Controlled
WHMIS Classification:
Irving Oil (506) 632-2000
Supplier Name and Address: Phone:
10 Sydney Street (506) 648-3060
Emergency:
Saint John, NB
E2L 4K1
SECTION 2 - HAZARDOUS INGREDIENTS OF MATERIALS
Hazardous Ingredients CAS#
Exposure limits have not been established for any of the components in this product. See section V for health hazard information
SECTION 3 - PHYSICAL DATA AND CHEMICAL PROPERTIES
o
Liquid > 500
Form: Boiling Point @ 1 atm.( C):
Clear light amber fluid N/A
Colour: pH Neat:
Bland odour. N/A
Odour: % Volatile by volume:
o
.92 NIL
Specific Gravity @ 15 C: Vapour Pressure (mm Hg):
Insoluble >1
Solubility in Water Vapour Density (Air = 1):
< 0.1.
Evaporation Rate:
SECTION 4 - FIRE AND EXPLOSION HAZARD
Yes 鈱? No
Flammability: Conditions:
510 Degrees F.
Flash Point :
Cleveland Open Cup
Not applicable. Not applicable.
Upper Flammable Limit: Lower Flammable Limit:
Not applicable. Non-Hazardous.
Auto Ignition Temperature: TDG Flammability Classification:
None. None.
Sensitivity to Impact: Sensitivity to Static Discharge:
Foam, dry chemical or carbon dioxide.
Means of Extinction:
None
Hazardous Combustion Products:
Product is fire-resistant but it will burn if water is removed.
Special Procedures:
SECTION 5 - REACTIVITY DATA
This material is stable.
Stability:
Will not occur.
Hazardous Polymerisation:
Strong oxidising agents and acids.
Conditions to avoid:
Strong oxidising agents and acids.
Incompatibility with other substances:
Thermal, oxides of carbon.
Hazardous decomposition products:
Avoid breathing product mists. Breathing mists in excess of TLV may cause irritation of respiratory tract.
Effects of Acute Exposure:
Persons with chronic respiratory disease may show increased symptoms due to irritation. Mild to
moderate skin and eye irritant.
Unknown for this product.
Effects of Chronic Exposure:
See Hazardous ingredients Section 2. Not determined.
Exposure Limits: Carcinogenicity:
Not determined. Not determined.
Reproductive Toxicity: Teratogenicity:
Mildly irritating. Not determined.
Irritancy of Product: Mutagenicity:
The information contained in this form is based on data from sources considered to be reliable but Irving Oil does not guarantee the accuracy or completeness thereof. The information is
provided as a service to the persons purchasing or using the material to which it refers and Irving Oil expressly disclaims all liability for loss or damage including consequential loss or for
injury to persons including death. The information shall not be reproduced, published or distributed in any manner without prior consent in writing of Irving Oil
hsf_po.doc
Page 1 of 2
MATERIAL SAFETY DATA SHEET
SECTION 7 - PREVENTATIVE AND CORRECTIVE MEASURES
Gloves: Rubber/Chemical resistant.
Personal Protective Equipment:
Eye: Safety glasses with side shields or goggles.
Respiratory: Required only when exposure limits are exceeded.
Footwear: No special requirements.
Clothing: No special requirements.
Other:
Provide adequate ventilation with local exhaust system when mist levels are above exposure limits.
Engineering Controls:
Stop leak at source. Contain large spills and collect with absorbent material. Flush area with water for
Leak and Spill Procedure:
small quantities.
Consult Local authorities on correct disposal procedure.
Waste Disposal:
Store in cool ,dry, well-ventilated area. Keep containers closed.
Storage Requirements
Special Shipping Information:
SECTION 8 - FIRST AID MEASURES
Not applicable.
Inhalation:
If swallowed if conscious, then induce vomiting. Seek medical attention immediately.
Ingestion:
Flush with plenty of water for at least 20 minutes.
Eye:
Flush with water, wash with mild soap if available.
Skin:
Launder contaminated clothing before re-use.
General Advice:
SECTION 9 - PREPARATION DATE OF MSDS
Irving Lubricants (506) 632-7000
MSDS Prepared by: Phone:
MSDS Date: February 14, 2007
Revision 02
The information contained in this form is based on data from sources considered to be reliable but Irving Oil does not guarantee the accuracy or completeness thereof. The information is
provided as a service to the persons purchasing or using the material to which it refers and Irving Oil expressly disclaims all liability for loss or damage including consequential loss or for
injury to persons including death. The information shall not be reproduced, published or distributed in any manner without prior consent in writing of Irving Oil
hsf_po.doc
Page 2 of 2
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP