Material Safety Data Sheet
Aqua Base 120 Bonding Adhesive MSDS No. 307431
Date of Preparation: 01/11/07 Revision: 000
Section 1 - Chemical Product and Company Identification
Product/Chemical Name: Aqua Base鈩? 120 Bonding Adhesive
Chemical Formula:
CAS Number:
Other Designations: Water Based Bonding Adhesive
General Use: Roof Contact Adhesive
Manufacturer: : WeatherBond, PO Box 251, Plainfield, PA 17081 Phone: 866-471-5125
Emergency Phone Number: CHEMTREC (USA) 800-424-9300
Section 2 - Composition / Information on Ingredients
Ingredient Name CAS Number % wt
Vinyl Acetate 108-05-4 <1% wt
Hydrous Aluminum Silicate 1332-58-7 Non Hazardous
Trace Impurities:
OSHA PEL ACGIH TLV NIOSH REL NIOSH
Ingredient TWA STEL TWA STEL TWA STEL IDLH
Vinyl Acetate 10 ppm 20 ppm 10 ppm 20 ppm none estab. none estab. none estab.
30 mg/m3 60 mg/m3 30 mg/m3 60 mg/m3
Hydrous Aluminum none estab. none estab. 15 mg/m3 none estab. none estab. none estab. none estab.
Silicate
Section 3 - Hazards Identification
HMIS
Emergency Overview 1
H
0
F
0
R
Potential Health Effects PPE鈥?
鈥燬ec. 8
Acute Effects
Inhalation: May cause respiratory irritation.
Eye: May cause eye irritation.
Skin: May cause transient skin irritation.
Ingestion: Unknown
Carcinogenicity: The Vinyl Acetate supplier reports that there is limited evidence of carcinogenicity of the monomer in animals
(IARC group 2B)
Medical Conditions Aggravated by Long-Term Exposure: None currently known.
Chronic Effects: None currently known.
Section 4 - First Aid Measures
Inhalation: Remove to fresh air.
Eye Contact: Flush with large amounts of water, lifting upper and lower lids occasionally. Continue for at least 15 minutes.
Get medical attention.
Skin Contact: Remove contaminated clothing. Wash affected area with soap and water. Obtain medical attention if irritation
persists.
Ingestion: If swallowed, call Poison Control Center, Hospital Emergency Room or Physician immediately.
After first aid, get appropriate in-plant, paramedic, or community medical support.
Note to Physicians: Any treatment that might be required for overexposure should be directed at the control of symptoms and
the clinical conditions.
MSDS No. 307431 Aqua Base 120 Bonding Adhesive Revision_Date: 1/11/07
Section 5 - Fire-Fighting Measures
NFPA
Flash Point: Not applicable
Autoignition Temperature: Not applicable
#
LEL: 3.0% v/v
#
#
UEL: 13% v/v
鈥?
Flammability Classification: Not applicable
Extinguishing Media: Will not burn
Unusual Fire or Explosion Hazards: None known
Hazardous Combustion Products: Will not burn
Fire-Fighting Instructions: No special Fire-Fighting instructions.
Section 6 - Accidental Release Measures
Spill /Leak Procedures: Confine in small area; use absorbent to clean up. Place in container for disposal.
Cleanup: Dispose in accordance with Federal, State and Local Regulations.
Regulatory Requirements:
Section 7 - Handling and Storage
Handling Precautions: Protect from freezing. Close container after each use. Keep away from children.
Storage Requirements: Protect from freezing.
Regulatory Requirements: None
Section 8 - Exposure Controls / Personal Protection
Engineering Controls:
Ventilation: Natural ventilation should be adequate under normal conditions.
Administrative Controls:
Respiratory Protection: Proper selection of respiratory protection depends upon many factors including duration and level of
exposure and conditions of use. In general, exposure to organic chemicals such as those contained in this product may not
require the use of respiratory protection if used in well ventilated areas. In areas of restricted ventilation a NIOSH approved
Organic Vapor Respirator may be required. Under certain conditions, such as spraying, a mechanical prefilter may also be
required. In confined areas or in high exposure situations a NIOSH/MSHA approved Air Supplied Respirator may be required.
If the TLV鈥檚 or PEL鈥檚 listed in Section 2 are exceeded use a properly fitted NIOSH/MSHA approved respirator with an
appropriate protection factor. Refer to OSHA 29 CFR 1910.134 鈥淩espiratory Protection鈥?, and 鈥淩espiratory Protection A
Manual and Guideline, American Industrial Hygiene Association鈥?.
Eye Protection: Wear safety spectacles with side shields. Wear face shield as necessary when spraying.
Protective Clothing/Equipment: Not likely to be needed.
Comments: Never eat, drink, or smoke in work areas. Practice good personal hygiene after using this material, especially before
eating, drinking, smoking, using the toilet, or applying cosmetics.
Section 9 - Physical and Chemical Properties
Physical State: Liquid Water Solubility:
Appearance and Odor: White, mild odor Other Solubilities:
Odor Threshold: Boiling Range: 162掳F (72掳C) to 446掳F (230掳C)
Vapor Pressure: Freezing/Melting Point:
Vapor Density (Air=1): Heavier than air Viscosity:
Formula Weight: 8.8 lbs./gal. Refractive Index:
Density: N/A Surface Tension:
Specific Gravity (H2O=1, at 4 掳C): 1.1 % Volatile: 56
Evaporation Rate: Slower than diethyl ether
pH:
Section 10 - Stability and Reactivity
Stability: Normally stable.
Polymerization: Hazardous polymerization will not occur.
Chemical Incompatibilities: None know.
Conditions to Avoid: None know.
Hazardous Decomposition Products: Burning, including when heated by welding or cutting, will produce smoke, carbon
monoxide and carbon dioxide.
Page 2 of 3
01/11/07 Aqua Base 120 Bonding Adhesive MSDS No. 307431
Section 11- Toxicological Information
Toxicity Data:
No information available.
Section 12 - Ecological Information
No information available
Section 13 - Disposal Considerations
Disposal: See Section 6.
Disposal Regulatory Requirements:
Container Cleaning and Disposal:
Section 14 - Transport Information
DOT Transportation Data (49 CFR 172.101):
Shipping Name: Packaging Authorizations Quantity Limitations
Shipping Symbols: a) Exceptions: a) Passenger, Aircraft, or Railcar:
Hazard Class: Adhesives, Not b) Non-bulk Packaging: b) Cargo Aircraft Only:
Regulated c) Bulk Packaging:
ID No.: Vessel Stowage Requirements
Packing Group: DOT (HM-181) a) Vessel Stowage:
Label: b) Other:
Special Provisions (172.102):
Section 15 - Regulatory Information
All ingredients in this product are listed on the U.S. TSCA Inventory.
Ingredient CAS # Detail Inventory List Information
Vinyl Acetate 108-05-4 TSCA (8d)
DSL
Hydrous Aluminum Silicate 1332-58-7 TSCA
NDSL
Detail Inventory List Description
TSCA/Toxic Substances Control Act
(8d) Health and Safety Reporting Rules
DSL/Canadian Domestic Substance List
NDSL/Canadian Non-Domestic Substance List
Section 16 - Other Information
Prepared By: Research and Development
Revision Notes:
Additional Hazard Rating Systems:
Disclaimer: The information contained in this document is based upon data that was supplied to WeatherBond by other
companies and organizations. No warranty of merchantability or fitness for a particular purpose is expressed or implied
regarding the accuracy or completeness of the data and/or information in this material safety data sheet.
Page 3 of 3
|