**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 5324-84-5 |Sodium 1-octanesulfonate | 100% | 226-195-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes and skin.The toxicological properties of this
material have not been fully investigated.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation. May be absorbed through the skin in harmful
amounts.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Immediately flush skin with plenty of water for at least 15 minutes
while removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Get medical aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Flush spill area with water. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Avoid contact with eyes, skin, and clothing. Avoid ingestion and
inhalation.
Storage:
Store in a cool, dry place. Keep container closed when not in use.
Keep away from acids.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate general or local exhaust ventilation to keep airborne
concentrations below the permissible exposure limits.
Exposure Limits
CAS# 5324-84-5:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Solid
Color: white to light cream
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: > 300 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Soluble in water.
Specific Gravity/Density:
Molecular Formula: C8H17O3S1Na1
Molecular Weight: 216.167
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials.
Incompatibilities with Other Materials:
Strong acids.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 5324-84-5 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Sodium 1-octanesulfonate -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/38 Irritating to eyes and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28 After contact with skin, wash immediately
with...
WGK (Water Danger/Protection)
CAS# 5324-84-5: 2
Canada
CAS# 5324-84-5 is listed on Canada's DSL List.
CAS# 5324-84-5 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 5324-84-5 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 12/12/1997 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
2,4-Hexadien-1-Ol, 99%, Mixture of Isomers
| 111-28-4 |
|
Benzalkoniumchloride, 50 wt% Aq.Solution
| 7732-18-5 |
|
3-Bromo-1,1,1-trifluoro-2-propanol, 96% (g c)
| 88378-50-1 |
|
Glutaraldehyde sodium bisulfite addition compound, 95%
| 28959-35-5 |
|
4-Bromobenzoyl chloride, 98%
| 586-75-4 |
|
4,4'-Methylenedianiline, 99% (Titr.)
| 101-77-9 |
|
2-Methylcinnamic acid, 99%
| 2373-76-4 |
|
Platinum black, 98% Pt
| 7440-06-4 |
|
Rubidium nitrate, 99.8%
| 13126-12-0 |
|
Calcium Hypochlorite
| 7778-54-3 |
|
cis-2-Amino-1-cyclopentanecarboxylic acid hydrochloride hemihydrate
| 7664-93-9 |
|
Dichlorodiphenylmethane, 99%
| 2051-90-3 |
|
Tryptone
| |
|
2-Butene-1,4-Diol, 97% Cis
| 6117-80-2 |
|
Boric acid, 2 % w/v aqueous solution
| 7732-18-5 |
|
Molecular Sieves, 5A, Powder, Max. Grain-Size 50 Micron
| 0-00-1 |
|
Heptaldehyde, 96% (gc)
| 111-71-7 |
|
Alpha-Amylase
| 9000-90-2 |
|
Lead, 1000 ppm, standard metal solution in approx. M nitric acid
| 7439-92-1 |
|
2-Picoline, 98%
| 109-06-8 |
|
Vinyl sulfone,97% stabilized with 500 ppm hydroquinone
| 77-77-0 |
|
Potassium Chloride, saturated solution
| 7447-40-7 |
|
Potassium Chloride 3 M-4 M Solutions
| 7447-40-7 |
|
Potassium thiocyanate, 0.1N solution stabilized with 10 ppm mercuric
| 333-20-0 |
|
Sodium Thiosulfate, 0.100 N Solution
| 7732-18-5 |
|
Ethanol SDA1, Anhydrous
| 64-17-5 |
|
1-O-Octyl-beta-D-glucopyranoside
| 29836-26-8 |
|
Soap solution - Wanklyn
| 143-18-0 |
|
1-Octane sulfonic acid, sodium salt
| 5324-84-5 |
|
This is a test.
| 67-56-1 |
|
Polyurethane foam (polymer A)
| 0-00-0 |
|
Tetrabromocatechol, 96%
| 488-47-1 |
|
Alpha-Bromo-4-Nitro-O-Cresol
| 772-33-8 |
|
Trimethyl-ethoxysilane
| 7732-18-5 |
|
Diethyl citrate, tech.
| 7553-56-2 |
|
alpha-Cyano-3-hydroxycinnamic acid, 99%
| 54673-07-3 |
|
2,4,6-Triphenyl-s-triazine
| 493-77-6 |
|
Zinc Metal (Granular and Mossy)
| 7440-66-6 |
|
Magnesium Powder
| 7439-95-4 |
|
Geometric Data Fixative (BSI)
| 67-56-1 |
|
Isopropyl-dimethyl-chlorosilane
| 67-63-0 |
|
Wright Stain
| 67-56-1 |
|
Lithium diisopropylamide, 2M solution in THF/n-heptane
| 100-41-4 |
|
Gastrak 4 Molar Potassium Chloride (BSI)
| 7447-40-7 |
|
1-Acetyl-2-Phenylhydrazine, 98%
| 114-83-0 |
|
Sulfosalicylic acid 20%
| 97-05-2 |
|
Hydrochloric Acid 4N, 5N and 6N
| 7647-01-0 |
|
Hydrochloric Acid 0.01 N to 1.0N
| 7647-01-0 |
|
Hydrochloric Acid 0.1 N
| 90-43-7 |
|
Acetic acid 1N
| 64-19-7 |
|
|