**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Not available.
Potential Health Effects
Eye:
May cause eye irritation. Low hazard for normal industrial
handling.
Skin:
May cause skin irritation. Low hazard for usual industrial handling.
Ingestion:
May cause irritation of the digestive tract. Low hazard for usual
industrial handling.
Inhalation:
May cause respiratory tract irritation. Low hazard for usual
industrial handling.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. If irritation
develops, get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water. Wash mouth out with water. Get
medical aid if irritation or symptoms occur.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Runoff from
fire control or dilution water may cause pollution.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Sweep up
or absorb material, then place into a suitable clean, dry, closed
container for disposal. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Wash hands before eating. Use with
adequate ventilation. Avoid contact with eyes, skin, and clothing.
Keep container tightly closed. Avoid ingestion and inhalation. Use
with adequate ventilation.
Storage:
Store in a cool place in the original container and protect from
sunlight. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. No special
precautions indicated.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
There are no special ventilation requirements. Facilities storing or
utilizing this material should be equipped with an eyewash facility
and a safety shower. Use adequate ventilation to keep airborne
concentrations low.
Exposure Limits
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Protective garments not normally required. Wear
appropriate protective gloves to prevent skin
exposure.
Clothing:
Protective garments not normally required. Wear
appropriate protective clothing to minimize contact
with skin. Wear appropriate protective clothing to
prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use. Follow the OSHA
respirator regulations found in 29 CFR 1910.134 or
European Standard EN 149. Use a NIOSH/MSHA or
European Standard EN 149 approved respirator if
exposure limits are exceeded or if irritation or
other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: Clear
Odor: Not available
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: 37 deg C
Solubility in water: Soluble in water
Specific Gravity/Density: Not available.
Molecular Formula: Not applicable.
Molecular Weight:
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable. However, may decompose if heated.
Conditions to Avoid:
High temperatures, incompatible materials, light.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
None, irritating and toxic fumes and gases.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
No CAS#s in product.
LD50/LC50:
Carcinogenicity:
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
US FEDERAL
TSCA
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 7/20/1999 Revision #3 Date: 3/04/2004
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
2,4-Hexadien-1-Ol, 99%, Mixture of Isomers
| 111-28-4 |
|
Benzalkoniumchloride, 50 wt% Aq.Solution
| 7732-18-5 |
|
3-Bromo-1,1,1-trifluoro-2-propanol, 96% (g c)
| 88378-50-1 |
|
Glutaraldehyde sodium bisulfite addition compound, 95%
| 28959-35-5 |
|
4-Bromobenzoyl chloride, 98%
| 586-75-4 |
|
4,4'-Methylenedianiline, 99% (Titr.)
| 101-77-9 |
|
2-Methylcinnamic acid, 99%
| 2373-76-4 |
|
Platinum black, 98% Pt
| 7440-06-4 |
|
Rubidium nitrate, 99.8%
| 13126-12-0 |
|
Calcium Hypochlorite
| 7778-54-3 |
|
cis-2-Amino-1-cyclopentanecarboxylic acid hydrochloride hemihydrate
| 7664-93-9 |
|
Dichlorodiphenylmethane, 99%
| 2051-90-3 |
|
Tryptone
| |
|
2-Butene-1,4-Diol, 97% Cis
| 6117-80-2 |
|
Boric acid, 2 % w/v aqueous solution
| 7732-18-5 |
|
Molecular Sieves, 5A, Powder, Max. Grain-Size 50 Micron
| 0-00-1 |
|
Heptaldehyde, 96% (gc)
| 111-71-7 |
|
Alpha-Amylase
| 9000-90-2 |
|
Lead, 1000 ppm, standard metal solution in approx. M nitric acid
| 7439-92-1 |
|
2-Picoline, 98%
| 109-06-8 |
|
Vinyl sulfone,97% stabilized with 500 ppm hydroquinone
| 77-77-0 |
|
Potassium Chloride, saturated solution
| 7447-40-7 |
|
Potassium Chloride 3 M-4 M Solutions
| 7447-40-7 |
|
Potassium thiocyanate, 0.1N solution stabilized with 10 ppm mercuric
| 333-20-0 |
|
Sodium Thiosulfate, 0.100 N Solution
| 7732-18-5 |
|
Ethanol SDA1, Anhydrous
| 64-17-5 |
|
1-O-Octyl-beta-D-glucopyranoside
| 29836-26-8 |
|
Soap solution - Wanklyn
| 143-18-0 |
|
1-Octane sulfonic acid, sodium salt
| 5324-84-5 |
|
This is a test.
| 67-56-1 |
|
Polyurethane foam (polymer A)
| 0-00-0 |
|
Tetrabromocatechol, 96%
| 488-47-1 |
|
Alpha-Bromo-4-Nitro-O-Cresol
| 772-33-8 |
|
Trimethyl-ethoxysilane
| 7732-18-5 |
|
Diethyl citrate, tech.
| 7553-56-2 |
|
alpha-Cyano-3-hydroxycinnamic acid, 99%
| 54673-07-3 |
|
2,4,6-Triphenyl-s-triazine
| 493-77-6 |
|
Zinc Metal (Granular and Mossy)
| 7440-66-6 |
|
Magnesium Powder
| 7439-95-4 |
|
Geometric Data Fixative (BSI)
| 67-56-1 |
|
Isopropyl-dimethyl-chlorosilane
| 67-63-0 |
|
Wright Stain
| 67-56-1 |
|
Lithium diisopropylamide, 2M solution in THF/n-heptane
| 100-41-4 |
|
Gastrak 4 Molar Potassium Chloride (BSI)
| 7447-40-7 |
|
1-Acetyl-2-Phenylhydrazine, 98%
| 114-83-0 |
|
Sulfosalicylic acid 20%
| 97-05-2 |
|
Hydrochloric Acid 4N, 5N and 6N
| 7647-01-0 |
|
Hydrochloric Acid 0.01 N to 1.0N
| 7647-01-0 |
|
Hydrochloric Acid 0.1 N
| 90-43-7 |
|
Acetic acid 1N
| 64-19-7 |
|
|