CHEMICAL INTERNATIONAL
MATERIAL SAFETY DATA SHEET
EMERGENCY#: CANUTEC (613)996-6666
PRODUCT IDENTIFICATION AND PREPARATION INFORMATION
PRODUCT NAME: C.I. Stain-Out EFFECTIVE DATE: 10 September 2003
WHMIS CLASS: D2B, Toxic
T.D.G. CLASSIFICATION: Not regulated
UN: CLASS: PG: CHEMICAL FAMILY:
MATERIAL USE:
HAZARDOUS INGREDIENTS
INGREDIENTS CAS # Wt% ACGTH-TLV LC50 LD50
Sodium Perborate 15630-89-4 10 - 30 Oral (rat) 200 mg/kg
Sodium Carbonate 497-19-8 5 - 10 Oral (rat) 4 g/kg
PHYSICAL DATA
BOILING POINT(oC): N/A COEF. OF WATER/OIL DIST.:
VAPOUR PRESSURE (mm Hg): N/A SPECIFIC GRAVITY (H20=1): N/A
VAPOUR DENSITY (Air=1): N/A PERCENT VOLATILE (by vol.):
SOLUBILITY IN WATER: 10% EVAPORATION RATE (H20=1): N/A
PHYSICAL STATE: Solid ODOUR THRESHOLD:
FREEZING POINT(oC): N/A
pH (as supplied): Not Available
APPEARANCE AND ODOUR: Blue granular powder
FIRE AND EXPLOSION DATA
FLAMMABILITY:
FLASH POINT (Test method): N/A
FLAMMABLE LIMITS IN AIR, % BY VOL. LOWER: Non-flammable UPPER: N/A
HAZARDOUS COMBUSTION PRODUCTS: Oxygen, hydrogen peroxide and oxides of sodium.
MEANS OF EXTINCTION:
SPECIAL FIREFIGHTING PROCEDURES: Use self contained breathing apparatus and protective clothing.
FIRE AND EXPLOSION HAZARDS:
AUTOIGNITION TEMP.:
SENSITIVITY TO: MECHANICAL IMPACT: STATIC DISCHARGE:
REACTIVITY DATA
CONDITIONS FOR CHEMICAL INSTABILITY: Stable
INCOMPATIBILITY: Oxidizing material, Iron, Copper, Rust and Storage temperatures above 400C.
HAZARDOUS DECOMPOSITION PRODUCTS: See HAZARDOUS COMBUSTION PRODUCTS.
REACTIVITY:
FIRST AID
EYE: Flush with plenty of water for at least 15 minutes.
SKIN: Flush with plenty of water.
INHALATION: Remove from exposure. Get fresh air.
INGESTION: Induce vomiting. Drink milk, egg whites, gelatin solution or large quantities of water. Get medical
attention.
C.I. STAIN-OUT
TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY: Eyes, skin contact, inhalation, ingestion
EFFECTS OF ACUTE & CHRONIC EXPOSURE:
EYE: Causes temporary discomfort and irritation of the respiratory tract.
SKIN: Prolonged contact may cause irritation and defatting of tissue.
INHALATION: Large amounts of dust may cause irritation of the respiratory tract.
INGESTION: May cause nausea, abdominal pain and diarrhea.
PREVENTATIVE MEASURES
GLOVES: Rubber gloves should be worn to minimize contact with skin.
EYE PROTECTION: Safety glasses or chemical workers goggles.
RESPIRATORY PROTECTION: Dust mask should be worn where dust occurs.
OTHER PROTECTIVE EQUIPMENT: Coveralls should be worn to minimize contact with skin.
VENTILATION REQUIREMENTS (Local or General): Use with adequate ventilation.
LEAK AND SPILL PROCEDURE (including Neutralization): Sweep, scoop or vacuum discharged material.
Flush residue with water. Observe environmental regulations.
WASTE DISPOSAL: Dispose according to local, federal and provincial regulations. Flush residue with water.
Observe environmental regulations.
STORAGE REQUIREMENTS & HANDLING PROCEDURES: Store in a cool, dry area. Prolonged storage may
cause product to cake and become wet from atmospheric moisture.
DISCLAIMER: Information for this material safety data sheet was obtained from sources
considered technically accurate and reliable. While every effort has been made to ensure full
disclosure of product hazards, in some cases, data is not available and is so stated. Since
conditions of actual product use are beyond the control of the supplier, it is assumed that the user
of this material has been full trained according to the mandatory requirements of WHIMIS. No
warranty, expressed or implied is made, and supplier will not be liable for any losses, injuries, or
consequential damage which may result from the use or reliance on any information contained in
this form.
CHEMICAL INTERNATIONAL
18043 鈥? 107 Avenue
EDMONTON ALBERTA
T5S 1K3
|