FD4010 Page 1 of 5
01-30-2001
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
08-24-2000 12-26-1999
REVISION DATE: SUPERSEDES:
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
COMPANY INFORMATION
Foster Products Corporation
H.B. Fuller Company Subsidiary
2900 Granada Lane
Oakdale, MN 55128
Phone: 651-236-3785
Medical Emergency Phone Number (24 Hours): 1-888-853-1758
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
PRODUCT INFORMATION
PRODUCT IDENTIFIER: FD4010
PRODUCT NUMBER: FD4010
PRODUCT NAME: FOSTER 40-10
TRADEMARK: DUCT LINER ADHESIVE COATING鈩?
PRODUCT DESCRIPTION: Coating
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for any additional exposure limit guidelines.
Chemical Name CAS # PERCENT OSHA PEL
Zinc compounds 1332-07-6 10 - 30 Not established
Zinc oxide 1314-13-2 1-5 TWA Fume 5 MG/M3
TWA (Total dust) 10 MG/M3
TWA (Respirable dust) 5 MG/M3
STEL Fume 10 MG/M3
Triphenyl phosphate 115-86-6 1-5 TWA 3 MG/M3
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
HMIS RATING: HEALTH -- 1 FLAMMABILITY -- 0 REACTIVITY -- 0
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment
recommendations.
FD4010 Page 2 of 5
01-30-2001
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
POTENTIAL HEALTH EFFECTS BY ROUTE OF ENTRY
EYE: Can cause minor irritation, tearing and reddening.
SKIN: Can cause minor skin irritation, defatting, and dermatitis.
Component(s) may be absorbed through intact skin, but it is unlikely that harmful effects will occur unless contact is
prolonged, repeated, and extensive.
INHALATION: Can cause minor respiratory irritation. Inhalation of dusts produced during cutting, grinding or
sanding of this product may cause irritation of the respiratory tract.
INGESTION: Ingestion may cause transient irritation of throat, stomach and gastrointestinal tract.
LONG-TERM (CHRONIC) HEALTH EFFECTS
TARGET ORGAN(S): Lungs, Peripheral nervous system
REGULATED CARCINOGEN STATUS:
Unless noted below, this product does not contain regulated levels of NTP, IARC, ACGIH, or OSHA listed
carcinogens.
EXISTING HEALTH CONDITIONS AFFECTED BY EXPOSURE: Lung disease
SECTION 4: FIRST AID MEASURES
IF IN EYES: Use an eye wash to remove a chemical from your eye regardless of the level of hazard. Flush the
affected eye for at least twenty minutes. Tilt the head to prevent chemical from transferring to the uncontaminated
eye. Seek medical advice after flushing.
IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
IF VAPORS INHALED: Remove to fresh air. Call a physician if symptoms persist.
IF SWALLOWED: No hazard in normal industrial use. Do not induce vomiting. Seek medical attention if
symptoms develop. Provide medical care provider with this MSDS. Induce vomiting as a last measure. Induced
vomiting may lead to aspiration of the material into the lungs potentially causing chemical pneumonitis that may be
fatal.
SECTION 5: FIRE FIGHTING MEASURES
FLASH POINT: Non flammable
AUTOIGNITION TEMPERATURE: Not established
LOWER EXPLOSIVE LIMIT (% in air): Not established
UPPER EXPLOSIVE LIMIT (% in air): Not established
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers
when heated. Water spray may be used to cool the containers.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide, Phosphorus compounds,
Metal fumes
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION: No health affects expected from the clean-up of this material if contact can
FD4010 Page 3 of 5
01-30-2001
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
be avoided. Follow personal protective equipment recommendations found in
Section 8 of this MSDS.
CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers
for disposal. Keep spilled product out of sewers, watersheds, or water
systems.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: Mildly irritating material. Avoid unnecessary exposure.
Storage: Store in a cool, dry place.
Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE PROTECTION: Wear safety glasses when handling this product.
SKIN PROTECTION: Avoid skin contact by wearing chemically resistant gloves.
GLOVES: Nitrile
RESPIRATORY PROTECTION: Respiratory protection may be required to avoid overexposure when
handling this product. Use a respirator if general room ventilation is
not available or sufficient to eliminate symptoms.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).
VENTILATION: Use local exhaust ventilation or other engineering controls to
minimize exposures.
EXPOSURE LIMITS:
Chemical Name ACGIH EXPOSURE LIMITS AIHA WEEL
Zinc compounds Not established Not established
Zinc oxide TWA Fume 5 MG/M3 Not established
TWA (Total dust) 10 MG/M3
Triphenyl phosphate TWA 3 MG/M3 Not established
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Liquid
COLOR: White
ODOR: Neutral
ODOR THRESHOLD: Not established
WEIGHT PER GALLON (lbs.): 11.2
FD4010 Page 4 of 5
01-30-2001
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SPECIFIC GRAVITY: 1.34
SOLIDS (% by weight): 57.0
pH: 8.7
BOILING POINT (deg. C): Not established
FREEZING/MELTING POINT (deg. C): Not established
VAPOR PRESSURE (mm Hg): Not established
VAPOR DENSITY: Not established
EVAPORATION RATE: Not established
OCTANOL/WATER COEFFICIENT: Not established
SECTION 10: STABILITY AND REACTIVITY
STABILITY: Stable under normal conditions.
CHEMICAL INCOMPATIBILITY: Not established
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide, Phosphorus
compounds, Metal fumes
SECTION 11: TOXICOLOGICAL INFORMATION
CHEMICAL NAME LD50/LC50
Zinc compounds Not established
Zinc oxide Oral LD50 Mouse > 950 mg/kg
Inhalation LC50 Mouse = 2500 mg/cu m (no duration specified)
Triphenyl phosphate Oral LD50 Rat = 3500 mg/kg
Dermal LD50 Rabbit > 7900 mg/kg
TOXICOLOGY SUMMARY: No additional health information available.
SECTION 12: ECOLOGICAL INFORMATION
OVERVIEW: No ecological information available
SECTION 13: DISPOSAL CONSIDERATIONS
To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA
Hazardous Waste Regulations 40 CFR 261. Solidify and dispose of in an approved landfill. Consult state, local or
provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
Consult Bill of Lading for transportation information.
SECTION 15: REGULATORY INFORMATION
INVENTORY STATUS
U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's
Inventory requirements.
CANADIAN CEPA DSL: This product is in compliance with the Canadian Domestic Substance List
requirements.
FD4010 Page 5 of 5
01-30-2001
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
If you need more information about the inventory status of this product call 651-236-5858.
TSCA Section 12(b) - Export Notice Requirements
This product contains a chemical substance that is currently on the EPA's Section 12(b) Export List. Contact the
company Global Regulatory Group at 651/236-5858 for the identity of the Section 12(b) chemical(s).
FEDERAL REPORTING
EPA SARA Title III Section 313
Unless listed below, this product does not contain toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 72. EPA
has advised that when a percentage range is listed the midpoint may be used to fulfill reporting obligations.
Chemical Name CAS# %
Zinc compounds 1332-07-6 10 - 30
Zinc compounds 1314-13-2 1-5
WHMIS STATUS: Unless listed below, this product is not controlled under the Canadian Workplace Hazardous
Materials Information System.
STATE REPORTING
This MSDS is not prepared for distribution in California.
SECTION 16: ADDITIONAL INFORMATION
This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health
Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace
Hazardous Materials Information System (WHMIS).
Prepared by: The Global Regulatory Department
Phone: 651-236-5842
The information and recommendations set forth herein are believed to be accurate. Because some of the information
is derived from information provided to Foster Products Corporation from its suppliers, and because Foster Products
Corporation has no control over the conditions of handling and use, Foster Products Corporation makes no warranty,
expressed or implied, regarding the accuracy of the data or the results to be obtained from the use thereof. The
information is supplied solely for your information and consideration, and Foster Products Corporation assumes no
responsibility for use or reliance thereon. It is the responsibility of the user of Foster Products Corporation products
to comply with all applicable federal, state and local laws and regulations.
|