Material Safety Data Sheet
NFPA HMIS PPE Transport Symbol
Issuing Date 27-Feb-2007 Revision Date Revision Number 0
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name Component B for
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Recommended Use Insulation
Supplier Address Convenience Products, division of Clayton Corp.
866 Horan Drive
Fenton, MO 63026-2416 USA
TEL: (636) 349-5855
Emergency Telephone Number Chemtrec 1-800-424-9300
(703) 527-3887 outside US
2. HAZARDS IDENTIFICATION
Emergency Overview
May cause drowsiness and dizziness.
Appearance Pale Amber Physical State Liquid Aerosol Odor Faint hydrocarbon
Potential Health Effects
Principle Routes of Exposure Inhalation, Skin contact, Eye contact.
Acute Toxicity
Eyes May cause slight irritation. Avoid contact with eyes.
Skin May cause skin irritation and/or dermatitis. Contact with product may cause frostbite. Avoid
contact with skin and clothing.
Inhalation May cause central nervous system depression with nausea, headache, dizziness, vomiting,
and incoordination. Irritating to mucous membranes. Avoid breathing vapors or mists.
Ingestion Not an expected route of exposure. No known effect based on information supplied.
Chronic Effects No known effect based on information supplied
Aggravated Medical Conditions Central nervous system.
Environmental Hazard See Section 12 for additional Ecological information
3. COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Name CAS-No Weight %
Chlorodifluoromethane 75-45-6 10-30
4. FIRST AID MEASURES
Eye Contact Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician
Skin Contact Wash off immediately with plenty of water for at least 15 minutes. In case of contact with
liquefied gas, thaw frosted parts with lukewarm water. If symptoms persist, call a physician.
Page 1 / 7
COMPONENT B for Revision Date
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
Inhalation Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
If symptoms persist, call a physician.
Ingestion Clean mouth with water and afterwards drink plenty of water. Consult a physician if necessary.
Notes to Physician Treat symptomatically
5. FIRE-FIGHTING MEASURES
Flammable Properties Containers may explode when heated.
Flash Point None
Suitable Extinguishing Media Dry chemical, CO2, water spray or regular foam. Move containers
from fire area if you can do it without risk. Dike fire-control water for
later disposal.
Unsuitable Extinguishing Media Do not scatter spilled material with high pressure water streams.
Explosion Data
Sensitivity to mechanical impact None
Sensitivity to static discharge None
Specific Hazards Arising from the Chemical
Ruptured cylinders may rocket.
Protective Equipment and Precautions for Firefighters
Wear self-contained breathing apparatus and protective suit.
NFPA Health Hazard 1 Flammability 1 Stability 0 Physical and Chemical
Hazards -
HMIS Health Hazard 1 Flammability 1 Stability 0 Personal Precautions -
6. ACCIDENTAL RELEASE MEASURES
Personal Precautions Ensure adequate ventilation
Methods for Containment Prevent further leakage or spillage if safe to do so.
Methods for Cleaning Up Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder,
sawdust). Following product recovery, flush area with water.
7. HANDLING AND STORAGE
Handling Handle in accordance with good industrial hygiene and safety practice. Wear personal
protective equipment. Avoid contact with eyes. Ensure adequate ventilation. Do not breathe
vapors or spray mist.
Storage Keep containers tightly closed in a dry, cool and well-ventilated place.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Guidelines
Chemical Name ACGIH TLV OSHA PEL NIOSH IDLH
Chlorodifluoromethane TWA: 1000 ppm TWA: 1000 ppm
3
TWA: 3500 mg/m
NIOSH IDLH: Immediately Dangerous to Life or Health
Page 2 / 7
COMPONENT B for Revision Date
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
Engineering Measures Showers
Eyewash stations
Ventilation systems
Personal Protective Equipment
Eye/Face Protection Tightly fitting safety goggles.
Skin and Body protection Wear protective gloves/clothing.
Respiratory Protection No protective equipment is needed under normal use conditions. If exposure limits are
exceeded or irritation is experienced, ventilation and evacuation may be required.
Hygiene Measures Handle in accordance with good industrial hygiene and safety practice
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance Odor
Pale Amber Faint hydrocarbon
Odor Threshold Physical State
No information available Liquid Aerosol
pH No information available
Flash Point Autoignition Temperature
None Not applicable
Decomposition temperature Boiling Point/Range
No data available -42掳C / -44掳F
Melting Point/Range No data available
Flammability Limits in Air Explosion Limits
No data available No data available
Specific Gravity Water Solubility
1.1 Not Compatible
Solubility Evaporation Rate
No data available No data available
Vapor Pressure Vapor Density
No data available No data available
VOC Content EPA VOC (g/l)
Not applicable 0
Partition Coefficient (n- No data available
octanol/water)
10. STABILITY AND REACTIVITY
Stability Stable under recommended storage conditions
Conditions to Avoid Keep away from open flames, hot surfaces and sources of ignition.
Incompatible Products Oxidizing agents. Strong acids. Strong bases.
Hazardous Decomposition Products Thermal decomposition can lead to release of irritating gases and
vapors, Carbon monoxide (CO), Carbon dioxide (CO2).
Hazardous Polymerization Hazardous polymerization does not occur.
11. TOXICOLOGICAL INFORMATION
Acute Toxicity
Product Information No acute toxicity information is available for this product.
Component Information
Chemical Name LD50 Oral LD50 Dermal LC50 Inhalation
Page 3 / 7
COMPONENT B for Revision Date
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
Chlorodifluoromethane 220000 ppm ( Rat ) 4 h
Subchronic Toxicity (28 days)
Chronic Toxicity
Carcinogenicity There are no known carcinogenic chemicals in this product
Mutagenicity
Reproductive Toxicity This product does not contain any known or suspected reproductive hazards
Target Organ Effects Central nervous system (CNS).
Endocrine Disruptor Information This product does not contain any known or suspected endocrine disruptors
12. ECOLOGICAL INFORMATION
Ecotoxicity
Ecotoxicity effects.
Chemical Name Log Pow
Chlorodifluoromethane 1.08
13. DISPOSAL CONSIDERATIONS
Waste Disposal Method This material, as supplied, is not a hazardous waste according to state and federal regulations
(40 CFR 261).
Contaminated Packaging Dispose of in accordance with local regulations.
14. TRANSPORT INFORMATION
DOT
Proper Shipping Name Consumer commodity
Hazard Class ORM-D
Description Consumer commodity,ORM-D,
TDG
Proper Shipping Name Aerosols
Hazard Class 2.2
UN-No UN1950
Description AEROSOLS,2.2,UN1950
MEX
Proper Shipping Name Aerosols
Hazard Class 2.2
UN-No UN1950
Description UN1950 Aerosols,2.2,
ICAO
UN-No UN1950
Proper Shipping Name Aerosols
Hazard Class 2.2
Description Aerosols,UN1950
IATA
UN-No UN1950
Proper Shipping Name Aerosols, non-flammable
Hazard Class 2.2
ERG Code 2L
Description UN1950,Aerosols, non-flammable,2.2
IMDG/IMO
Proper Shipping Name Aerosols
Page 4 / 7
COMPONENT B for Revision Date
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
14. TRANSPORT INFORMATION
Hazard Class 2
UN-No UN1950
EmS No. F-D, S-U
Description UN1950, Aerosols,2
RID
Proper Shipping Name Aerosols
Hazard Class 2
UN-No UN1950
Classification Code 5A
Description UN1950 Aerosols,2,RID
ADR/RID-Labels 2
ADR
Proper Shipping Name Aerosols
Hazard Class 2
UN-No UN1950
Classification Code 5A
ADR/RID-Labels 2
ADN
Proper Shipping Name Aerosols
Hazard Class 2
Classification Code 5A
Special Provisions 63, 190, 191, 277, 913
Description UN1950 Aerosols,2,
Hazard Labels 2
Limited Quantity See SP277
15. REGULATORY INFORMATION
International Inventories
DSL Complies
EINECS/ELINCS Complies
ENCS Complies
CHINA Complies
KECL Complies
PICCS Complies
AICS Complies
U.S. Federal Regulations
SARA 313
Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product contains a chemical or
chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 372:
Chemical Name CAS-No Weight % SARA 313 - Threshold
Values
Chlorodifluoromethane 75-45-6 10-30 1.0
Page 5 / 7
COMPONENT B for Revision Date
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
SARA 311/312 Hazard Categories
Acute Health Hazard Yes
Chronic Health Hazard No
Fire Hazard Yes
Sudden Release of Pressure Hazard Yes
Reactive Hazard No
Clean Water Act
This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR 122.21 and 40 CFR
122.42).
CERCLA
This material, as supplied, contains one or more substances regulated as a hazardous substance under the Comprehensive
Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302).
U.S. State Regulations
California Proposition 65
This product does not contain any Proposition 65 chemicals.
U.S. State Right-to-Know Regulations
Chemical Name Massachusetts New Jersey Pennsylvania Illinois Rhode Island
Chlorodifluoromethane X X X X
International Regulations
Chemical Name Carcinogen Status Exposure Limits
3
Chlorodifluoromethane Mexico: TWA= 3500 mg/m
Mexico: TWA= 1000 ppm
Mexico: STEL= 1250 ppm
3
Mexico: STEL= 4375 mg/m
Canada
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations (CPR) and the
MSDS contains all the information required by the CPR.
WHMIS Hazard Class
A Compressed gases
Chemical Name NPRI
Chlorodifluoromethane X
Legend
NPRI - National Pollutant Release Inventory
16. OTHER INFORMATION
Issuing Date 27-Feb-2007
Revision Date
Revision Note No information available
Page 6 / 7
COMPONENT B for Revision Date
Touch 'n Seal Foam Kit 15 / 110 / 200 / 600 (std)
Touch 鈥榥 Foam Professional Foam Kit 15 / 200 / 600 (std)
Disclaimer
The information provided on this MSDS is correct to the best of our knowledge, information and belief at the date of its
publication. The information given is designed only as a guide for safe handling, use, processing, storage, transportation,
disposal and release and is not to be considered as a warranty or quality specification. The information relates only to the
specific material designated and may not be valid for such material used in combination with any other material or in any
process, unless specified in the text.
End of MSDS
Page 7 / 7
|