EMS CATALOG NO: 50400-S
EMS PRODUCT: Crystalbond 509 Stripper
DATE: March 4, 2008
PAGE NUMBER: One of 3
MATERIAL SAFETY DATA SHEET
The information contained herein is based on data considered accurate. However,
no warranty is expressed or implied regarding the accuracy of these data or the
results to be obtained from the use thereof.
Electron Microscopy Sciences assumes no responsibility for personal injury or
property damage to vendees, users or third parties caused by the material. Such
vendees or users assume all risks associated with the use of the material.
ELECTRON MICROSCOPY SCIENCES
1560 Industry Road
P.O. Box 550
Hatfield, PA 19440
215-412-8400 / Fax 215-412-8450
24 HOUR EMERGENCY PHONE NUMBER CHEMTREC: (800) 424-9300
FOR PRODUCT AND SALES INFORMATION
CONTACT ELECTRON MICROSCOPY SCIENCES OFFICE ABOVE.
PRODUCT IDENTIFICATION
IDENTITY: Crystalbond 509-S Stripper
HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
Hazardous Ingredients: Dimethylacetamide
CAS# 127-19-5
ACCIH TLV: 10ppm TWA
OSHA PEL: 10ppm TWA
HEALTH: 1 FLAMMABILITY: 0 REACTIVITY: 0
HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW: A transparent liquid with a slight ammonia odor. May cause
Skin and eye irritation. May be harmful if swallowed, inhaled or absorbed through the
Skin. May cause liver, kidney and central nervous systems effects.
POTENTIAL HEALTH EFFECTS:
EYES: May cause slight to moderate irritation.
SKIN: May cause slight to moderate irritation. May be harmful if absorbed
through the skin.
INHALATION: May cause dizziness and nausea.
INGESTION: May cause slight to moderate irritation of gastrointestinal
May cause central nervous system effects.
DELAYED EFFECTS: Repeated or prolonged exposure may cause kidney
And liver damage.
FIRE AND EXPLOSION DATA
Flash Point: 160 F
Flammable Limits: LEL: (1.8%) @ 100 C (Dimethylacetamide)
UEL: (11.5%) @ 160 C (Dimethylacetamide)
Extinguishing Media: Foam, carbon dioxide, dry powder, water spray.
Special Fire Fighting Procedures: Wear self contained brealthing apparatus and
Full protective equipment.
Unusual Fire and Explosion Hazards: Vapors can travel along surfaces to distant
Ignition sources and flash back. Vapors can spread along ground and collect in
Low confined areas. As with any organic material, contact with strong oxidizers
May cause fire or explosion. Special fire fighting precautions would be to wear
Self-contained breathing apparatus (SCBA) and full protective equipment.
FIRST AID MEASURES
SKIN: Immediately flush skin with plenty of water for at least 15 minutes while
Removing contaminated clothing and shoes. Get medical attention immediately.
Wash contaminated clothing before reuse.
EYES: Immediately flush eyes with water for at least 15 minutes. Do not wear
Contacts. Get medical attention immediately.
INHALATION: If inhaled, remove to fresh air. If not breathing, give artificial
Respiration. If breathing is difficult, give oxygen. Get medical attention.
INGESTION: Do not induce vomiting. Immediately give plenty of water. Get
Medical attention immediately. Do not give anything by mouth to an unconscious
Or convulsing person.
HEALTH HAZARD DATA
Effects of Overexposure
Inhalation: May cause dizziness and nausea.
Dermal Exposure: May cause skin irritation with prolonged contact.
Eye Irritation: Contact with eyes can cause irritation.
Ingestion: May cause stomach pains or nausea
Emergency and First-Aid Procedures:
Skin: Wash area thoroughly with soap and water.
Eye: Flush with copious amount of water. If irritation occurs, consult a physician.
Ingestion: Drink large amounts of water and induce vomiting. After vomiting drink
more water.
Catalog # 50400-S 2
Crystalbond 509-S Stripper
PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be taken in case material is released or spilled: Isolate and flush area with
water and mop up.
Waste Disposal Method: Dispose of in accordance with local, state, and federal
regulations.
Precautions to be taken in handling and storing: Avoid excessive heat, sparks, open
flames.
SPECIAL PROTECTION INFORMATION
Use NIOSH approved mist respirator where spray occurs. Use of rubber gloves and
chemical goggles is recommended.
Good industrial hygiene practice requires that employee exposure be maintained below
the recommended TLV. This is preferably achieved through the provision of adequate
ventilation where necessary. Where mist cannot be controlled in this way, personal
respiratory protection should be employed.
CHEMICAL COMPONENTS OF THIS PRODUCT WHICH ARE PRESENT IN REPORTABLE
AMOUNTS AND ARE LISTED IN SECTION 313 OF THE EMERGENCY PLANNING AND
COMMUNITY RIGHT TO KNOW ACT OF 1986 (SARA TITLE III) ARE SHOWN BELOW
WITH THEIR CAS REGISTRY NUMBER SNA MAXIMUN COMPOSITION BY WEIGHT.
HANDLING AND STORAGE
Keep away from heat , sparks and flames. Keep container tightly closed when
Not in use. Avoid contact with skin, eyes, and on clothing. Avoid breathing , vapor
Or mist. Keep away from sources of ignition. Keep storage container tightly closed.
Store in cool, dry well-ventilated area or cabinet. Isotlate from incompatible substances.
Residual vapors might explode on ignition, do not apply heat, cut drill or weld on or
Near this container.
EXPOSURE CONTROLS
Use local exhaust to keep airborne concentrations below the permissible
Exposure limits.
PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: Transparent
PHYSICAL STATE: Liquid
MOLECULAR WEIGHT: Mixture
CHEMICAL FORMULA: Mixture
ODOR: Slight Ammonia
SPECIFIC GRAVITY (water=1.0) 0.96-1.03@68 F
SOLUBILITY IN WATER (Weight %) Completely soluable
pH: Not determined
BOILING POINT: 329 F
Catalog # 50400-S 3
Crystalbond 509-S Stripper
MELTING POINT : -4F
VAPOR PRESSURE: 3.5@77F
VAPOR DENSITY (air=1.0) 2.50
EVAPORATION RATE: 0.17 Compared to: Butyl Acetate
% VOLATILES: Not determined
FLASH POINT: >160 F
TRANSPORT INFORMATION
US DOT HAZARD CLASS: Combustible Liquid
US DOT ID NUMBER: NA1993
PROPER SHIPPING NAME: Combustible Liquid, n.o.s. (contains Dimethylacetamide)
Not regulated in containers less than 119 gallons.
REGULATORY INFORMATION
TOXIC SUBSTANCES CONTROL ACT (TSCA)
TSCA INVENTORY STATUS: All components are listed on TSCA
OTHER TSCA ISSUES: None
Section 311/312 Hazard Class: Immediate Chronic: Fire
Sara 313 Toxic Chemicals:
The following ingredients are SAR 313 Toxic Chemicals and may be subject to
Annual reporting requirements. CAS numbers and weight percents are found in
Section 2.
OTHER INFORMATION: HMIS-2-2-0
NFPA-2-2-0
DISCLAIMER OF LIABILITY: The information contained here in is based on data taken
from sources believed to be both current and reliable at the time of publication. Electron
Microscopy Sciences makes no warranties expressed or implied, to the accuracy and
assumes no liability arising from its use by others. Compliance with all applicable
federal, state and local laws and regulations the responsibility of the users.
Catalog # 50400-S 4
Crystalbond 509-S Stripper
|