Epoxy Systems, Inc.
Material Safety Data Sheet
OSHA's Hazard Communication Standard,
29 CFR 1910.1200.
IDENTITY: EPOXY SYSTEMS鈥? PRODUCT #1800 White Brushable Polyurea Coating 鈥淎鈥? Component
SECTION I
Manufacturer: Epoxy Systems, Inc.
Emergency Number: 1-800-633-8253 PERS
Address: 9370 SW 208th CircleTelephone Number:352-489-1666
Dunnellon, FL 34431 Date Prepared: 4/2002
SECTION II 鈥? HAZARDOUS INGREDIENTS
Hazardous Components CAS # OSHA PELHazard Limits %
.5% mg/m3
Homopolymer Polymer HDI 28182-81-2 N/D
10 mg/ m3
Titanium Dioxide 13 463-67-7
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Specific Gravity: 1.27 Ph (1% solution) N/D
Appearance and Odor: Gray liquid, mild odor Volatility: Low
Flash Point: (掳f) (CLOSED CUP):>200 Water Solubility: Negligible (<1%)
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point: (掳F)(Method):>200 (CLOSED CUP)
Ignition Temp: (掳F): N/D
Flammable Limits: (%): Lower N/D Upper N/D
Products evolved when subjected to heat or combustion: Isocyanate vapor and mist. Carbon Dioxide,
Carbon Monoxide, Nitrogen Oxides and possible traces of Hydrogen Cyanide.
Recommended Fire Extinguishing Agents and Special Procedures: Carbon Dioxide, Dry Chemical, or
Foam. If Water is used, it should be a very large quantity. The reaction between water and hot Isocyanate
may be Vigorous.
Note: Down- Wind Personnel Must Be Evacuated. Fire Fighters Must Wear Positive Pressure Self-
Contained Breathing Apparatus And Full Protective Clothing.
Unusual Or Explosive Hazards: Do Not Reseal Contaminated Containers As Pressure May Build Up And
Rupture them.
SECTION V 鈥? REACTIVITY DATA
Stability: Stable Under Recommended Storage Conditions.
Incompatibility: Water, Acid, Base (Alkalies, Ammonia), Alcohols, Metal Compounds, Surface Active Material
Avoid Water As It Reacts To Form Heat, C02 And Insoluble Urea.
Hazardous Decomposition Products: Isocyanate Vapor and Mist. Carbon Dioxide, Carbon Monoxide,
Nitrogen Oxides And possible Traces Of Hydrogen Cyanide.
Hazardous Polymerization: May Occur With Incompatible Reactants (See Above). Especially Strong Bases
And Water Or Temperature Over 320掳F (160掳C). Reaction with Water Is Gentle At Room Temperature Over
120掳F (49掳C) Accelerates Reaction Rate.
Conditions To Avoid: Stable Under Recommended Storage Conditions.
SECTION VI - HEALTH HAZARD DATA
Respiratory Protection: Wear MSHA/NIOSH Approved (Or Equivalent) Full Face piece Airline Respirator In
The Positive Pressure Mode With Emergency Escape Provisions. A Respiratory Protection Program That
Meets OSHA 1910.134 And ANSI Z88.2 Requirements Must Be Followed Whenever Workplace Conditions
Warrant A Respirator鈥檚 Use.
Eye Protection: Use Chemical Splash Goggles.
Skin Protection: Use Impermeable Gloves To Minimize Skin Contact. Special Precautions Should Be Taken
To Ensure That Material Cannot Get Inside Gloves. This Product May Be A Skin Sensitizer. Exposed Users
Should Shower And Change To Clean Clothing After The Work Shift. Precautions Should Be Taken To
Prevent Re-Exposure Of Sensitized Individuals. Personal Protective Equipment To Prevent Dermal Exposure
Is Recommended.
Other Protective Equipment: A Safety Shower And Eye Wash Fountain Should Be Readily Available To
Identify Additional Personal Protective Equipment (PPE) Requirements, It Is Recommended That A Hazard
Assessment In Accordance With The OSHA PPE Standard (29 CFR 1910.132) Be Conducted Before Using
This Product.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
The Following Personal Protection Is Recommended:
Safety Glasses; Coveralls:
Chemical Glasses: Gloves, Chem. Resist:
Supplied Air Mask: (for large spills or confined areas- unreacted material)
Eyes: Irrigate With Water For 15 Minutes Continuously. Consult Medical Personnel
Skin: Wash Off With Soap And Water.
Ingestion: This Product Has A Low Order Of Acute Oral Toxicity Based On Animal Data. May Be Harmful If
Swallowed.
Ingestion: Remove To Fresh Air. If Not Breathing, Give Mouth To Mouth Resuscitation. If Breathing Difficult,
Give Oxygen. Consult Medical Personnel.
SECTION VIII - CONTROL MEASURES
Exposure Guidelines(S): Value Limit Reference
HDI polymeric diisocyanate 0.005 ppm TWA OSHA / ACGIH
Ventilation: General And / Or Local Exhaust To Control To Below The Exposure Guidelines.
Spill Control And Disposal: Contain Spill. Avoid Personal Contact. Wipe Up Or Absorb With Suitable
Material For Disposal. Dispose Of Unused Material In A Suitable Manner.
RCRA Waste: No RCRA Classification: N/A
Storage And Handling: Store Indoors At 50-96掳f In The Original Unopened Containers. Protect From
Atmospheric Moisture. Replace Outage With Inert Dry Gas-Nitrogen Or Desiccated Dry Air.
Other Precautions: Misuse Of Empty Containers Can Be Hazardous. Empty Containers Can Be Hazardous
If Used To Store Toxic, Flammable, Or Reactive Materials. Cutting Or Welding Of Empty Containers Might
Cause Fire, Explosion Of Toxic Fumes From Residues. Do Not Pressurize Or Expose To Open Flame Or
Heat.
Section IX- ADDITIONAL INFORMATION
1. Title III Section .311- Hazard Categorization
Acute:
Chronic:
Reactive
N/A = Not Applicable N/D = Not Determined N/E = Not Established
Epoxy Systems, Inc.
Material Safety Data Sheet
OSHA's Hazard Communication Standard,
29 CFR 1910.1200.
IDENTITY: EPOXY SYSTEMS鈥? PRODUCT #1800 White Brushable Polyurea Coating 鈥淏鈥? Component
SECTION I
Manufacturer: Epoxy Systems, Inc.
Emergency Number: 1-800-633-8253 PERS
Address: 9370 SW 208th Circle Telephone Number: 352-489-1666
Dunnellon, FL 34431 Date Prepared: 4/2000
SECTION II - HAZARDOUS INGREDIENTS
Hazardous Components CAS # OSHA PEL Hazard Limits %
Aspartic Ester
specific chemical identity is withheld as a trade secret ACGIH: N/E N/E 100%
SECTION III 鈥? PHYSICAL/CHEMICAL CHARACTERISTICS
Specific Gravity: 1.07 Ph (1% solution) N/D
Appearance and Odor: Amber liquid, mild odor Volatility: Low
Flash Point: (掳F) (CLOSED CUP):>200 Water Solubility: Negligible (<1%)
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point: (掳F)(Method):>200
Ignition Temp: (掳F): N/D
Flammable Limits: (%): Lower N/D Upper N/D.
Products Evolved When Subjected To Heat Or Combustion:. Carbon Dioxide, Carbon Monoxide, And
Ammonia May Be Formed And Burning In Limited Air Supply.
Recommended Fire Extinguishing Agents and Special Procedures: Water, Dry Chemical, Foam Or
Carbon Dioxide, Water And Foam May Cause Frothing. Use Water To Cool Fire Exposed Containers.
Unusual Or Explosive Hazards: None
SECTION V - REACTIVITY DATA
Stability: Stable Under Recommended Storage Conditions.
Conditions To Avoid: None
Incompatibility: Strong oxidizing
Hazardous Decomposition Products: Carbon Dioxide, Carbon Monoxide, And Ammonial May Be Formed
On Burning In Limited Air Supply.
Hazardous Polymerization: Will Not Occur.
SECTION VI - HEALTH HAZARD DATA
Eye Protection: May Cause Extreme Eye Irritation.
Skin Contact: May Be Only Slightly Irritating To Corrosive.
Skin Absorption: Expected To Be Somewhat Toxic By Dermal Absorption.
Ingestion: Harmful If Swallowed.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
The Following Personal Protection Is Recommended:
Safety Glasses: Protective Apron:
Chemical Glasses: Coveralls:
Face Shield: Gloves, Chem. Resist:
Supplied Air Mask: (for large spills or confined areas-unreacted material)
Eyes: Flush With Plenty Of Water For 15 Minutes. Consult Medical Personnel.
Skin: Wash Off With Soap And Water. Consult Medical Personnel.
Ingestion: DO NOT Induce Vomiting. Give Large Quantities Of Water. Consult Medical Personnel.
Inhalation: Remove To Fresh Air. If Not Breathing, Give Mouth To Mouth Resuscitation. If Breathing Is
Difficult, Give Oxygen. Consult Medical Personnel.
SECTION VIII - CONTROL MEASURES
Ventilation: Normal
Spill Control And Disposal: Avoid Personal Contact. Wipe Up Or Absorb With Suitable Material For
Disposal. Dispose Of As Industrial Local, State And Federal Regulations.
RCRA Waste: No RCRA Classification: N/A
Storage And Handling: Minimum Storage Temperatures Are Recommended. If Stored Above 100掳F, A N2
Atmosphere Is Recommended. Avoid Water Contamination.
Other Precautions: Misuse Of Empty Containers Can Be Hazardous. Empty Containers Can Be Hazardous
If Used To Store Toxic, Flammable, Or Reactive Materials. Cutting Or Welding Of Empty Containers Might
Cause Fire, Explosion Of Toxic Fumes From Residues. Do Not Pressurize Or Expose To Open Flame Or
Heat.
Section IX- ADDITIONAL INFORMATION
1.Title III Section 302/304- Extremely Hazardous Substance
Component: None
2. CERCLA SEC 1-2 (a)- Hazardous Substance
Component: None
3. Title III Sec. 311 Hazard Categorization
immediate health hazard
4. Title III Sec. 313- Toxic Chemicals
Component: None
N/A = Not Applicable N/D = Not Determined N/E = Not Established
|