MATERIAL SAFETY DATA SHEET
EPOXYSYSTEMS鈥? PRODUCT #214 TABLE TOP RESIN PART A
PRODUCT NAME: EPOXYSYSTEMS鈥? PRODUCT #214 TABLE TOP RESIN PART A HMIS CODES: H F RP
PRODUCT CODE:
SECTION 1: MANUFACTURER IDENTIFICATION
MANUFACTURER'S NAME: EPOXY SYSTEMS, INC.
ADDRESS: 9370 SW 208 Circle
Dunnellon, Fl 34431
EMERGENCY NUMBER: 1-800-633-8253 DATE PRINTED: 08/29/05
INFORMATION NUMBER: 1-352-489-1666 NAME OF PREPARER: N. LAMBERT
SECTION 2: HAZARDOUS INGREDIENTS/SARA III INFORMATION
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV WT % CARCINOGEN
Reaction Products of
25085-99-8 NE NE NO
Epichlorohydrin & Bis Phenol A
Substances listed are present in concentration of 1% or greater, or 0.1% if cited as a potential Carcinogen in the OSHA
hazards communication standard. Where proprietary ingredient is listed, the identity is available as provided in 29 CFR
1910.1200.
NE - Not Established
SECTION 3: PHYSICAL/CHEMICAL CHARACTERISTICS
BOILING RANGE
: Heavier than Air
VAPOR DENSITY
: -0-
VOC
: Low viscosity clear liquid
APPEARANCE
: 1.16
WEIGHT PER CM鲁
: Slower than Ether
EVAPORATION RATE
SECTION 4: FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: >480潞 F
METHOD USED:
FLAMMABLE LIMITS IN AIR BY VOLUME - LOWER: Not determined
UPPER: Not determined
EXTINGUISHING MEDIA: Foam, dry chemical CO 2
SPECIAL FIRE FIGHTING PROCEDURES: Use self-contained breathing apparatus.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
SECTION 5: REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID: Excess heating or long periods of time degrades the resin.
INCOMPATIBILITY (MATERIALS TO AVOID): Avoid contact with strong oxidizing agents, strong acids, strong bases.
Mixing large quantities ( 1 gallon) with amines or epoxy hardeners can cause heat build-up and hazardous reaction.
HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: Carbon Monoxide, Carbon Dioxide.
HAZARDOUS POLYMERIZATION: May occur--Avoid excess contact with alphatic amine curing agents.
SECTION 6: HEALTH HAZARD DATA
HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
EYES: May cause eye irritation.
SKIN: May cause skin irritation.
HEALTH HAZARDS (ACUTE AND CHRONIC):
CARCINOGENICITY: NTP CARCINOGEN: IARC MONOGRAPHS: OSHA REGULATED:
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
EMERGENCY AND FIRST AID PROCEDURES:
EYES: Flush at once with potable water for at least 15 minutes and seek medical attention immediately.
SKIN: Wash with soap and warm water. Remove contaminated clothes. Wash before reuse. Destroy
contaminated shoes.
INGESTION: Not likely to occur in normal handling. Give large quantities of water and get medical attention.
INHALATION: Remove to fresh air. Administer oxygen if breathing is difficult.
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Avoid contact. Soak up with clay or other
absorbent material. Place in covered container for disposal. Flush contaminated area with water.
WASTE DISPOSAL METHOD: Dispose in an approved incinerator or an approved landfill.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Practice reasonable care and cleanliness.
OTHER PRECAUTIONS: Avoid gross contamination with skin. Wash off skin with soap and water.
SECTION 8: CONTROL MEASURES
RESPIRATORY PROTECTION: Dust respirator NIOSH approved.
VENTILATION: General mechanical ventilation and local exhaust
PROTECTIVE GLOVES: Impervious Gloves
EYE PROTECTION: Splash proof goggles
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Provide eye fountain and safety shower.
SECTION 9: REGULATORY INFORMATION
D. O. T. PROPER SHIPPING NAME: Synthetic Resin Liquid
PROPER SHIPPING NAME: Synthetic Resin Liquid
HAZARD CLASS: non-hazardous
UN/NA ID NUMBER:
SECTION 10: DISCLAIMER
Data and recommendations presented herein are based upon our and other researchers and are believed to be accurate.
The products discussed are distributed without warranty (expressed or implied) and the customer shall make his own
determination of suitability for his particular purpose.
MATERIAL SAFETY DATA SHEET
EPOXYSYSTEMS鈥? PRODUCT #214 TABLE TOP RESIN PART B
PRODUCT NAME: EPOXYSYSTEMS鈥? PRODUCT #214 TABLE TOP RESIN PART B HMIS CODES: H F RP
PRODUCT CODE: 31 0C
SECTION 1: MANUFACTURER IDENTIFICATION
MANUFACTURER'S NAME: EPOXY SYSTEMS, INC.
ADDRESS: 9370 SW 208 Circle
Dunnellon, FL 34431
EMERGENCY NUMBER: 1-800-933-8253 DATE PRINTED: 08/29/05
INFORMATION NUMBER: 1-352-489-1666 NAME OF PREPARER: N. Lambert
SECTION 2: HAZARDOUS INGREDIENTS/SARA III INFORMATION
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV WT % CARCINOGEN
Bezyl Alcohol 100-51-6 NE >40%
Isophornediamine 2855-13-2 NE <40%
Substances listed are present in concentration of 1% or greater, or 0.1% if cited as a potential Carcinogen in the OSHA
hazards communication standard. Where proprietary ingredient is listed, the identity is provided in 29 CFR 1910.1200.
NE - Not Established
SECTION 3: PHYSICAL/CHEMICAL CHARACTERISTICS
: NE
BOILING RANGE
: NE
VAPOR DENSITY
: NE
VAPOR PRESSURE
: NE
FREEZING/MELTING POINT
: -0-
VOC
: Slight; <1% @ 20C (70F)
SOLUBILITY IN WATER
: amber liquid.
APPEARANCE
: Ammonia
ODOR
: 1.01 @ 21C (70F)
SPECIFIC GRAVITY (H20=1)
: NE
EVAPORATION RATE
: 100 @ 25C (77F)
VISCOSITY (cps)
: Mixture
MOLECULAR WEIGHT
SECTION 4: FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: Approx. 203潞 F
METHOD USED: Closed Cup
FLAMMABLE LIMITS IN AIR BY VOLUME - LOWER: Not determined.
UPPER: Not determined.
EXTINGUISHING MEDIA: Foam, dry chemical, CO2, water spray
OSHA FLAMMABILITY CLASSIFICATION: Combustible liquid, Class III B
SPECIAL FIRE FIGHTING PROCEDURES: Wear NIOSH approved self-contained breathing apparatus with independent
air supply. Keep containers cool with water spray. Avoid skin contact. Contain runoff water in dikes. Prevent
stream contamination. Remain expended liquids from fire fighting for later disposal. Firefighters should wear butyl
rubber boots, gloves, and body suit and self-contained breathing apparatus.
UNUSUAL FIRE AND EXPLOSION HAZARDS: May generate toxic or irritating combustio9n products. May generate
carbon monoxide gas. May generate toxic nitrogen oxide gases. Vapors may travel along ground to a source of
ignition and flash back. Vapors may collect in closed spaces such as sewers, caves, or closed structures. Sudden
reaction and fire may result if product is mixed with an oxidizing agent.
SECTION 5: REACTIVITY DATA
STABILITY: Stable.
CONDITIONS TO AVOID: Not applicable
INCOMPATIBILITY (MATERIALS TO AVOID): Oxidizing agents (i.e. perchlorates, nitrates)
HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: Carbon monoxde in a fire. Carbon Dioxide in a fire. Nitrogen
oxides in a fire. Nitrogen oxide can react with water vapors to form corrosive nitric acid (TLV=2ppm). Combustion of
product under oxygen-starved conditions can be expected to produce numerous toxic products including: nitriles,
amides. Irritating and toxic fumes at elevated temperatures.
HAZARDOUS POLYMERIZATION: will not occur.
SECTION 6: HEALTH HAZARD DATA
HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
EYES: May cause moderate eye irritation.
SKIN: May cause moderate skin irritation.
INHALATION: May cause moderate respriatory irritation.
HEALTH HAZARDS:
ACUTE: Contact with the skin or eys may cause irritation, redness, and discomfort which is transient. Inhalation of
vapors causes irritation of the respriatory tract and may cause adverse systemic effects. Risk of exposure to
hazardous concentrations of vapor under normal working conditions in a well ventilated space is minimal.
However, conditions such as spraying, or sudden release of hot liquid, which generate an aerosol, mists or fog
should be avoided. Ingestion may cause headache, nausea, vomiting, death unless treated promptly. Product
vapor in low concentrations can cause lacrimation, conjunctivitis, and crneal edema when absorbed into the
tissue of the eye from the atmosphere. Corneal edema may give rise to a perception of "blue haze" or "fog"
around lights. The effect is transient and has no known residual effect.
CHRONIC: Repeated and/or long term contact with the skin may cause primary skin irritation and dermitis.
Repeated and/or prolonged exposure to low concentrations of vapor may casue sore throat, eye irritation.
Repeated and/or long prolonged exposures may result in liver disorders (such as jaundice or liver enlargement),
kidney disorders (such as edema, or proteinurial), adverse respiratory effects (such as cough, tightness of chest
or shortness of breath), adverse skin effects (such as defatting, rash, irritation, or corrosion), adverse eye effcts
(such as conjuntivitis or corneal damage).
CARCINOGENICITY:
NTP CARCINOGEN: IARC MONOGRAPHS: OSHA REGULATED:
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Asthma; Chronic respiratory disease (e.g.
Bronchitis, Emphysema); Eye disease; Skin disorders and Allergies; Liver disorders.
EMERGENCY AND FIRST AID PROCEDURES:
EYES: Flush immediately for 15 minutes with large amounts of potable water. Get immediate medical attention.
SKIN: Flush immediately for 15 minutes with potable water. Except in the most minor, superficial and localized
burns, cover the affected area with a sterile dressing or clean sheeting and transport for midical care. DO NOT
APPLY GREASES OR OINTMENTS. Control shock, if present. Remove contaminated clothing. Launder
before reuse. Discard contaminated shoes. Get medical attention if swelling and/or irritation occurs.
INGESTION: DO NOT induce vomiting. Give milk or water to dilute stomach contents. Get immediate medical
attention. Note to physicians: This product is highly injurous to all tissues, similar to that of ammonia or
ammonia gas. Chemical pneumoitis, pulmonary edema, laryngeal edema and delayed scarring of the airway or
other affected tissues may occur following exposure. There is no specific treatment. Clinical management is
based on supportive treatment, which is similar to that for thermal burns.
INHALATION: Remove to fresh air. I breathing has stopped or is labored give assisted respiration. Supplemental
oxygen may be indicated. Prevent aspiration of vomit. Turn victim's head to the side. Assure mucus does not
obstruct airway. Get medical attention if effects persist.
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Stop the leak, if possible. Ventilate the
space involved. Reduce vapor spreading with a water spray. Shut off or remove all ignition sources. Construct a
dike to prevent spreading. If recovery is feasible, admix with dry soil, sand, or non-reactive absorbent and place in a
container or dumpster pending disposal. Flush area with water spray. Clean-up personnel must be equipped with
self-contained breathing apparatus and butryl rubber protective clothing.
WASTE DISPOSAL METHOD: Dispose of in approved incinerator or an approved landfill.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Avoid contact. Keep containers tightly closed when not
in use. Do not remove labels from empty containers. If mixtures of Part B and Part A are allowed to remain in the
mixing container past the pot life deadline, heat and a strong reaction will result.
OTHER PRECAUTIONS:
SECTION 8: CONTROL MEASURES
RESPIRATORY PROTECTION: Not required under normal conditions. In poorly ventilated areas, a cartridge mask
NIOSH approved fro organic vapors is recommeded. For emergency situations, use self-contained breathing
apparatus with pressure demand mode.
VENTILATION: Mechanical ventilation required if TLV is expected to be exceeded in confined areas.
PROTECTIVE GLOVES: Nitrile rubber gloves. In emergency situations, wear impermeable gloves with cuffs to prevent
spread of material to area above wrists.
EYE PROTECTION: Chemical safety glasses. Splash-proof eye goggles. In emergency situations, use eye goggles with
full face shield. Contact lenses should not be worn.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Body covering clothes
WORK/HYGIENIC PRACTICES: Practice good industrial hygiene. Wash with soap and water before eating or smoking.
SECTION 9: REGULATORY INFORMATION
D. O. T. PROPER SHIPPING NAME: Caustic Alkali Liquid, N.O.S. (Modified Cycloaliphatic Amines); 8; UN1719; PG II
PROPER SHIPPING NAME: Caustic Alkali Liquid, N.O.S. (Modified Cycloaliphatic Amines)
HAZARD CLASS: Class 8, Corrosive
UN/NA ID NUMBER: UN 1719
SECTION 10: DISCLAIMER
Data and recommendations presented herein are based upon our and other researchers and are believed to be accurate.
The products discussed are distributed without warranty (expressed or implied) and the customer shall make his own
determination of suitability for his particular purpose.
|