MATERIAL SAFETY DATA SHEET
MSDS DATE:07/27/07
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: M-BOND 610 ADHESIVE
SYNONYMS: N/A
PRODUCT CODES: 50410-30
MANUFACTURER: ELECTRON MICROSCOPY SCIENCES
DIVISION: 1560 INDUSTRY ROAD/P.O. BOX 550
ADDRESS: HATFIELD, PA 19440
EMERGENCY PHONE: 215-412-8400
CHEMTREC PHONE: 800-424 -4300
FAX PHONE: 215-412-8450
CHEMICAL NAME: N/A
CHEMICAL FAMILY: N/A
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
INGREDIENT:
TETRAHYDROFURAN
EPOXY NOVOLAC
METHYL ETHYL KETONE
% WT % VOL SARA 313 REPORTABLE
CAS NO.
109-99-9 58.0-64.4 N/A
28064-14-4 26.7-30.3 N/A
78-93-3 5.3-8.9 N/A
mg/m3
ppm
OSHA PEL-TWA: 200
OSHA PEL STEL : 250
OSHA PEL CEILING: 200
ACGIH TLV-TWA: 200
ACGIH TLV STEL: 300
ACGIH TLV CEILING: 300
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW:
ROUTES OF ENTRY: INHALATION, SKIN, INGESTION
POTENTIAL HEALTH EFFECTS
EYES:MAY CAUSE SEVERE IRRITATION OR BURNS. MAY CAUSE PAIN ON CONTACT. VAPORS MAY IRRITATE EYES.
SKIN: MAY CAUSE SEVERE IRRITATION OR BURNS. ABSORPTION INTO THE SKIN MAY CAUSE DERMATITIS. REPEATED
CONTACT MAY CAUSE DRYING OR FLAKING OF SKIN. MAY RARELY CAUSE AN ALLERGIC REACTION.
INGESTION: MAY CAUSE HEADACHE, NAUSEA, VOMITING, DIZZINESS, GASTROINTESTINAL IRRITATION
INHALATION: EXCESSIVE EXPOSURE TO SOLVENTS MAY CAUSE RESPIRATORY IRRITATION AND CENTRAL NERVOUS
SYSTEM DEPRESSION. SIGNS AND SYMPTOMS OF CENTRAL NERVOUS SYSTEM DEPRESSION, IN ORDER OF INCREASING
EXPOSURE, ARE HEADACHE, DIZZINESS, DROWSINESS, AND INCOORDINATION. SIGNS AND SYMPTOMS OF EXCESSIVE
EXPOSURE MAY BE NAUSEA AND/OR VOMITING.
ACUTE HEALTH HAZARDS: N/A
CHRONIC HEALTH HAZARDS: CHRONIC OVER-EXPOSURE MAY RESULT IN KIDNEY AND/OR LIVER DAMAGE
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: SKIN DISORDERS, RESPIRATORY SYSTEM DISEASE.
PAGE 1 OF 6
MATERIAL SAFETY DATA SHEET
MSDS DATE:07/27/07
CARCINOGENICITY
OSHA: N/A ACGIH: N/A NTP: N/A IARC: N/A
OTHER: N/A
SECTION 4: FIRST AID MEASURES
EYES: FLUSH WITH WATER FOR 15 MINUTES WHILE HOLDING EYELIDS OPEN. IF IRRITATION OCCURS, SEEK MEDICAL
ATTENTION
SKIN:FLUSH SKIN WITH WATER WHILE REMOVING CONTAMINATED CLOTHING. WASH AFFECTED AREA WITH SOAP AND
WATER. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
INGESTION: CALL A PHYSICIAN, IF SWALLOWED, DO NOT INDUCE VOMITING UNLESS DIRECTED TO DO SO BY A PHYSICIAN. IF
CONSCIOUS GIVE LARGE AMOUNTS OF WATER.
INHALATION: IF INHALED, MOVE TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION. IF BREATHING IS
DIFFICULT, GIVE OXYGEN.
NOTES TO PHYSICIANS OR FIRST AID PROVIDERS: N/A
SECTION 5: FIRE-FIGHTING MEASURES
FLAMMABLE LIMITS IN AIR, UPPER: 11.8
(% BY VOLUME) LOWER: 1.8
FLASH POINT:
F: 6 DEG
C: -14 DEG
METHOD USED: PMCC
AUTOIGNITION TEMPERATURE:
F: 610 DEG
C: 320 DEG
NFPA HAZARD CLASSIFICATION
HEALTH: N/A FLAMMABILITY: N/A REACTIVITY: N/A
OTHER: N/A
HMIS HAZARD CLASSIFICATION
HEALTH: N/A FLAMMABILITY: N/A REACTIVITY: N/A
PROTECTION: N/A
EXTINGUISHING MEDIA: ALCOHOL FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER MAY BE INEFFECTIVE
SPECIAL FIRE FIGHTING PROCEDURES: FIREFIGHTERS SHOULD WEAR PROPER PROTECTIV EQUIPMENT AND SELF-
CONTAINED BREATHING APPARATUS WITH FULL FACEPIECE OPERATED IN THE POSITIVE PRESSURE MODE. MOVE
CONTAINERS FROM FIRE AREA IF IT CAN BE DONE WITHOUT RISK. USE WATER TO KEEP FIRE-EXPOSED CONTAINERS COOL.
UNUSUAL FIRE AND EXPLOSION HAZARDS: VAPORS MAY FLOW ALONG SURFACES TO DISTANT IGNITION SOURCE AND
FLASH BACK CLOSED CONTAINERS EXPOSED TO HEAT MAY EXPLODE. CONTACT WITH STRONG OXIDIZERS MAY CAUSE FIRE.
MAY FORM EXPLOSIVE PEROXIDES, ESPECIALLY WHEN HEATED.
HAZARDOUS DECOMPOSITION PRODUCTS: N/A
SECTION 6: ACCIDENTAL RELEASE MEASURES
ACCIDENTAL RELEASE MEASURES:
PAGE 2 OF 6
MATERIAL SAFETY DATA SHEET
MSDS DATE:07/27/07
KEEP UNNECESSARY PEOPLE AWAY; ISOLATE HAZARD AREA. WEAR SELF-CONTAINED BREATHING APPARATUS AND FULL
PROTECTIVE CLOTHING. SHUT OFF IGNITION SOURCES; NO FLARES, SMOKING OR FLAMES IN AREA. STOP LEAK IF YOU CAN
DO SO WITHOUT RISK. KEEP OUT OF STORM DRAINS, SURFACE WATERS AND SOIL. USE CONTAINER FOR LATER DISPOSAL.
FLUSH AREA WITH WATER.
SECTION 7: HANDLING AND STORAGE
HANDLING AND STORAGE: KEEP CONTAINERS TIGHTLY CLOSED. STORE IN A COOL, DRY, WELL-VENTILATED, FLAMMABLE
LIQUID STORAGE AREA. TAKE PRECAUTIONARY MEASURES AGAINST STATIC DISCHARGES. KEEP AWAY FROM OPEN FLAMES
AND SPARK PRODUCING EQUIPMENT. KEEP PRODUCT OUT OF LIGHT.
OTHER PRECAUTIONS: KEEP CONTAINERS TIGHTLY SEALED WHEN NOT IN USE. BOND TO GROUND CONTAINERS WHEN
TRANSFERRING LIQUID. USE CAUTION WHEN OPENING CAP. AVOID PROLONGED EXPOSURE TO VAPORS AND SKIN CONTACT.
AVOID BREATHING VAPORS
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS:
VENTILATION: USE ONLY WITH ADEQUATE VENTILATION
LOCAL EXHAUST: KEEP BELOW TLV
MECHANICAL: KEEP BELOW TLV
RESPIRATORY PROTECTION: RESPIRATORY PROTECTION REQUIRED IF AIRBORNE CONCENTRATION EXCEEDS TLV. AT
CONCENTRATIONS UP TO 1000 PPM, A CHEMICAL CARTRIDGE RESPIRATOR WITH ORGANIC VAPOR CARTRIDGE IS
RECOMMENDED ABOVE THIS LEVEL, A SELF-CONTAINED BREATHING APPARATUS IS RECOMMENDED.
EYE PROTECTION: CHEMICAL SPLASH GOGGLES RECOMMENDED
SKIN PROTECTION: USE GLOVES IMPERVIOUS TO THIS MATERIAL WHEN PROLONGED OR FREQUENTLY REPEATED CONTACT
COULD OCCUR. NEOPRENE GLOVES RECOMMENDED
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: IMPERVIOUS OVER-CLOTHING AS NEEDED TO PREVENT SKIN CONTACT.
SAFETY SHOWER AND EYE WASH STATION IN LOCAL AREA.
WORK HYGIENIC PRACTICES: WASH THOROUGHLY AFTER HANDLING. WASH CLOTHING BEFORE REUSE.
EXPOSURE GUIDELINES: N/A
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: COLORLESS
ODOR: ETHER-LIKE ODOR
PHYSICAL STATE: LIQUID
pH AS SUPPLIED: N/A
pH (Other): N/A
BOILING POINT:
F: 150 DEG
C: 66 DEG
MELTING POINT: N/A
F: N/A
C: N/A
FREEZING POINT: N/A
F: N/A
PAGE 3 OF 6
MATERIAL SAFETY DATA SHEET
MSDS DATE:07/27/07
C: N/A
VAPOR PRESSURE (mmHg): 129
@
F: 68 DEG
C: 20 DEG
VAPOR DENSITY (AIR = 1): 2.4
@
F: N/A
C: N/A
@
F: N/A
C: N/A
EVAPORATION RATE:
BASIS (=1): 8.0
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES (con鈥檛)
SOLUBILITY IN WATER: APPRECIABLE ( MORE THAN 50%)
PERCENT SOLIDS BY WEIGHT: N/A
PERCENT VOLATILE: N/A
BY WT/ BY VOL @
F: N/A
C: N/A
VOLATILE ORGANIC COMPOUNDS (VOC): N/A
WITH WATER: N/A LBS/GAL
WITHOUT WATER: N/A LBS/GAL
MOLECULAR WEIGHT: N/A
VISCOSITY: N/A
@
F: N/A
C: N/A
SECTION 10: STABILITY AND REACTIVITY
STABILITY: STABLE
CONDITIONS TO AVOID (STABILITY): HEAT, FLAME, OTHER SOURCES OF IGNITION, LIGHT AND AIR. AVOID SUBJECTING RESIN
TO TEMPERATURES ABOVE 90 DEG F/32 DEG C DUE TO THE PRESENCE OF VOLATILE METHYL ETHYL KETONE
INCOMPATIBILITY (MATERIAL TO AVOID): ACIDS, STRONG OXIDIZING AGENTS, STRONG BASES, STRONG REDUCING AGENTS
HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: CARBON MONOXIDE, CARBON DIOXIDE, EXPLOSIVE PEROXIDES,
PHENOLICS.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR BY ITSELF, BUT MASSES OF MORE THAN ONE POUND OF PRODUCT PLUS
AN ALIPHATIC AMINE WILL CUASE IRREVERSIBLE POLYMERIZATION WITH CONSIDERABLE HEAT BUILDUP
CONDITIONS TO AVOID (POLYMERIZATION): N/A
SECTION 11: TOXICOLOGICAL INFORMATION
TOXICOLOGICAL INFORMATION:
TETRAHYDROFURAN
OSHA PEL: 200 PPM (TWA)
ACGIH TLV: 200 PPM
OTHER: 250 OOM (STEL)
PAGE 4 OF 6
MATERIAL SAFETY DATA SHEET
MSDS DATE:07/27/07
LD50 IPR (RAT) 2900 MG/KG
3
LC50 INHAL (RAT) 78 G/M
EPOXY NOVOLAC
OTHER: LD50 SKIN (RABBIT) > 2000 MG/KG
LD50 ORAL (RAT) > 4000 MG/KG
METHYL ETHYL KETONE
OSHA PEL: 200 PPM(TWA)
ACGIH TLV: 200 PPM
OTHER: 300 PPM (STEL)
LD50 ORAL (RAT) 2737 MG/KG
LD50 IPR (MOUSE) 616 MG/KG
LD50 SKIN (RABBIT) 13 G/KG
SECTION 12: ECOLOGICAL INFORMATION
ECOLOGICAL INFORMATION: N/A
SECTION 13: DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD: COMPLY WITH FEDERAL, STATE, LOCAL REGULATIONS. DO NOT DUMP INTO ANY SEWERS, ON
THE GROUND, OR INTO ANY BODY OF WATER. ALL DISPOSAL METHODS MUST BE IN ACCORDANCE WITH ALL LOCAL, STATE
AND FEDERAL ENVIRONMENTAL REGULATIONS. REGULATIONS MAY VARY IN DIFFERENT LOCATIONS. WASTE
CHARACTERIZATIONS AND COMLIANCE WITH APPLICABLE LAWS ARE THE RESPONSIBILITY OF THE WASTE GENERATOR
RCRA HAZARD CLASS: N/A
SECTION 13: DISPOSAL CONSIDERATIONS (con鈥檛)
SECTION 14: TRANSPORT INFORMATION
U.S. DEPARTMENT OF TRANSPORTATION
PROPER SHIPPING NAME: FLAMMABLE LIQUIDS, N.O.S. ( TETRAHYDROFURAN/ETHYL METHYL KETONE) (METHYL ETHYL
KETONE)
HAZARD CLASS: 3
ID NUMBER: 1993
PACKING GROUP: II
LABEL STATEMENT: FLAMMABLE LIQUID
WATER TRANSPORTATION
PROPER SHIPPING NAME:
HAZARD CLASS: SAME
ID NUMBER:
PACKING GROUP:
LABEL STATEMENTS:
AIR TRANSPORTATION
PROPER SHIPPING NAME:
HAZARD CLASS: SAME
ID NUMBER:
PACKING GROUP:
LABEL STATEMENTS:
OTHER AGENCIES: N/A
SECTION 15: REGULATORY INFORMATION
U.S. FEDERAL REGULATIONS
PAGE 5 OF 6
MATERIAL SAFETY DATA SHEET
MSDS DATE:07/27/07
TSCA (TOXIC SUBSTANCE CONTROL ACT): ALL COMPONENTS OF THIS PRODUCT ARE LISTED IN THE TOXIC SUBSTANE
CONTROL ACT CHEMICAL SUBSTANCE INVENTORY (TSCA).
CERCLA (COMPREHENSIVE RESPONSE COMPENSATION, AND LIABILITY ACT): N/A
SARA TITLE III (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT): CONTAINS A TOXIC CHEMICAL OR CHEMICALS
SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 TITLE III OF THE SUPERFUND AMNDMENT AND
REAUTHORIZATION ACT OF 1986 AND 40 CFR PART 372
311/312 HAZARD CATEGORIES: N/A
313 REPORTABLE INGREDIENTS: METHYL ETHYL KETONE
STATE REGULATIONS: N/A
INTERNATIONAL REGULATIONS: N/A
SECTION 16: OTHER INFORMATION
OTHER INFORMATION: N/A
PREPARATION INFORMATION: N/A
DISCLAIMER: IN COMPLIANCE WITH THE OSHA HAZARD COMMUNICATION STANDARD, 2.9 C.F.R
1910. 1200, WE ARE PROVIDING YOU WITH A MSDS FOR THE HAZARDOUS MATERIAL YOU ARE
PURCHASING.
IT IS YOUR RESPONSIBILITY TO EDUCATE YOUR EMPLOYEES ON THE SAFE USE OF THE HAZARDOUS
MATERIAL.
ELECTRON MICROSCOPY SCIENCES MAKES NO PRESENTATION AS TO THE ACCURACY OF THE
INFORMATION IN THE MSDS. THE INFORMATION IS BELIEVED TO BE CORRECT; HOWEVER, YOU
(THE CUSTOMER), SHOULD PERFORM YOUR OWN INVESTIGATION AND INDEPENDENT
VERIFICATION. IF YOU RESELL THE PRODUCT, YOU ARE RESPONSIBLE TO FORWARD THE
INFORMATION IN THE MSDS TO YOUR CUSTOMER.
PAGE 6 OF 6
|