MTL Bio-Clear 1000
Page 2 of 3
MATERIAL SAFETY DATA SHEET
INHALATION: Remove patient to fresh air. Apply artificial respiration as required. seek medical attention
SECTION V: PHYSICAL DATA
APPEARANCE AND ODOUR: White powder, disinfectant
SPECIFIC GRAVITY: N/A
BOILING POINT (掳C): N/A
MELTING POINT (掳C): N/A
SOLUBILITY IN WATER: 1.5% @ 23掳C
PERCENT VOLATILE BY VOLUME: N/A
EVAPORATION RATE: Is slower than Butyl Acetate
VAPOUR PRESSURE (mm Hg): N/A
BULK DENSITY (lb/ft3): 1.33 g/cc
SECTION VI: FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: N/A
FLAMMABLE LIMITS: N/A
EXTINGUISHING MEDIA: Fog , Water
SPECIAL FIRE FIGHTING PROCEDURES: Wear self-contained breathing apparatus
UNUSUAL FIRE AND EXPLOSION HAZARDS: None
SECTION VII: REACTIVITY DATA
STABILITY: Stable [XX] Unstable [ ]
INCOMPATIBILITY (CONDITIONS TO AVOID): Strong contact with strong bases
CONDITIONS OF REACTIVITY: Excessive heat (>70掳C)
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon dioxide which can act as an asphyxiant
HAZARDOUS POLYMERIZATION: Will Not Occur [XX] May Occur [ ]
VIII: PREVENTIVE MEASURES
SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: If in concentration are high suggest use of a NIOSH approved
MTL Bio-Clear 1000
Page 3 of 3
MATERIAL SAFETY DATA SHEET
full facepiece organic vapour respirator.
VENTILATION: Local Exhaust
PROTECTIVE GLOVES: Chemical resistant gloves
EYE PROTECTION: Safety glasses or goggles
OTHER PROTECTIVE EQUIPMENT: None
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Avoid contact with eyes, skin or clothing. Do not use empty container for any reason. Wash thoroughly after
handling
STEPS TO BE TAKEN IN CASE THE MATERIAL IS SPILLED OR RELEASED
Pick up spill with broom, shovel, or vacuum. Place contaminated material in approved disposal container.
WASTE DISPOSAL METHOD
Dispose of in accordance with federal, provincial and local regulations. It is the responsibility of the user to
determine if contaminated material meets hazardous waste requirements.
SECTION IX: PREPARATION
THE INFORMATION CONTAINED HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY, EXPRESSED
OR IMPLIED, IS MADE.
DATE PRINTED: April 20, 2006 BY: MILLENNIUM TECHNOLOGIES LTD.
DATE MODIFIED: May 17, 2004 APPROVED BY:
SUPERSEDES: October 1, 2003
24 HOUR PHONE: 403-252-5904
|