Drispac Liquid
Page 1 of 3
MATERIAL SAFETY DATA SHEET
SECTION I: IDENTIFICATION OF PRODUCT
PRODUCT NAME: Drispac Liquid
PRODUCT USE: Drilling Mud Additive CAS NO. N/A
CHEMICAL FAMILY: Mixture
WORK PLACE HAZARDOUS MATERIALS INFORMATION SYSTEM (WHMIS)
WHMIS CLASSIFICATION: Not a controlled product under WHMIS
WORK PLACE HAZARD: N/A
TRANSPORTATION OF DANGEROUS GOODS (TDG)
SHIPPING NAME: Petroleum Product, N.O.S.
TDG CLASSIFICATION: Combustible liquid
UN NUMBER (PIN): 1268
PACKING GROUP: III
SECTION II: HAZARDOUS INGREDIENTS
INGREDIENT PERCENT CAS NUMBER LD Oral-Rat OSHA PEL ACGIH TLV
(50)
Petroleum Distillates 55 64742-47-8 N/A N/A N/A
SECTION III: TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY: [XX] SKIN [XX] EYE CONTACT [XX] INHALATION [XX] INGESTION
EYE CONTACT : May cause mild irritant.
SKIN CONTACT: Repeated/ prolonged contact may result in defatting of skin, irritation and dermatitis.
INGESTION: Low toxicity, may produce diarrhoea.
INHALATION: High Vapour concentrations may cause headache, dizziness, nausea, and
unconsciousness.
SECTION IV: FIRST AID MEASURES
SKIN CONTACT: Wash with soap and water for at least 15minutes. If irritation and/or adverse symptoms develop,
seek medical attention.
Drispac Liquid
Page 2 of 3
MATERIAL SAFETY DATA SHEET
EYE CONTACT: Flush eyes with running water for at least 15 minute. If irritation or adverse symptoms develop, seek
medical attention.
INGESTION: Give 2 glasses of water and induce vomiting, only if subject in conscious. Seek medical attention.
INHALATION: Remove from exposure. If breathing is difficult, give oxygen. If breathing causes, administer
artificial respiration followed by oxygen. Seek medical attention immediately.
SECTION V: PHYSICAL DATA
APPEARANCE AND ODOUR: Off-White Viscous Liquid
SPECIFIC GRAVITY: 0.97
217-237 C
BOILING POINT (掳C):
N/A
MELTING POINT (掳C):
pH: N/D
SOLUBILITY IN WATER: N/A
PERCENT VOLATILE BY VOLUME: N/A
EVAPORATION RATE: N/A
VAPOUR PRESSURE (mm Hg): N/A
VAPOUR DENSITY (Air = 1): N/A
SECTION VI: FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: N/A
FLAMMABLE LIMITS: N/A
EXTINGUISHING MEDIA: Use media suitable for surrounding fire.
SPECIAL FIRE FIGHTING PROCEDURES: Fire fighting personnel wear self -contained breathing apparatus.
UNUSUAL FIRE AND EXPLOSION HAZARDS: None known.
SECTION VII: REACTIVITY DATA
STABILITY: Stable [XX] Unstable [ ]
INCOMPATIBILITY (CONDITIONS TO AVOID): Strong oxidizing materials
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon oxides formed when burned.
Drispac Liquid
Page 3 of 3
MATERIAL SAFETY DATA SHEET
HAZARDOUS POLYMERIZATION: Will Not Occur [XX] May Occur [ ]
SECTION VIII: PREVENTIVE MEASURES
SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: None generally required. may need to prevent respiratory irritation.
Use NIOSH approved air purifying respirator with organic vapour.
VENTILATION: Use adequate ventilation to control exposures, recommended limit
of 400ppm (total hydrocarbons in air).
PROTECTIVE GLOVES: Use rubber or neoprene gloves.
EYE PROTECTION: Goggles/ safety glasses with side shields if splashes could occur.
OTHER PROTECTIVE EQUIPMENT (Specify :) Ensure eyewash station and safety shower is available.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Wash thoroughly after handling. Avoid contact with eyes, skin or clothing. Avoid breathing vapours, mists, fumes,
or dust. Wear protective equipment and/or garments described in MSDS if exposure conditions warrant. Lauder
contaminated clothing before reuse. Use with adequate ventilation. Keep away from heat, sparks, and flame. Bond
and ground during liquid transfer. Store in cool, dry, well ventilated area in a closed container.
STEPS TO BE TAKEN IN CASE THE MATERIAL IS SPILLED OR RELEASED
Evacuate area of all necessary personnel. Shut off source, if possible and contain spill. Protect from ignition. Keep
out of water source and sewers. Absorb in dry inert material (sand, Clay, sawdust, etc) and transfer to disposal
container non-sparking equipment.
WASTE DISPOSAL METHOD
Dispose of material in accordance with local, provincial and federal ordinances. It is the responsibility of the user to
determine if waste meets the criteria of hazardous waste
SECTION IX: PREPARATION
THE INFORMATION CONTAINED HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY, EXPRESSED OR
IMPLIED, IS MADE.
DATE PRINTED: April 6, 2006 BY: MILLENNIUM TECHNOLOGIES LTD.
DATE MODIFIED: May 26, 2004 APPROVED BY:
SUPERSEDES: October 1, 2003
|