FIR No. 158358 03/20/2003
MATERIAL SAFETY DATA SHEET
Ford Internal Reference Number(Tox No. : 158358)
Print Date : 03/19/03
Language: English
Part Type and Number Part name
鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭? 鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝
Motorcraft 鈭? U.S. XG鈭?5 MOTORCRAFT CONSTANT VELIOCITY JOINT
GREASE (90 GRAM TUBE)
Approved to Active Production鈭扺orldwide spec WSS鈭扢1C258鈭扐1
====================== CHEMICAL AND PHYSICAL PROPERTIES =======================
Appearance : Physical State GREASE
Form 鈭?
Color GREEN
Specific Gravity (Relative Density) 0.9
Boiling Point +388 掳C
Flash Point >+180 掳C (>+356 F) (CLEVELAND OPEN
CUP)
pH full strength Not Determined
pH diluted Not Determined
Odor MINERAL OIL
Odor Threshold 鈭?
Viscosity 鈭?
Vapor Density 5 (AIR = 1)
Vapor Pressure 0.01 mmHg at 20C
Evaporation Rate 鈭?
Freezing Point 鈭?
Explosion Properties : UEL Not Determined
LEL Not Determined
Auto鈭抜gnition Temperature +260 掳C
Solubility NEGLIGIBLE in Water
Partition Coefficient 鈭?
================== HAZARDOUS AND OTHER DISCLOSED INGREDIENTS ==================
Percent Exposure Limits 鈭? TWA
Range ACGIH/OSHA(where est.) CAS number Chemical Name
鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝 鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝 鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝 鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝
>30鈭?60 5/5 64741鈭?88鈭?4 PETROLEUM DISTILLATES,
Ford= 1.0 mg/m3 SOLVENT鈭扲EFINED HEAVY
PARAFFINIC
>30鈭?60 5/5 64742鈭?65鈭?0 PETROLEUM DISTILLATES,
Ford= 1.0 mg/m3 SOLVENT DEWAXED HEAVY
PARAFFINIC
<.1 0.5(S2.5)/1(S5) ppm 71鈭?43鈭?2 BENZENE
O+I+N
<.1 100(S125)/100(S125) 100鈭?41鈭?4 ETHYLBENZENE
ppm
1/5
FIR No. 158358 03/20/2003
<.1 100(S150)/100(S150) 1330鈭?20鈭?7 XYLENE (ALL ISOMERS)
ppm
Exposure Limit Abbreviations
鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝鈭掆垝
TWA=Time Weighted Average C=Ceiling
S=Short Term Exposure Sk=Skin
Sol=Soluble Compounds Fu=Fumes
Insol=Insoluble Compounds Du=Dust I=IARC Resp=Respirable
=========================== REGULATORY INFORMATION ============================
This product contains trace levels (<0.1%) of a potential carcinogen.
If oil mist is generated, observe the OSHA exposure limit of 5 mg/m3. Ford
Motor Company recommends an exposure limit of 1.0 mg/m3.
The supplier of this product did not provide information concerning the
classification of this product under the Canadian Controlled Products Act.
========================== HEALTH HAZARD INFORMATION ==========================
=(A)=============================== HAZARDS ===================================
This product is harmful if swallowed.
This product may be harmful by inhalation.
Prolonged and/or repeated skin contact with this product may cause
irritation/dermatitis.
This product may cause irritation to the eyes and skin.
If this material is injected beneath the skin, regardless of amount injected,
get immediate medical attention. Do not wait for symptoms to develop.
=(B)================ TARGET ORGANS AND MEDICAL CONDITIONS =====================
Overexposure to some hazardous ingredients in this product has been found
to affect certain body organs and systems in experimental animals and/or
humans. These include:
Skin, Eyes, and Respiratory System
=(C)===================== ACUTE TOXICITY INFORMATION ==========================
Based on the composition of the product identified by the supplier,
selected portions of the acute toxicity information from RTECS are
as follows:
71鈭?43鈭?2 BENZENE
Inhalation, adult rat, LC50 = 10000 ppm (7 Hours)
Oral, adult rat, LD50 = 3306 mg/kg
Skin, mouse, LD50 = 48 mg/kg
100鈭?41鈭?4 ETHYLBENZENE
Oral, adult rat, LD50 = 3500 mg/kg
Skin, adult rabbit, LD50 = 17800 mg/kg
1330鈭?20鈭?7 XYLENE (ALL ISOMERS)
Inhalation, adult rat, LC50 = 5000 ppm (4 Hours)
Oral, adult rat, LD50 = 4300 mg/kg
3033鈭?62鈭?3 BIS[2鈭?(DIMETHYLAMINO) ETHYL] ETHER
Oral, adult rat, LD50 = 1070 mg/kg
Skin, adult rabbit, LD50 = 280 mg/kg
======================= FIRE AND EXPLOSION INFORMATION ========================
Empty containers may retain product residue including Flammable or
Explosive vapors. Do not cut, drill, grind, or weld near full,
partially full, or empty product containers.
2/5
FIR No. 158358 03/20/2003
This product is not combustible.
EXTINGUISHER INFORMATION: Dry chemical, foam, carbon dioxide.
A fine spray or fog of water will reduce the intensity of flames. Do not use
a solid stream of water, as this could spread the fire. Firemen should wear
a self鈭抍ontained breathing apparatus.
Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or
low molecular weight hydrocarbons.
Decomposition of this product may yield oxides of phosphorus.
Decomposition of this product may yield hydrogen sulfide and sulfur dioxide.
Decomposition of this product may yield oxides of sulfur and nitrogen.
Irritating and/or toxic fumes and gases may be emitted upon heating of
this product.
Use water to flush spills from the area of the fire.
Water may be used to cool exposed containers to prevent pressure build鈭抲p
and explosion when exposed to extreme heat.
=============================== REACTIVITY DATA ===============================
This is a stable material.
Hazardous polymerization will not occur.
This product may react with strong oxidizing agents (bleach鈭掆垝sodium
hypochlorite, calcium hypochlorite, hydrogen peroxide, permanganate,
nitric acid, concentrated OXYGEN, perchlorates).
============================= PREVENTIVE MEASURES =============================
=(A)====================== SAFE HANDLING AND STORAGE ==========================
Do not breathe gas/fumes/vapor/spray.
Keep the container tightly closed and in a cool, well鈭抳entilated place.
Avoid getting this material into contact with your skin and eyes.
Avoid prolonged or repeated skin contact with this material.
Ground all containers of this material.
Use this product with adequate ventilation.
Keep this product from heat, sparks, or open flame.
Do not reuse the empty container.
Avoid the generation of oil mists.
Petroleum distillate base oils used in the product are severely hydrotreated
and/or solvent refined.
=(B)========================= PROTECTIVE MEASURES =============================
Use general ventilation and use local exhaust, where possible, in confined or
enclosed spaces.
Use of protective coveralls and long sleeves is recommended.
Wear impervious gloves for prolonged contact.
Wear chemical goggles; face shield (if splashing is possible).
Use an organic vapor respirator for concentrations exceeding the Occupational
Exposure Limit.
=(C)===================== SPILLS, LEAKS AND DISPOSAL ==========================
Wear appropriate protective equipment and clothing during clean鈭抲p.
Do not allow this material to drain into sewers/water supplies.
Thoroughly wash the area after a spill or leak clean鈭抲p.
Attempt to reclaim the free product, if this is possible.
Eliminate all sources of ignition or flammables that may come into contact
with a spill of this material.
Absorb the spilled material with an inert absorbent (nonflammable) material.
Avoid excessive skin contact with the spilled material.
Dispose of waste material according to Local, State, Federal, and
Provincial Environmental Regulation.
3/5
FIR No. 158358 03/20/2003
============================= FIRST AID TREATMENT =============================
In case of contact with eyes, rinse immediately with plenty of water and seek
medical advice.
Remove contaminated clothing and wash before reuse.
If the material is swallowed, get immediate medical attention or advice 鈭掆垝
Do not induce vomiting.
If gas/fume/vapor/dust/mist from the material is inhaled, remove the affected
person immediately to fresh air.
For skin contact, wash immediately with soap and water.
If irritation persists, get medical attention.
============================= NOTES TO PHYSICIANS =============================
This material, if aspirated into the lungs, may cause chemical pneumonitis;
treat the affected person appropriately.
=============================== SPECIAL REMARKS ===============================
Petroleum distillate base oils used in the product are severely hydrotreated
and/or solvent refined.
===================== ENVIRONMENTAL INFORMATION: ECOLOGY ======================
Material contains a chemical which is a Ford Motor Company Material of
Concern. Use and release of this material should be minimized to the
greatest extent possible.
This product contains a chemical which is restricted at any concentration by
the Ford Motor Company Restricted Substance Management Standard (RSMS),
WSS鈭扢99P9999鈭扐1. Consult the RSMS for restricted applications. If used in a
restricted application, prior notification to and acknowledgement from Ford
Motor Company is required.
Material contains a chemical which is a Hazardous Air Pollutant (HAP),
regulated by the United States Clean Air Act.
============================ Transport Information ============================
U.S. Department of Transportation (DOT) 49 鈭? CFR 172.101
This product is not regulated as a dangerous good.
Canadian Transportation of Dangerous Goods (T.D.G.) 鈭扵DGR Schedule II
This product is not regulated as a dangerous good.
Secretary of Communication and Transportation (SCT)鈭? NOM鈭?002鈭扴CT2/1994 (Mexico)
This product has not been reviewed for this regulation.
International and Domestic Air Transportation 鈭? ICAO &IATA Section 4.2
This product has not been reviewed for this regulation.
International Water Transportation 鈭? IMDG Code Amendment 29鈭?98
This product has not been reviewed for this regulation.
=========================== PREPARATION INFORMATION ===========================
Health and safety information has been evaluated by:
Occupational &Environmental Health Sciences Department
Ford Motor Company
Central Laboratory Building 鈭? Rm S鈭?120
15000 Century Drive
4/5
FIR No. 158358 03/20/2003
Dearborn, Michigan 48120
For 24 hour emergency information dial 1鈭?800鈭?959鈭?3673.
This is the last page of this MSDS.
Date of Preparation: 06/19/00
5/5
|