Aexcel Corporation
Material Safety Data Sheet
I. PRODUCT AND COMPANY IDENTIFICATION
Product Name: 95A-D001
95A-D001
Product Code:
Black Epoxy Adhesive
Description:
Manufacturer:
Aexcel Corporation
7373 Production Drive
Mentor, OH 44060
Information: 440-974-3800
Phone Numbers:
Emergency/CHEMTREC: 800-424-9300
1 2002-04-04 13:06:52
MSDS Rev No./Date:
II. COMPOSITION/INFORMATION ON POTENTIALLY HAZARDOUS INGREDIENTS
Chemical Name CAS No. Wt % OSHA Permissible Exposure Limits (PEL)
STEL, ppm TWA, ppm
Nonylphenol 84852-15-3 34.59 N.E. N.E.
n-Aminoethylpiperazine 140-31-8 17.27 N.E. N.E.
III. HAZARDS IDENTIFICATION
HMIS Safety Ratings Health Flammability Reactivity
3 1 0
(0 - 4, 4 = severe hazard)
Health Hazards
Skin contact, Eye contact
Routes of Entry:
Central nervous system stimulation
Target Organs:
Immediate (Acute) Health Effects by Route of Exposure:
Harmful if absorbed through the skin.Vapors ormist may cause irritation of
Skin Absorption:
upper respiratory tract.Harmful. Causes burning of mouth, throat, and stomach
Inhalation:
with abdominal and chest pain.
Ingestion:
Can cause severe irritation. Eye contact may result in corneal injury. Symptoms
Eye Contact:
may include discomfort or pain, excess blinking and tear production, with
marked redness and swelling of the conjunctiva. Temporary vision impairment
(cloudy or blurred vision) is possible.
Long-Term (Chronic) Health Effects:
Reproductive/Developmental: No data available to indicate product or any components present at greater than
0.1% may cause birth defects.
No data available to indicate product or any components present at greater than
Mutagenicity:
0.1% is mutagenic or genotoxic.
Breathing large amounts may cause harmful effects. Severe overexposure may
Inhalation:
result in difficutly breathing, headache, nausea, vomiting, and drowsiness.
Swallowing large amounts is harmful, seek medical attention.
Ingestion:
Expected to cause severe skin damage with burns and blistering. Toxic effects
Skin Absorption:
due to skin absorption is possible.
95A-D001
Page 1 of 4
Notice: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent
brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may
be harmful or fatal.
IV. FIRST-AID MEASURES
Remove to fresh air. If not breathing, give artificial respiration. If breathing is
Inhalation:
difficult, give oxygen. Get immediate medical attention.
Immediately flush eyes with plenty of water for at least 20 minutes retracting
Eyes:
eyelids often. Tilt the head to prevent chemical from transferring to the
uncontaminated eye. Get immediate medical attention and monitor the eye daily
as advised by your physician.
Immediately flush skin with plenty of water. Remove clothing. Get medical
Skin Contact:
attention immediately. Wash clothing separately from other articles before reuse.
V. FIRE FIGHTING MEASURES
Combustible at elevated temperatures> 200 Deg. F. TCC
Flammability Summary:
Flash Point:
Flashpoint TCC deg F Autoignition Temp UEL % in air LEL % in air
Component Parameters:
deg F
Nonylphenol 300
n-Aminoethylpiperazine 205 1.0
VI. ACCIDENTAL RELEASE MEASURES
Small Spill: Eliminate all sources of ignition such as flares, flames, pilot lights, and sparks. Absorb liquid on
vermiculite, floor absorbent, or other absorbent material.
Large Spill: Eliminate all ignition sources (flares, flames including pilot lights, electrical sparks). Persons not
wearing protective equipment should be excluded from area of spill until clean-up has been completed. Stop spill at
source. Prevent from entering bare ground, drains, sewers, streams or other bodies of water. Prevent from spreading.
Pump or vacuum-transfer spilled product for recovery. Absorb unrecoverable product. Transfer contaminated
absorbent, soil and other materials to containers for disposal. Prevent run-off to bare ground, sewers, streams or other
bodies of water. If run-off occurs, notify proper authorities as required that a spill has occurred.
VII. HANDLING AND STORAGE
Handling/Storage: Containers of this material may be hazardous when emptied. Since emptied containers retain
product residues (vapor, liquid, and/or solid), all hazard precautions given in the data sheet must be observed. All
five-gallon pails and larger metal containers, including tank cars and tank trucks, should be grounded and/or bonded
when material is transferred. Emergency eyewash fountains and safety showers should be available in the
immediate vicinity of potential exposure.
VIII. EXPOSURE CONTROLS/PERSONAL PROTECTION
Provide sufficient general and/or local exhaust ventilation to maintain exposure
Engineering Measures:
below TLV(s).
If workplace exposure limit(s) of product or any component is exceeded,
Respiratory Protection:
a NIOSH/MSHA approved air supplied respirator is advised in absence of proper
environmental control. OSHA regulations also permit other NIOSH/MSHA
respirators under specified conditions. Engineering or administrative controls
should be implemented to reduce exposure.
95A-D001
Page 2 of 4
Wear chemically resistant safety glasses with side shields when handling this
Eye Protection:
product. Wear additional eye protection such as chemical splash goggles and/or
face shield when the possibility exists for eye contact with splashing or spraying
liquid, or airborne material. Do not wear contact lenses. Have an eye wash station
available.
Chemically resistant gloves
Gloves:
Control Parameters:
ACGIH TLV-TWA ppm ACGIH STEL ppm IDLH ppm
Chemical Name
Nonylphenol NE NE
n-Aminoethylpiperazine NE NE
IX. PHYSICAL AND CHEMICAL PROPERTIES
Heavy Black Liquid
Appearance:
11.52 lbs/gal
Bulk Density:
VP mmHg at deg F Vapor Density Evaporation Rate BP F
Component Properties:
(1 = air) (1 = n-butyl acetate) at 1 atm
Nonylphenol 1.0 68 7.4 590
n-Aminoethylpiperazine 0.1 4.4 410
X. STABILITY AND REACTIVITY
Stable under normal conditions.
Stability/Reactivity:
Avoid heat, sparks, open flame and other ignition sources.
Conditions to Avoid:
Strong oxidizing agents
Chemical Incompatibility:
XI. TOXICOLOGICAL INFORMATION
No data
XII. ECOLOGICAL INFORMATION
No data
XIII. DISPOSAL CONSIDERATIONS
Dispose of in accordance with all applicable local, state and federal regulations.
Disposal Methods:
XIV. TRANSPORTATION INFORMATION
Corrosive Liquid, N.O.S.(Contains n-Aminoethylpiperazine, Nonylphenol)
DOT Basic Description:
8
Hazard Class:
1760
UN Number:
XV. REGULATORY INFORMATION
A component or components of this product are listed on the TSCA Inventory of Existing Chemical
TSCA Status:
Substances.
Chemical Name CAS # Regulation
Nonylphenol 84852-15-3 SARA 312
XVI. ADDITIONAL INFORMATION
THE INFORMATION IN THIS MATERIAL SAFETY DATA SHEET (MSDS) IS TO THE BEST
Disclaimer:
OF OUR KNOWLEDGE TRUE AND ACCURATE, BUT IS OFFERED WITHOUT WARRANTY,
EXPRESS OR IMPLIED. CONDITIONS OF USE ARE BEYOND OUR CONTROL. NEITHER
95A-D001
Page 3 of 4
AEXCEL CORPORATION NOR ITS AGENTS SHALL BE LIABLE FOR ANY DIRECT OR
CONSEQUENTIAL INJURY, LOSS, OR DAMAGE ARISING FROM THE USE OR INABILITY
TO USE THE PRODUCT DESCRIBED HEREIN. NO PERSON IS AUTHORIZED TO MAKE ANY
STATEMENT OR RECOMMENDATION NOT CONTAINED IN THIS MSDS. ANY SUCH
STATEMENT OR RECOMMENDATION IF MADE SHALL NOT BIND THE CORPORATION.
95A-D001
Page 4 of 4
|