TECH LINE COATINGS, INC.
26844 ADAMS AVE. MURRIETA, CA 92562 USA
Phone 951-304-0498
Fax 951-461-9658
www.techlinecoatings.com
MATERIAL SAFETY DATA SHEET
SECTION I
COMMON NAME (S): MCBL, CermaBlue
CHEMICAL NAME (S) AND SYNONYM (S): ALUMINUM FILLED METALLIC CERAMIC COATING
CHEMICAL FAMILY: Not Applicable
FORMULA: Complex Mixture
EMERGENCY PHONE: (Chemtrec) 1-800-424-9300
INFORMATION PHONE: 951-304-0498
DATE PREPARED: 9/29/2003
SECTION II
HAZARDOUS INGREDIENTS CAS# CONCENTRATIONS
ALUMINUM POWDER 7429-90-5 <25%
ACGIH TLV: 10mg/M3
Cobalt Aluminate Blue Spinel 1345-16-0 >50%
Cobalt metal, dusts and fumes (as Co)
OSHA PEL: .05 MG/M3
ACGIH TLV: .02 MG/M3
SARA TITLE 313: YES
PHOSPHATE/CHROMATE SOLUTION 92203-02-6 >15%
(Less than 3.% of total weight is CrO3)
ACGIH TLV: 1mg/M3
SARA TITLE 313: YES
NOTE: The National Toxicology program lists chromium and certain chromium compounds to be carcinogenic.
SECTION III
PHYSICAL CHARACTERISTICS____________________________________
BOILING POINT: N/A
VAPOR DENSITY (AIR = 1) : <1
% VOLATILE VOLUME: 59.7%
APPEARANCE AND ODOR: GRAY BLUE WITH NO ODOR
SOLUBILITY IN WATER: APPRECIABLE
VOC'S: 0
SHIPPING: Non Hazardous
SECTION IV
FIRE AND EXPLOSION HAZARD DATA_____________________________
FLASH POINT: NONE
EXTINGUISHING MEDIA: USE SAND OR CARBON DIOXIDE
SPECIAL FIRE FIGHTING PROCEDURES: DO NOT USE EXTINGUISHING AGENTS CONTAINING WATER, AS REACTION WITH ALUMINUM
MAY PRODUCE HYDROGEN GAS.
UNUSUAL FIRE AND EXPLOSION HAZARDS: CONTACT WITH ALKALIS, STRONG REDUCING OR OXIDIZING AGENT MAY PRODUCE
HYDROGEN GAS, CAUSING FIRE OR EXPLOSION HAZARD.
SECTION V
REACTIVITY DATA
STABILITY: STABLE
INCOMPATIBILITY (MATERIALS TO AVOID): CONTACT WITH OXIDIZING AGENTS, ALKALIS OR STRONG REDUCING AGENTS
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
SECTION VI
HEALTH HAZARD DATA__________________________________________________
Page 1
ROUTES OF ENTRY:
INHALATION? YES
SKIN? YES
INGESTION? YES
CARCINOGENICITY:
NTP, OSHA? CHROMIUM AND CERTAIN CHROMIUM COMPOUNDS ARE LISTED
HEALTH HAZARDS:
EYES: CAUSES SEVERE IRRITATION
SKIN: CAUSES MILD SKIN IRRITATION, DRYING OF SKIN
INHALATION: MAY CAUSE DRYING OF NASAL AND RESPIRATORY TISSUE
INGESTION: HARMFUL IF SWALLOWED, CAUSING VOMITING, NAUSEA, DIARRHEA
EMERGENCY AND FIRST AID:
EYES: IMMEDIATELY FLUSH WITH PLENTY OF WATER, CALL A PHYSICIAN
SKIN: WASH WITH WATER. REMOVE CONTAMINATED CLOTHING
INHALATION: REMOVE INDIVIDUAL TO FRESH AIR. ADMINISTER OXYGEN IF
BREATHING IS DIFFICULT. CALL A PHYSICIAN
INGESTION: GIVE LARGE AMOUNTS OF WATER FOLLOWED BY MILK OF MAGNESIA. CALL A PHYSICIAN IMMEDIATELY
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: RESPIRATORY, DERMAL AILMENTS
SECTION VII
SPILL OR LEAK PROCEDURES___________________________________
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: CLEAN SPILL WITH ABSORBENT MATERIAL. NEUTRALIZE WITH
SODIUM BICARBONATE. DO NOT USE STRONG ALKALIS. FLUSH AREA WITH WATER
WASTE DISPOSAL METHOD: MATERIAL MAY BE BAKED AT CURE TEMPERATURE THEN DISCARDED AS SOLID WASTE, OR FILTER TO
REMOVE ALUMINUM AND DISCARD AS SOLID WASTE. TREAT REMAINING LIQUID WITH SODIUM METABISULFITE, THEN PRECIPITATE
TRIVALENT CHROMIUM BY NEUTRALIZING WITH ALKALI, SUCH AS LIME. DISPOSAL SHOULD BE MADE IN ACCORD WITH FEDERAL,
STATE AND LOCAL REGULATIONS.
SECTION VIII
SPECIAL PROTECTION / CONTROL MEASURES:____________________
RESPIRATORY PROTECTION: #9910 RESPIRATOR MANUFACTURED BY 3M OR EQUIVALENT
VENTILATION:
LOCAL EXHAUST: USE TO MAINTAIN BELOW TWA LIMITS
MECHINICAL: USE NON-SPARKING EQUIPMENT
PROTECTIVE GLOVES: RUBBER ACID PROOF
EYE PROTECTION: SAFETY GLASSES WITH SIDE SHIELDS OR GOGGLES
OTHER PROTECTIVE EQUIPMENT: WEAR PROTECTIVE CLOTHING, ACID PROOF
WORK / HYGIENIC PRACTICES: WASH THOROUGHLY AFTER HANDLING PRODUCT AND BEFORE EATING, DRINKING OR SMOKING
SECTION IX
SPECIAL PRECAUTIONS___________________________________________
HANDLING AND STORAGE: STORE IN AREAS THAT WILL NOT COME INCONTACT WITH STRONG ALKALIS OR OXIDIZING AGENTS.
NOTE: Since this compound contains aluminum powder, a clean spray area and duct system are important. It is hazardous to allow an accumulation of
dried material to occur since this dried material in the form of duct could be ignited by sparks or other means and possibly cause a dust explosion as with
any finely divided powdered material.
REGULATORY INFORMATION
U.S. FEDERAL REGULATIONS:
THIS PRODUCT CONTAINS A TOXIC CHEMICAL OR CHEMICALS SUBJECT TO THE REPORTING REQUIREMENTS
OF SECTION 313 OF TITLE III OF THE SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 AND
40 CFR 372. SEE SECTION 2, LIST LEGEND 02.
OSHA STANDARD 29 CFR 1910.1200 REQUIRES THAT INFORMATION BE PROVIDED TO EMPLOYEES
REGARDING THE HAZARDS OF CHEMICALS BY MEANS OF A HAZARD COMMUNICATION PROGRAM
INCLUDING LABELING, MATERIAL SAFETY DATA SHEETS, TRAINING AND ACCESS TO WRITTEN RECORDS.
WE REQUEST THAT YOU, AND IT IS YOUR LEGAL DUTY TO, MAKE ALL INFORMATION IN THIS MATERIAL
SAFETY DATA SHEET AVAILABLE TO YOUR EMPLOYEES.
TO AID OUR CUSTOMERS IN COMPLYING WITH REGULATORY REQUIREMENTS, SARA TITLE III HAZARD
CATEGORIES FOR THIS PRODUCT ARE INDICATED BELOW. IF THE WORD 鈥淵ES鈥? APPEARS NEXT TO ANY
CATEGORY, THIS PRODUCT MAY BE REPORTABLE BY YOU UNDER THE REQUIREMENTS OF 40. CFR. 370.
PLEASE CONSULT THOSE REGULATIONS FOR DETAILS.
CHROMIC ACID
Page 2
TSCA:
ALL CONPONENTS OF THIS PRODUCT THAT ARE REQUIRED TO BE ON THE TSCA INVENTORY ARE LISTED ON
THE INVENTORY.
SARA/TITLE III HAZARD CATEGORIES:
IMMEDIATE (ACUTE) HEALTH: YES REACTIVE HAZARD: NO
DELAYED (CHRONIC) HEALTH: YES SUDDEN RELEASE OF PRESSURE: NO
FIRE HAZARD: YES
HMIS HAZARD RATINGS:
HEALTH HAZARD: 3* FIRE HAZARD: 0 REACTIVITY: 1
WARNING: THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANCER.
INTERNATIONAL REGULATIONS:
CONSULT THE REGULATIONS OF THE IMPROTING COUNTRY.
CANADA:
WHMIS HAZARD CLASS: C, D1A, D2A, E
------------------------------------------------------------------------------------------------------------------
THIS INFORMATION IS FURNISHED WITHOUT WARRANTY, REPRESENTATION, INDUCEMENT OR LICENSE OF ANY KIND, EXCEPT
THAT IT IS ACCURATE TO THE BEST OF TECH LINE COATINGS, INC., KNOWLEDGE OR OBTAINED FROM SOURCES BELIEVED BY
TECH LINE COATINGS, INC. TO BE ACCURATE, AND TECH LINE COATINGS, INC., DOES NOT ASSUME ANY LEGAL RESPONSIBILITY
FOR USE OR RELIANCE UPON SAME. BEFORE USING ANY CHEMICAL, READ ITS LABEL, INSTRUCTIONS AND MATERIAL SAFETY
DATA SHEET.
Page 3
|