SECTION V HEALTH HAZARD DATA
MATERIAL SAFETY DATA SHEET HH 230
Threshold Limited Value Cellulose: 15 mg/m3 TWA (total dust), OSHA; 5 mg/m3 TWA (respirable
ALDON 1533 W.Henrietta Rd. 3
dust), OSHA; 10 mg/m TWA, ACGIH.
HH 230
Avon, New York 14414 MSDS No.
庐
CORPORATION October 2, 1995
Effective Date
(716) 226-6177
Effects of Overexposure INGESTION: None known. SKIN: None known. INHALATION: May
cause irritation of the respiratory tract. May aggravate asthma and
SECTION I NAME 24 HOUR EMERGENCY ASSISTANCE inflammatory or fibrotic pulmonary disease. EYES: May cause irritation
and redness of the conjunctiva.
Product HYDROXYETHYL CELLULOSE
CHEMTREC Health 0
800-424-9300
Chemical
Emergency and
Hydroxyethyl Cellulose
Synonyms INGESTION: If swallowed, if conscious, give two glasses of water to drink.
Fire 0
Day 716-226-6177
First Aid Procedures Induce vomiting and call physician. Never give anything by mouth to an
[(C H O )(C H O) H]
Formula Reactivity 0
695 24 x n
NFPA unconscious person. EYES: Flush thoroughly with water for at least 15
HAZARD RATING HMIS * minutes, lifting upper and lower eyelids occasionally. If irritation persists,
Unit Size up to 180 Kg.
LEAST SLIGHT MODERATE HIGH EXTREME get medical attention. SKIN: Flush thoroughly with water, then wash with
0 1 2 3 4
C.A.S. No. 9004-62-0 mild soap and water. INHALATION: Remove to fresh air. If illness or
discomfort develops, get medical attention.
SECTION II INGREDIENTS OF MIXTURES
SECTION VI REACTIVITY DATA
Principal Component(s) % TLV Units
Conditions to Avoid
Stability Unstable
Hydroxyethyl Cellulose: (CAS No. 9004-62-0) 85.5% min See Section V.
Heat, sparks and flame.
Sodium Acetate: (CAS No. 127-09-3) 7.5% max None established. Stable X
Water: (CAS No. 7732-18-5) 5.0% max None established.
Incompatibility
Cellulose: (CAS No. 9004-34-6) 1.5% max None established.
None known.
(Materials to Avoid)
Glyoxal: (CAS No. 107-22-2) 0.5% max None established.
Hazardous
CAUTION! CAUSES IRRITATION TO EYES AND RESPIRATORY TRACT.
Carbon monoxide and/or carbon dioxide.
Decomposition Products
SECTION III PHYSICAL DATA
Conditions to Avoid
Hazardous Polymerization
Specific Gravity (H2O = 1)
Melting Point (掳F) Not applicable.
Decomposes above 200掳C (392掳F)
May Occur Will Not Occur Not applicable.
Percent Volatile
Boiling Point (掳F) Not applicable. 5.0
by Volume (%) X
Evaporation Rate
SECTION VII SPILL OR LEAK PROCEDURES
Vapor Pressure (mm Hg) Unknown. Not applicable.
=1)
(
Steps to be taken in case
Vapor Density (Air=1) Unknown.
Wear protective safety equipment and use adequate ventilation.
material is released or spilled
Avoid making dust. Sweep up and place in a suitable container
Solubility in Water 99.2 - 100%
for disposal. Material will absorb moisture and become slippery.
Appearance & Odor White powder; mild characteristic odor.
Discharge, treatment, or disposal may be subject to Federal, State or Local laws.
Waste Disposal Method
SECTION IV FIRE AND EXPLOSION HAZARD DATA These disposal guidelines are intended for the disposal of catalog-size quantities only.
Lower
Flammable Limits in Air Upper
Flash Point
Dispose of in an approved chemical landfill in accordance with local, state and
Non-flammable. N/A
% by Volume
(Method Used)
federal regulations.
Small fires: Carbon dioxide or dry chemical.
Extinguisher
SECTION VIII SPECIAL PROTECTION INFORMATION
Media Large fires: Alcohol-type or all-purpose-type foam.
Respiration Protection
Use a NIOSH/MSHA-approved respirator.
(Specify Type)
SPECIAL FIREFIGHTING
Recommended. No.
Local Exhaust Special
PROCEDURES Ventilation Mechanical (General) Other
Recommended. No.
In fire conditions, wear a NIOSH/MSHA-approved self-contained
breathing apparatus and full protective clothing. Do not direct a Protective Gloves Eye Protection
Rubber. Chemical safety goggles.
solid stream of water or foam into burning molten material; this
Other Protective
may cause spattering and spread the fire. Lab coat, apron, eye wash station, proper gloves, ventilation hood.
Equipment
SECTION IX SPECIAL PRECAUTIONS
Precautions to be Taken
UNUSUAL FIRE AND Store in a cool, dry area away from ignition sources. Static ignition hazard
in Handling & Storing
EXPLOSION HAZARDS can result from handling and use. Wash thoroughly after handling.
Avoid dispersion of dust in the air to reduce potential for dust Keep container tightly closed when not in use.
ignition/rapid burning. Dust is easily ignited; avoid ignition
Read label on container before using. Do not wear contact lenses when working with chemicals.
Other Precautions
sources. All metal parts and equipment should be properly
bonded and grounded. In the presence of flammable gases,
Avoid breathing dust. Use with adequate ventilation. Remove
liquids or vapors, handle in inert nitrogen-blanketed equipment.
and wash contaminated clothing.
Autoignition Temperature: 400掳C (752掳F) ASTM For laboratory use only. Not for drug, food or household use. Keep out of reach of children.
Chemical Safety
Approved
Revision Date Michael Raszeja
No. 1 10/2/95 MR
Coordinator
D.O.T. NON-REGULATED. The information contained herein is furnished without warranty of any kind. Employers should use this information only as a supplement to other information
gathered by them and must make independent determinations of suitability and completeness of information from all sources to assure proper use of these
Approved by U.S. Department of Labor "essentially similar" to form OSHA-20 materials and the safety and health of employees. * Hazardous Materials Industrial Standards. Printed on recycled paper.
|