MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name INK UP82
ITW TRANS TECH
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
2-BUTOXYETHANOLACETATE 112-07-2 20 - 25 OSHA PELs: Not established.
ACGIH TLV: Not established.
OSHA/NIOSH IDLH TLV*: 125
mg/m3
1-METHOXY PROPYL ACETATE-2 108-65-6 12 - 13 OSHA PELs: Not established.
ACGIH TLV: Not established.
OSHA/NIOSH IDLH TLV*: 275
mg/m3
CYCLOHEXANONE 108-94-1 5 ACGIH TLV: 25ppm -OSHA TWA-
50ppm (MAK)
1,2,4-TRIMETHYL BENZENE 95-63-6 1.6 OSHA PEL: 25ppm ACGIH TLV:
25ppm OSHA/NIOSH IDLH TLV*:
Not established.
Composition Comments
100% Reaction product - A bisphenol - Epichlorohydrin: epoxy resin
(Average Molecular Weight> 700 CAS EINECS 025036-25-3).
3 HAZARDS IDENTIFICATION
Potential Health Effects, Skin
Irritation of the skin, including redness, dermatitis, allergic eczema.
Potential Health Effects, Inhalation
In high concentrations can be irritating to the mucous membranes. Anesthetic effect.
Potential Health Effects, Ingestion
Harmful if swallowed. May cause nausea, vomiting, diarrhea.
Signs & Symptoms of Short-Term (Acute) Exposure
Dizziness, nausea, irritation of the skin and mucous membranes.
Effects of Long-Term (Chronic) Exposure
(Cyclohexanone): Eye cataracts, liver damage, kidney damage
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
554 INK UP82
Material Id Trade Name 1/ 4
4 FIRST AID MEASURES
Skin
Wash exposed area with soap and water.
Eye
Flush with large amounts of water. Consult a physician.
Inhalation
Remove to fresh air, restore breathing. Consult a physician.
Ingestion
Do not induce vomiting. Dilute any effect by drinking water and get immediate medical attention.
Medical Conditions Aggravated by Exposure
Not Determined
5 FIRE FIGHTING MEASURES
Extinguishing Media
Alcohol resistant foam, co2, powders, water spray.
Basic Fire Fighting Procedures
Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard. Use self-contained
breathing apparatus.
Unusual Fire & Explosion Hazards
Water may be used to cool tightly closed containers to prevent pressure build-up due to extreme heat.
46 潞C Closed Cup
Flash Point
0.8 N.D.
Flammability Limits in Air, Lower, % by Volume
N.D.
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Spill or Leak Procedure
Remove sources of ignition. Ventilate area. Contain and collect spillage with non-combustible absorbent materials, e.g.
sand, earth, vermiculite, diatomaceous earth and place in container for disposal according to local regulations.
7 HANDLING & STORAGE
Handling
Avoid breathing vapors or mist. Do not eat, drink or smoke during handling.
Storage
Do not store above +50C. Keep tightly closed. Store in accordance with NFPA, state and local standards Keep away from
heat, sparks or open flame.
Ventilation
Local exhaust if in confined areas. Remove vapors from floor.
Mechanical (general): Not determined.
Inks are not suited for spray applications.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering Controls
Vapors are heavier than air. Remove vapors from floor.
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
554 INK UP82
Material Id Trade Name 2/ 4
Eye Protection: Personal Protection Equipments (PPE)
Safety goggles.
Skin Protection: Personal Protection Equipments (PPE)
Protective gloves. Personnel should wear protective clothing.
Respiratory Protection: Personal Protection Equipments (PPE)
Wear a NIOSH approved respirator.
General
Wash hands thoroughly before eating, drinking, smoking, or using toilet facilities. Remove and wash contaminated clothing
before reuse.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Colored paste with order of organic solvents
137 - 192 潞C
Boiling Point
1.03 g/cm3 at 20潞C
Specific Gravity
N.D.
Melting Point
24 - 55 %
Percent Volatile
> 0.7 KPa
Vapor Pressure
N.D.
Evaporation Rate
<1
Vapor Density
90 sec. DIN CUP 4 mm
Viscosity
Not Soluble
Solubility In Water
10 STABILITY & REACTIVITY
Stability/Incompatibility
Stable under recommended storage and handling conditions.
Materials to Avoid: Water, Oxidizing agents. Strong acids, alkalies or oxidizers.
Hazardous Reactions/Decomposition Products
When exposed to high temperatures, hazardous decomposition products such as carbon monoxide and dioxide smoke
may occur.
Hazardous Polymerization
Will not occur
Conditions to avoid: None foreseen.
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Skin, eyes, ingestion, inhalation
Carcinogenicity
NATIONAL TOXICOLOGY PROGRAM: No
I.A.R.C. MONOGRAPHS: No
OSHA: No
12 ECOLOGICAL INFORMATION
13 DISPOSAL CONSIDERATIONS
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
554 INK UP82
Material Id Trade Name 3/ 4
14 TRANSPORT INFORMATION
Proper Shipping Name Paint Related Material
Hazard Class 3 UN/NA Code 1210
Packaging Group III
15 REGULATORY INFORMATION
Federal Regulations
To ensure compliance with the Toxic Substances Control Act (TSCA), Sara Title III - Section 313 (40 CFR part 372), and
the California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65).
1-methoxy-2-propylacetate: CAS# 108-65-6, TSCA - Listed, SARA - Not Listed under Section 313, Prop. 65 - Not Listed
2-butoxyethylacetate: CAS# 112-07-2, TSCA - Listed, SARA - Listed under certain Glycol Esters (Sec.313), Prop. 65 - Not
Listed.
Cyclohexanone: CAS# 108-94-1, TSCA - Listed, SARA - Not Listed under Section 313, Prop. 65 - Not Listed.
1,2,4 trimethylbenzene: CAS# 95-63-6, TSCA - Listed, SARA - Listed under Section 313, Prop. 65 - Not Listed. Chemical
components which are listed under SARA Title III, Section 313 are subject to Supplier Notification requirements. Each of
these components must be identified on the MSDS's as chemicals which are regulated under SARA Title III, Section 313.
Chemical components which are listed under the California Safe Drinking Water and Toxic Enforcement Act (Proposition
65) must be identified on the MSDS's according to their individual listing (i.e. causes Cancer or Reproductive Toxicity). This
notification has to be made only for products shipped to California.
International Regulations
The European Standard, EN 71 "Safety of Toys",Part 3: Chemical Properties, Edition 1 of June 1982, provides the
requirements in regard to the content of substances hazardous to health in printing of toys, writing utensils, etc. The
supplier confirms that the product supplied with this MSDS complies with those requirements. The following values in
soluble elements are not exceeded:
100 ppm lead 250 ppm antimony 100 ppm arsenic 500 ppm barium 100 ppm cadmium 250 ppm chromium 100
ppm mercury
Also in conforming with EN 71, the supplier confirms that the sum concentration of the above listed Heavy Metals does not
exceed 100 ppm.
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 3 Flammability 2 Reactivity 1 Personal Prot. Equip. C
16 OTHER INFORMATION
Disclaimer
The information contained herein is based on technical data believed to be reliable. However, since the conditions under
which this information may be applied are beyond our control, we can assume no liability for results of its application. This
information should be used only by a person having sufficient technical skill to make informed judgements regarding its
application.
6/24/2008 1/16/2003
Replaces Sheet Dated
Completed On
`
Completed By
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
554 INK UP82
Material Id Trade Name 4/ 4
|