MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name INK YN
ITW TRANS TECH
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
CYCLOHEXANONE 108-94-1 10 - 25 % ACGIH TLV: 100 mg/m3
BUTYL GLYCOL ACETATE 112-07-2 5 - 10 % N/A
SOLVENT NAPHTHA 64742-95-6 5 - 10 % NA
2-METHOXY-1-METHYLETHYL 108-65-6 5 - 10 % STEL: 550 mg/m3
ACETATE
3 HAZARDS IDENTIFICATION
Potential Health Effects, Skin
Skin contact may lead to degreasing with resultant dry skin, cracking, irritation and dermatitis.
Potential Health Effects, Eye
Eye contact with liquid or vapor causes severe irritation, redness, tearing, blurred vision. Vapors may cause severe eye
irritation, redness, tearing and blurred vision.
Potential Health Effects, Inhalation
Excessive inhalation of vapors can cause nasal, throat and respiratory irritation, dizziness, weakness, fatigue, nausea,
headache and possible unconsciousness. Excessive vapor concentration in air, especially in confined spaces, may cause
asphyxiation.
Potential Health Effects, Ingestion
Swallowing may cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Signs & Symptoms of Short-Term (Acute) Exposure
Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Reports have associated
repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage.
Effects of Long-Term (Chronic) Exposure
Health studies have shown that many solvents pose potential human health risks which may vary from person to person, as
a precaution:
Exposure to liquids and vapors should be minimized.
-Prolonged or continuous inhalation of vapors may result in delayed lung damage.
Repeated or prolonged inhalation of vapor may cause liver and kidney damage.
Repeated inhalation of vapor in high concentration can change the blood picture.
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
607 INK YN
Material Id Trade Name 1/ 4
4 FIRST AID MEASURES
Skin
Wash immediately with soap and water. DO NOT use solvents or thinners.
Eye
Remove contact lenses, keep eyelids open. Flush with large quantities of water for at least 15 minutes. Call a physician.
Inhalation
Remove to fresh air and keep warm. Irregular breathing/no breathing: artificial respiration. Call a physician.
Ingestion
Do not induce vomiting. Call a physician. Keep at rest.
Medical Conditions Aggravated by Exposure
None are known.
5 FIRE FIGHTING MEASURES
Extinguishing Media
Suitable: alcohol resistant foam, CO2, powders, water spray.
Not suitable: water jet
Basic Fire Fighting Procedures
Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard. Appropriate
breathing apparatus may be required.
Unusual Fire & Explosion Hazards
Cool endangered containers with water in case of fire. Do not allow the quenching water into the sewage system.
> 40 潞C
Flash Point
0.6
Flammability Limits in Air, Lower, % by Volume
10
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Environmental Precautions
Do not empty into drains. If the product contaminates lakes, rivers or sewer systems, inform appropriate authorities in
accordance with local regulations.
Spill or Leak Procedure
Remove sources of ignition. Ventilate area. Contain and collect spillage with non-combustible absorbent materials, e.g.,
sand, earth, vermiculite, diatomacious earth and place in container for disposal according to local regulations. Clean
preferably with a detergent. Avoid use of solvents.
7 HANDLING & STORAGE
Handling
Prevent the creation of flammable or explosive concentrations of vapor in air and avoid vapor concentration higher than the
occupational exposure limits. The product should only be used in areas from which all naked lights and other sources of
ignition have been excluded. Comply with the health and safety at work laws. Vapors are heavier than air and may spread
along floors. Vapors may form explosive mixtures with air. Preparation may change electrostatically: always use earthing
leads when transferring from one container to another. Operators should wear antistatic footwear and clothing. No sparking
tools should be used.
Storage
Containers which are opened must be carefully resealed and kept upright to prevent leakage. Keep container tightly closed.
Never use pressure to empty: container is not a pressure vessel. No smoking. Prevent unauthorized access. Keep away
from oxidizing agents, from strongly alkaline and strongly acid materials. Always keep in containers of same material as the
original one. Avoid heating and direct sunlight.
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
607 INK YN
Material Id Trade Name 2/ 4
Ventilation
Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation
and good general extraction. If these are not sufficient in maintaining concentrations of particles and solvent vapor below
the OEL, suitable respiratory protection must be worn.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Personal Protection Equipments (PPE)
Safety glasses or goggles.
Skin Protection: Personal Protection Equipments (PPE)
Protective gloves. After washing hands, replace lost skin fat by fat containing skin creams. Personal should wear anti static
clothings made of natural fiber or of high temperature resistant synthetic fiber. All parts of the body should be washed after
contact.
Respiratory Protection: Personal Protection Equipments (PPE)
If workplace limits are exceeded, a gas mask approved for this particular job must be worn.
General
This product is unlikely to harm health, given normal and proper handling and hygienic precautions. Prolonged inhalation
of vapors in high concentrations may lead to headache, giddiness and nausea. In case of contact with the product: danger
of resorption through the skin, irritation of skin/mucous membranes.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Colored paste with odor of organic solvent
141 - 195
Boiling Point
1.05 - 1.5 H20=1
Specific Gravity
n.a.
Melting Point
25 - 46 %
Percent Volatile
5 app.
Vapor Pressure
n.a. (Butyl Acetate=1)
Evaporation Rate
>1
Vapor Density
no
Solubility In Water
10 STABILITY & REACTIVITY
Stability/Incompatibility
Stable under recommended storage and handling conditions
Incompatability: Materials to Avoid: Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order
to avoid exothermic reactions.
Hazardous Reactions/Decomposition Products
When exposed to high temperatures may produce hazardous decomposition products such as carbon monoxide and
dioxide, smoke, oxides of nitrogen.
Hazardous Polymerization
none.
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Inhalation, ingestion, skin and eye contact.
12 ECOLOGICAL INFORMATION
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
607 INK YN
Material Id Trade Name 3/ 4
13 DISPOSAL CONSIDERATIONS
Waste Disposal
According to state and local regulations.
14 TRANSPORT INFORMATION
Department of Transportation (DOT) Requirements:
General Transportation Information for Bulk Shipments
Proper Shipping Name Paint Related Material
UN/NA Code 1263
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 2 Flammability 2 Reactivity 1 Personal Prot. Equip. C
16 OTHER INFORMATION
Disclaimer
The information contained herein is based on technical data believed to be reliable. However, since the conditions under
which this information may be applied are beyond our control, we can assume no liability for results of its application. This
information should be used only by a person having sufficient technical skill to make informed judgements regarding its
application.
6/24/2008 5/9/2006
Replaces Sheet Dated
Completed On
Completed By
Printed On 24-Jun-08
ND = No Data NA = Not Applicable NI = Not Indicated
607 INK YN
Material Id Trade Name 4/ 4
|